Analog Devices Welcomes Hittite Microwave Corporation NO CONTENT ON THE ATTACHED DOCUMENT HAS CHANGED www.analog.com www.hittite.com THIS PAGE INTENTIONALLY LEFT BLANK HMC-C011 v05.0310 GaAs MMIC SPDT NON-REFLECTIVE SWITCH, DC - 20 GHz Features High Isolation: >45 dB up to 5 GHz >35 dB up to 20 GHz Low Insertion Loss: 2 dB @ 12 GHz 2.5 dB @ 16 GHz Fast Switching Typical Applications Non-Reflective Design The HMC-C011 is ideal for: Hermetically Sealed Module • Basestation Infrastructure Field Replaceable SMA connectors • Fiber Optics & Broadband Telecom -55 °C to +85 °C Operating Temperature • Microwave Radio & VSAT • Military Radios, Radar, & ECM The HMC-C011 is a general purpose broadband high isolation non-reflective GaAs MESFET SPDT switch housed in a miniature hermetic module with field replaceable SMA connectors. Covering DC to 20 GHz, the switch offers high isolation and low insertion loss. The switch features >45 dB isolation up to 5 GHz and >35 dB isolation up to 20 GHz. CMOS interface allows a single positive +5V bias voltage at very low DC currents. Functional Diagram SWITCHES 8 General Description • Test Instrumentation Electrical Specifi cations, TA = +25° C, With Vdc = +5V & 0/+5V Control, 50 Ohm System Parameter 8-4 Frequency Insertion Loss DC - 4.0 GHz DC - 12.0 GHz DC - 16.0 GHz DC - 20.0 GHz Isolation DC - 4.0 GHz DC - 8.0 GHz DC - 20.0 GHz Min. 41 35 25 Typ. Max. Units 1.8 2.0 2.5 4.0 2.3 2.5 3.5 4.9 dB dB dB dB 46 40 35 dB dB dB Return Loss “On State” DC - 12.0 GHz DC - 20.0 GHz 15 10 dB dB Return Loss RF1, RF2 “Off State” DC - 10.0 GHz DC - 15.0 GHz DC - 20.0 GHz 20 15 10 dB dB dB Input Power for 1 dB Compression 0.5 - 20.0 GHz 23 dBm Input Third Order Intercept (Two-Tone Input Power= +7 dBm Each Tone) 0.5 - 10.0 GHz 0.5 - 20.0 GHz 20 48 45 dBm dBm Switching Characteristics tRISE, tFALL (10/90% RF) tON, tOFF (50% CTL to 10/90% RF) DC - 20 GHz 1.3 5.0 ns ns Switching Transients DC - 20 GHz 20 mVpp For price, delivery, and to place orders, please contact Hittite Microwave Corporation: 20 Alpha Road Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373 Order Online at www.hittite.com HMC-C011 v05.0310 GaAs MMIC SPDT NON-REFLECTIVE SWITCH, DC - 20 GHz Return Loss 0 0 -2 -5 RETURN LOSS (dB) -4 +25 C +85 C -55 C -6 -8 RFC RF1,RF2 ON RF1,RF2 OFF -10 -15 -20 -10 -25 0 2 4 6 8 10 12 14 16 18 20 22 0 2 4 6 FREQUENCY (GHz) Isolations 10 12 14 16 18 20 22 8 Isolation Between Ports RF1 and RF2 0 0 RF1 RF2 RF2 PATH ON RF1 PATH ON -20 ISOLATION (dB) -20 ISOLATION (dB) 8 FREQUENCY (GHz) -40 -60 SWITCHES INSERTION LOSS (dB) Insertion Loss -40 -60 -80 -80 0 2 4 6 8 10 12 14 16 18 20 22 0 2 4 6 FREQUENCY (GHz) 8 10 12 14 16 18 20 22 20 22 FREQUENCY (GHz) Input P1dB & P0.1dB Compression Point Input Third Order Intercept Point 30 55 45 IP3 (dBm) P1dB & P0.1dB (dBm) 50 25 20 40 +25 C +85 C -55 C 35 P1dB P0.1dB 15 30 10 25 0 2 4 6 8 10 12 14 FREQUENCY (GHz) 16 18 20 22 0 2 4 6 8 10 12 14 16 18 FREQUENCY (GHz) For price, delivery, and to place orders, please contact Hittite Microwave Corporation: 20 Alpha Road Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373 Order Online at www.hittite.com 8-5 HMC-C011 v05.0310 GaAs MMIC SPDT NON-REFLECTIVE SWITCH, DC - 20 GHz Control Voltages Absolute Maximum Ratings RF Input Power +27 dBm State Bias Condition Supply Voltage (Vdc) +7 Vdc High +3.5 to Vdc @ 1 mA Typ. Control Voltage Range (Vctl) -0.5V to Vdd +0.5V Low 0 to +1.5V @ 20 μA Typ. Hot Switch Power Level +23 dBm Storage Temperature -65 to +150 °C Operating Temperature -55 to +85 °C Truth Table Control Input ELECTROSTATIC SENSITIVE DEVICE OBSERVE HANDLING PRECAUTIONS Signal Path State Vctl RFC to RF1 RFC to RF2 High On Off Low Off On Bias Voltage & Current 8 SWITCHES Vdc Range = +5 Vdc ± 10% Vdc (Vdc) Idc (Typ.) (mA) +5.0 1.4 (Bias current increases with switching rate to 15 - 20 mA.) Pin Descriptions 8-6 Pin Number Function Description 1, 2, 3 RFC, RF1, RF2 RF connector, SMA female, field replaceable. These pins are DC coupled and matched to 50 Ohms. DC blocking capacitors are required if external RF line potential is not equal to 0V. 4 GND Power supply ground. 5 Vctl CMOS interface, control voltages per table. Requires active pullup to +5V (Vdc). 6 Vdc Supply voltage Interface Schematic For price, delivery, and to place orders, please contact Hittite Microwave Corporation: 20 Alpha Road Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373 Order Online at www.hittite.com HMC-C011 v05.0310 GaAs MMIC SPDT NON-REFLECTIVE SWITCH, DC - 20 GHz Outline Drawing SWITCHES 8 Package Information Package Type C-5 Package Weight [1] 17.7 gms [2] Spacer Weight 2.6 gms [2] [1] Includes the connectors NOTES: 1. PACKAGE, LEADS, COVER MATERIAL: KOVAR™ 2. FINISH: GOLD PLATE OVER NICKEL PLATE 3. MOUNTING SPACER: NICKEL PLATED ALUMINUM 4. ALL DIMENSIONS ARE IN INCHES [MILLIMETERS] 5. TOLERANCES: 5.1 .XX = ±0.02 5.2 .XXX = ±0.010 [2] ±1 gms Tolerance 6. FIELD REPLACEABLE SMA CONNECTORS TENSOLITE 5602 - 5CCSF OR EQUIVALENT 7. TO MOUNT MODULE TO SYSTEM PLATFORM REPLACE 0 -80 HARDWARE WITH DESIRED MOUNTING SCREWS For price, delivery, and to place orders, please contact Hittite Microwave Corporation: 20 Alpha Road Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373 Order Online at www.hittite.com 8-7