Application Manual for NEMA Motors Section 9 Testing Page Part 1 Routine Test 1 Part 2 Complete Test 3 Part 3 Calibration and Noise Test 4 Application Manual for NEMA Motors Section 9 Part 1 Section Page91 of 4 Part 104/08 Page 1/4 Date 08 / 07 Application Manual for NEMA Motors TESTING All Siemens motors are given a routine line test per NEMA MG1 and IEEE-112. ROUTINE TEST Routine test consists of the following items tested in accordance with IEEE standard 112. • No Load Current • No Load Speed • Locked-Rotor Current • Winding Resistance • High Potential • Bearings/Vibration Check Vibration data is NOT recorded with a routine test. If required, please add per the following table. Test report of routine test is based on IEEE Std. 112 Form A-1 and includes complete nameplate information. Application Manual for NEMA Motors Application Manual for NEMA Motors TESTING Routine Test including Vibration data: Vibration data is NOT recorded with a routine test. If required, please add per the following table. Section 9 Part 1 Section Page92 of 4 Part 104/08 Page 2/4 Date 08 / 07 Application Manual for NEMA Motors Section 9 Part 2 Section Page93 of 4 Part 104/08 Page 3/4 Date 08 / 07 Application Manual for NEMA Motors TESTING COMPLETE TEST Complete test consists of following items tested in accordance with NEMA andIEEE-112 test standards. • Full Load Heat Run • Temperature Rise at F.L. • Winding Resistance • Rated F.L. Slip • No Load Current • Breakdown Torque • Locked Rotor Torque-Amps • High Potential Tests • Efficiencies @ 100, 75, 50 Percent Load • Power Factor @ 100, 75, 50 Percent Load Test report of complete test is based on IEEE Std. Form A-2 and includes complete nameplate information. Application Manual for NEMA Motors Section 9 Part 3 Section Page94 of 4 Part 104/08 Page 4/4 Date 08 / 07 Application Manual for NEMA Motors TESTING CALIBRATION TESTS Calibration test consists of 0-125% rated load test measurement of speed, torque, current, power factor and efficiency, at rated voltage. Data is curve plotted on Siemens standard format. Foot mounted motors only. NOISE TESTS Noise test to verify sound levels can be performed. These tests are conducted per procedures defined in IEEE-85. Tests are performed under no load conditions.