Emerson® CybexTM SC KM 140/KM 145 4-Port KM Switches Quick Installation Guide HELPFUL RESOURCES Emerson® CybexTM SC KM 145 Switch Shown Product documentation downloads are available at: 4 www.avocent.com/manuals Search for additional product information at: www.avocent.com For further assistance, contact Avocent Technical Support. The following instructions will help you install your Emerson® CybexTM SC KM 140/ 1 3 KM 145 switch. WARNING: This product is equipped with 2 active intrusion protection. Tampering may permanently disable the switch and void the warranty. If the enclosure appears to have been tampered with or if all the port LEDs flash continuously, please contact Technical Support. This product also has tamper evident seals. Broken or removed seals will void the warranty. 1 Connecting local peripherals NOTE: The cables must be connected directly to an open USB port on your computer with no USB hubs or other devices in between. 3 Turning on your system NOTE: Make sure that the CAC switch is disabled (switched left) for all other nonconnected CAC systems. Once configured, the CAC connection will Turn the monitor on. Plug the power be switched only when required by the supply cord into the switch. Plug the other connected computer. When switching Turn off all computers you plan to use with end of the power supply cord into an AC from a CAC enabled port to a non-CAC your SC KM 140/KM 145 switching system. wall outlet.The display diagnostic LED enabled port, the CAC connection will Plug the cable into the appropriate should be solid green a few seconds after remain with the last previously selected CONSOLE port on the back of the switch. power is applied. port where CAC was enabled. Plug the USB or PS/2 keyboard and mouse cables, audio (speaker/headset) cable and Common Access Card (CAC) device into the appropriate ports. 2 Connecting computers to the switch 4 CAC device configuration and 5 Turning on the computers operation Turn on all the attached computers Using a USB cable, connect one end of the and check for display and peripheral cable to the computer that requires CAC, functionality. and the other end to the CAC port on the 6 Switching your computers Make sure all computers are turned off. switch that corresponds to the computer. When you turn on your computers, the Plug the speaker, keyboard and mouse Enable CAC for the port connection by computer connected to the front panel will cables from the corresponding computer switching the CAC switch to the right. be displayed. Press the corresponding front into one of the ports on the switch. Repeat Repeat the previous CAC steps for panel button (1 through 4) on the switch to for all computers. additional computers that require CAC. access the computers on your SC switching 1 To Contact Avocent Technical Support: Visit www.avocent.com 590-1230-501A Emerson, Emerson Network Power and the Emerson Network Power logo are trademarks or service marks of Emerson Electric Co. Avocent, the Avocent logo and Cybex are trademarks or service marks of Avocent Corporation. All other marks are the property of their respective owners. This document may contain confidential and/or proprietary information of Avocent Corporation, and its receipt or possession does not convey any right to reproduce, disclose its contents, or to manufacture or sell anything that it may describe. Reproduction, disclosure, or use without specific authorization from Avocent Corporation is strictly prohibited. ©2015 Avocent Corporation. All rights reserved. Emerson® CybexTM SC KM 140/KM 145 4-Port KM Switches Quick Installation Guide system. The front panel button of the selected computer will illuminate. Storage temperature is -4° to 140° F (-20° to 60° C). Supported Hardware The SC KM switches support most standard speakers, headsets, USB PS/2 keyboards and mice. Humidity requirements are 0-80% RH, noncondensing. Environmental Operating temperature is 32° to 104° F (0° to 40° C). Mechanical Approximate Dimensions H x W x D = 342 (W) x125 (D) x 28 (H) mm H x W x D =13.5 (W) x 5 (D) x 1.1 (H) inches Cables Users can choose from 6 ft. or 10 ft. cables and select whether or not to use CAC functionality. Contact an Emerson representative for ordering details. Weight: 1.4 kg / 3 lbs 2 To Contact Avocent Technical Support: Visit www.avocent.com 590-1230-501A Emerson, Emerson Network Power and the Emerson Network Power logo are trademarks or service marks of Emerson Electric Co. Avocent, the Avocent logo and Cybex are trademarks or service marks of Avocent Corporation. All other marks are the property of their respective owners. This document may contain confidential and/or proprietary information of Avocent Corporation, and its receipt or possession does not convey any right to reproduce, disclose its contents, or to manufacture or sell anything that it may describe. Reproduction, disclosure, or use without specific authorization from Avocent Corporation is strictly prohibited. ©2015 Avocent Corporation. All rights reserved.