Variable Gain Amplifiers Part Number Single October 2006 Gain Scaling 1 Frequency Range to –3 dB (MHz) Linearin-dB Linear AD600 DC to 35 32 — 0 to +40 ±0.2 AD602 DC to 35 32 — –10 to +30 ±0.2 DC to 90 40 — –11 to +31 +9 to +51 AD604 DC to 40 20 to 40 — AD605 DC to 40 20 to 40 — Dual Quad Gain Range (dB) Gain Accuracy Preamp (dB) Output Noise Noise Max Gain Figure (dB) (nV/∙∙ Hz) Output P1dB2 (dBm) Output IP32 (dBm) — — — — 46 8.8 3 200 2.7 94 EN nV/∙∙ Hz IN pA/∙∙ Hz No 1.4 — 158 No 1.4 — 50 ±0.5 No 1.3 — ±0.3 Yes 1.8 ±0.2 No 1.8 Z Z 3 IN 3 OUT Supply Voltage (V) Power/ Channel (mW) PowerDown — ±5 110 No — ±5 110 No AD602 is a lower absolute gain version of AD600 2 — ±4.75 to ±6.3 125 No Absolute gain settable via pin strap or external resistor; BW gets reduced for higher gains — 2 — ±5 220 Yes Ultralow noise preamp 350 2 — 5 90 Yes Like AD604 but without preamp Yes Differential input/output SE 𝛀 DIFF 𝛀 SE 𝛀 DIFF 𝛀 — 100 — 2 — 100 — 2 19 15 (40 MHz) 100 — 8.4 15 35 (10 MHz) >1000 8.4 15 33 (10 MHz) 175 Comments Analog Control AD603 AD8330 DC to 150 AD8331 33.3 0 to +48 +6 to +54 –14 to +34 0 to +48 2 0 to +50 –5 to +43 +7 to +55 –5 to +43 +7 to +55 –10 to +38 –2 to +46 –14 to +46 0 to +60 ±0.5 No 5 — 62 — — 27 (10 MHz) — 1000 — 150 2.7 to 6 54 @ VS = 2.7 V ±0.3 Yes 0.8 2.5 170 4.2 — 32 (10 MHz) Prog — — 2 4.5 to 5.5 125 Yes Single-ended input/differential output ±0.3 Yes 0.8 2.5 150 4.2 — 32 (10 MHz) Prog — — — 4.5 to 5.5 145 Yes Single-ended input/differential output ±0.2 Yes 1.3 2.4 80 7 18 31 (10 MHz) — — — 1.2 4.5 to 5.5 95 Yes Single-ended input/differential output; individual gain control per each channel ±0.2 Yes 3.0 3 600 — 11 — — — 2 — ±3 to ±12 150 No Single-ended input/output, power save DC to 120 50 — AD8334 DC to 100 50 — AD8335 DC to 85 20 — AD8336 DC to 100 50 — AD8337 DC to 280 19.7 — 0 to +24 ±0.25 Yes 2.2 4.8 34 14 — 28 (45 MHz) — — — — 4.5 to 10 78 No Single-ended input/output AD8367 DC to 500 45 — –2.5 to +42.5 ±0.2 No 1.9 — — 6.2 8 27.5 (70 MHz) 200 — 50 — 2.7 to 5.5 110 Yes Square law detector included for AGC applications; VGA or AGC mode AD8368 LF to 1000 34 — –12 to +22 ±0.4 No 1.3 — –143 dBm/Hz 9 16 33.7 (70 MHz) 50 — 50 — 4.5 to 5.5 60 mA Yes Single-ended input/output, VGA/AGC operation 22 — –34 to +22 ±1.5 Yes 1.3 — –150 dBm/Hz 7.8 22 31 (900 MHz) 25 50 25 50 4.75 to 6 1200 Yes RF/IF voltage controlled amplifier/attenuator 135 mA Yes AD8332 ADL5330 ADL5390 ADL5391 1 MHz to 3 GHz 20 MHz to 2.4 GHz DC to 2.0 GHz — 3.5 5 to –27 ±0.25 No 4.7 — –149 dBm/Hz 21 11 24 (380 MHz) 250 500 25 50 4.75 to 5.25 Vector modulator used as a VGA; can also change phase Multiplier used as a VGA with dc operation and very fast analog control — 1 0 to –42 ±1 No 4.7 — –133 dBm/Hz 40 15 26 (50 MHz) 250 500 38 75 4.5 to 5.5 135 mA Yes 45 — –5 to +40 ±0.5 No 2 — — 7 3 19.5 (70 MHz) — 200 — 200 3.0 to 5.5 170 Yes 4-bit interface 3 dB step — 28 –11 to +17 +6 to +34 ±0.5 Yes 2.1 — — 7.4 16 31 (70 MHz) — 200 — 100 2.7 to 5.5 410 Yes 7-bit interface Digital Control AD8369 AD8370 0.001 to 600 0.001 to 700 Digitally Controlled Line Drivers AD8320 150 — 0.077 –10 to +26 ±0.2 Yes 5.3 — 73 — 22.5 34 220 — 754 — 5 to 12 400 to 1160 Yes High output power line driver; 36 dB gain range AD8321 120 0.7526 — –27.4 to +26 ±0.2 Yes 20 — 60 15 19.5 23 820 900 754 — 5 to 9 810 Yes 54 dB gain range AD8322 180 6 dB/m.c.5 0.233245 ±0.2 Yes 12.5 — 63 11.8 19 — 210 235 — 754 5 565 Yes 5 V line driver coarse step AD8324 100 1 — ±1.0 Yes 1.3 — 157 15.5 21 — 550 1100 754 3.3 207 Yes 3 V low cost line driver AD8325 100 0.75 — –29.5 to +30 ±0.2 Yes 10 — 56 13.8 18.5 — 800 1600 — 75 5 665 Yes 5 V line driver fine step; output power control AD8326 100 0.75 — –26 to +27.5 ±0.2 Yes 13.3 — 100 16.6 26.5 — 800 1600 — 754 ±5, 12 1500, 1885 Yes Highest output power of all AD832x line drivers AD8327 160 6 dB/m.c. — –18 to +30 ±0.25 Yes 11 — 63 13.2 14.8 — 800 1600 754 — 5 525 Yes Coarse step line driver AD8328 107 1 — –27.5 to +31.5 ±1.0 Yes 1.2 — 135 16.7 18.4 — 800 1600 — 754 5 120 Yes Low cost line driver –12.6 to +29.5 –25.5 to +33.5 4 Gain scaling—analog control: dB/V and V/V; digital control: dB/LSB and V/V/LSB. 1 For all AD832x parts, the reference impedance for powers in dBm is 75 Ω; for all other parts it is 50 Ω. 2 SE: single-ended; DIFF: differential. 3 75 Ω ZOUT also during power-down. All specifications for 75 Ω load resistance; however, the parts can be used with other load impedances. 4 AD8322 gain scaling is 6 dB/m.c. where m.c. stands for major carry, and is 0.2332 V/V/LSB between major carries. 5 For more information on ADI Variable Gain Amplifiers, visit www.analog.com/vga.