OPTO ■ PHOTOINTERRUPTERS FOR SPECIFIC APPLICATIONS Photointerrupters for Specific Applications ♦Transmissive Type <For amusement use> Model No. Internal connection diagram Voltage regulator GP1A204HCS0▲ (Ta = 0 to +40°C) Features Connector with lock, screw mounting type, high resistant to noise Detecting and emitting gap (mm) Slit width (mm) 4.0 0.5 Electro-optical characteristics Operating voltage Low level output voltage VCC (V) IOL VCC VOL (V) Light MIN. MAX. MAX. cut-off (mA) (V) 10.8 24 0.4 Yes 5 10.8 to 24 Amplifier The model marked with ▲ may not be available in the near future. Contact with SHARP for details before use. Optoelectronics GP1A204HCS0 Notice In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in catalogs, data books, etc. Except where specially indicated, models listed on this page comply with the RoHS Directive*. For details, please contact SHARP. *RoHS Directive: Prohibits use of lead, cadmium, hexavalent chromium, mercury and specific brominated flame retardants (PBBs and PBDEs), with certain exceptions. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device. 51