SC1474 Portable Pentium Dual Phase Power Supply Controller ® POWER MANAGEMENT Description Features The SC1474 PowerStep III™ IC is a single chip high-performance Hysteretic PWM controller. With dual integrated Smart™ Drivers, it powers advanced Pentium® 4 processors. The SC1474 features extended Intel Mobile Voltage Positioning (IMVP) to increase battery life by reducing the voltage at the processor when it is heavily loaded. It directly supports Intel’s SpeedStep™ requirements for even longer battery life. The SC1474 automatically detects performance and battery mode VIDs. In addition, it integrates direct “deeper sleep” mode support. All operating modes incorporate automatic “power-save” to prevent negative current flow in the low-side FET during light loading conditions, saving even more power. A 5-bit DAC, accurate to 0.85%, sets the output voltage reference, and implements the 0.600V to 1.750V range required by the processor. The hysteretic converter uses a comparator without an error amplifier, and so provides the fastest possible transient response, while avoiding the stability issues inherent to classical PWM controllers. The SC1474 incorporates a controller for V_VID and automatically provides the proper sequencing. IMVP3 compliant single chip solution High speed Dual phase hysteretic controller VID programmable output Dual integrated 2A/4A drivers Integrated VID regulator controller Automatic performance/battery mode detection Dynamic phase current matching Under-voltage lock out on all Vcc inputs Over-voltage protection on CORE Current Limit protection on CORE Thermal protection Programmable soft-start Powergood flag with blanking during VID changes Automatic powersave at light load TSSOP-38 package Industrial temperature range Applications Advanced Intel microprocessors The SC1474 operates from +3.3Vdc Vcca and dual 5V DC drive inputs. It also features soft-start, an open-drain PWRGD signal with power-good blanking, and an enable input. Programmable current limiting latches the SC1474 off after 32 current limit pulses. It comes in a spacesaving TSSOP-38 package. Typical Application Circuit +V_IN +V_5 Smart Driver Power Control Signals Extended IMVP Logic Lo +VCORE Rcs 0.600V-1.75V Up to 40A Controller SC1474 Dual Phase Extended IMVP CONTROLLER VID [4:0] +V_3 VID Multiplexer Lo Smart Driver Rcs Co VID Regulator Controller +V_VID Revision 6, December 2002 1 www.semtech.com