SINGLE BOARD COMPUTER FOR SPACE • • • • • Proven in Space Best Single Event Performance Seamless Error Correction Wide Range of Processing Power Highest Design Margin SCS750® FLIGHT MODULE Overview of Specifications • • • • • Proven in space – TRL-9 Wide range of operating capability: • 200 – 1800 MIPS • 7 – 30 watts typical Speed and power settings can be managed via software in real time; no reboot required. Outstanding SBC radiation hardness • TID greater than 100 krad (Si) • SEU hard • SEL immune Standard development platform – VxWorks® The SCS750® Single Board Computer is Maxwell’s answer to the space industry’s need for both mid- and high-performance computing, and on-board data processing requiring the upmost in reliability and upset immunity. There is a trend to perform data management and manipulation on the spacecraft, which requires a large amount of processing power. The SCS750® SBC enables satellite designs to dramatically increase errorfree, on-board data processing, mission planning, and critical decision-making. The SCS750® SBC has been designed to operate in a cPCI system targeting high performance computing for the most demanding space applications. Its design decisions have been driven by a guarantee of the highest reliability and performance. Maxwell has developed a comprehensive strategy to provide total dose, latch-up, and upset hardness for the SCS750® SBC. Maxwell’s SCS750® Single Board Computer has become the benchmark against which all space processor boards are measured. Page 1 | Document #: 1004741 | Rev. 8 Rad Hard Architecture Block Diagram Reed Solomon And ECC Protected Actel RT-AXS SEU Tolerant FPGA PowerPC 750FXTM PowerPC 750FXTM SDRAM Interface Reed Solomon Double Device Data Correction Memory Controller, PCI, Timers, Interrupts, DMA, UART, Wachdog Timer, Mission Timer TMR Logic PowerPC 750FXTM SDRAM 256 Mbytes 0.5MB Primary SuROM EEPROM Interface SEC/DED EDAC 0.5MB Secondary SuROM 7.0MB User SuROM Upset Mitigation by Architectural Design PCI-IF MIL-STD-1553 BC/ RT/MT GPIO (32), USRT (SCC x2) System Timers, 1553 Interface Rad-Hard/Rad Tolerant SEU Tolerant Component Auto Controller/Peripheral Configuration Processor & SDRAM Error Logging Actel RT-AXS SEU Tolerant FPGA SEU Immune Design-in Hardness Actel RT-AXS SEU Tolerant FPGA • • PCI - PCI Bridge Local PCI Bus DC/DC Converter • • SupV Circuit Front Panel Test Connector Front Panel Flight Connector Single Event Upset Mitigation Commercial Technology Mitigation Technique Latest SOI PowerPC at 800MHz TMR/Resynch and Scrubbing High Performance SDRAM Double Device Correct and HW Scrub (Reed-Solomon) On-Board Control Logic Actel RT-AX Built-in TMR 1 Upset Per Day Unacceptable Page 2 | Document #: 1004741 | Rev. 8 Result SCS750 1 Uncorrected Error > 80 Years Better Upset Immunity Than Other Space SBC’s! 32 Bit, 33 MHz, cPCI TRP Protected Triple Redundant Processing Triple Redundant Processing Resynchronization & Scrubbing Software will reset, reload, and resynchronize all three processors to clear errors in 1 ms. SEU Hard TMR Voting Error Detection Output of each clock cycle is voted and majority is output without delay Hardware isolates a disagreeing processor and holds it in reset Triple Modular Redundancy Protection TMR Processor SEU Flush EDAC Memory PowerPC PowerPC TMR Processor Restore TMR Logic PowerPC PowerPC • • • TMR Logic PowerPC Detects upset Flushes μProcessors memory into main memory Tri-states upset μProcessor • • Restores memory back into μProcessors Resynchronizes all three μProcessors into lockstep Flushes and Restores in 1ms! Page 3 | Document #: 1004741 | Rev. 8 EDAC Memory PowerPC Performance Chart Software Selectable Power Consumption Estimated MIPS vs. Code/Data Size 2000 1750 SCS750 at 800MHz with 512KByte L2 Cache 1500 MIPS 1250 9X 8x 1000 1000X 750 500 250 RH PowerPC at 133MHz without L2 Cache 0 50 100 150 200 Code Size (KB) Page 4 | Document #: 1004741 | Rev. 8 250 300 350 Technical Specification RADIATION TOLERANCE • • • One board upset every 80 years in GEO orbit and 115 years in LEO orbit TID: > 100 krad (Si) - orbit dependent SEL (th):84 MeV-cm2/mg (room temperature) PROCESSORS (3) FULLY TMR PROTECTED PROCESSORS • PowerPC 750FXTM on silicon on insulator (SOI), 0.13um • 2.32 Dhrystone MIPS/MHz • > 1800 Dhrystone MIPS @ 800MHz • 400 to 800MHz - Software selectable core clock rate L1 CACHE • 32 KByte Instruction with parity • 32 KByte Data with parity L2 CACHE • 512 KByte on-chip with ECC @ CPU core clock rate MEMORY VOLATILE • 256 MByte SDRAM - Reed-Solomon protected - Double Device Data Correction NON-VOLATILE • 8 MByte EEPROM - ECC protected - 7.0 MByte EEPROM available to user - 0.5 MByte Primary SuROM - 0.5 MByte Secondary SuROM (autoswap on primary failure) INTERFACES cPCI BUS •6U •3.3V • 32 bit, 33MHz • Master/Target & Syscon/Peripheral 1553 •BC/RT/MT • SEU Immune SERIAL • UART ( Asynchronous ), LVDS • (2) USRTs ( Synchronous ), LVDS TEMPERATURE • -30°C to +65°C ( Acceptable levels ) • -40°C to +70°C ( Qualification levels ) MECHANICAL • 6u x 160mm • 1.5 Kg (3.3 Lbs.) Max MODELS SCS750F - FLIGHT CONFIGURATION • Rad-Tolerant, Class “S” or equivalent components • Conduction cooled • Flight cPCI connectors SCS750E - ENGINEERING CONFIGURATION (EM) • Parts identical to flight (but not screened to flight level) • Conduction cooled • Flight cPCI connectors SCS750D - ENGINEERING DESIGN CONFIGURATION (EDM) • Commercial components • Full hardware & software compatibility w/ E & F models • Conduction or convection cooled SCS750P - PROTOTYPE CONFIGURATION (PEM) • Commercial components • Similar functionality to D, E & F models • Convection cooled All models are available with an optional 1553 interface Deliverables • • • • • Board support package Management documents Product assurance documents Engineering and verfication documents Manufacturing and test documents PROGRAMMABLE I/O • 32 Programmable General Purpose I/O (GPIO) POWER • 7 - 30 watts ( typical ) dependent on clock rate/MIPS requirements • 5V for 1553 interface, 3.3V for rest of board OPERATING SYSTEM • VxWorks, Tornado Worldwide Headquarters Maxwell Technologies, Inc 3888 Calle Fortunada • San Diego, CA 92123 • USA PHONE: +1 (858) 503 3300 FAX: +1 (858) 503 3301 EMAIL: [email protected] Page 5 | Document #: 1004741 | Rev. 8 All specifications are subject to change.