ACSW-5578 High Power Switch Single Pole, Two Throw, High Power Data Sheet Revision Date: 12/16/2015 The most important thing we build is trust DESCRIPTION: The Cobham Signal & Control Solutions series of High Power T/R diode switches span the frequency range of 5MHz to 6GHz and are available with absorptive output on the RX port and reflective port on the TX side. The switches are available in a wide variety of standard frequency ranges. Each switch incorporates a TTL-compatible driver for convenient system integration and operates from +5V to +12v and -50V to -150V DC power supplies (depending on RF power requirements). All switches incorporate DC blocks at the RF ports. Some switches are also available with hermetic seal and high-rel screening for military and aerospace applications. SPECIFICATIONS: Parameters Spec Unit of Measure 2500 – 6000 MHz Insertion Loss (max) 1.25 dB J1 – J2 (RX Mode TTL Low) .8 dB J3 – J1 (TX Mode TTL High) VSWR (max) 1.5:1 ratio J2 – J1 (RX Mode TTL Low) 1.5:1 ratio J3 – J1 (TX Mode TTL High) 60 dB J3 – J2 (TX Mode TTL High) 20 dB J3 – J1 (RX Mode TTL Low) Switching Speed (max) 6 µsec (50% TTL-90/10%RF) RF Power Input 80 W (J3 – J1), Cold Switching Frequency Range Isolation (min) OUTLINE DRAWING: Revised Date: 12/16/2015 Notes FEATURES: • TTL-compatible drivers for convenient system integration • Operates on +5V or +15V and -50V to -200V DC power supplies • Up to 200W CW power handling on some configurations • High peak power configurations available • DC blocks at all RF ports • Ruggedized construction • All parts receive internal visual (per MIL-STD-883) and temp cycle (-40 °C to 100 °C, 10 cycles) • Hi-Rel screening available upon request (732) 460-0212 www.cobham.com/CSCS 1 ACSW 5578 High Power Switch Single Pole, Two Throw, High Power NOTES: ENVIRONMENTAL SPECIFICATIONS*: DC Bias: (Standard) +5 V @ 300 mA max -125 V @ 10 mA max MIL-E-5400, MIL-STD-202 MIL-E-16400 Control: TTL 0 = RX Insertion Loss (J1 – J2) TTL 1 = TX Insertion Loss (J3 – J1) Operating Temp: -40 °C to +95 °C Storage Temp: -46 °C to +85 °C RF Connectors: SMA Female Humidity: MIL-STD-202F, M103, Cond B DC and Control: 9-Pin D Sub Connector Shock: MIL-STD-202F, M213, Cond B Altitude: MIL-STD-202F, M105, Cond B Vibration: MIL-STD-202F, M204, Cond B Thermal Shock: MIL-STD-202F, M107, Cond A Finish: E1=1: J3 – J1 Low Loss, J2 – J1 Isolation Absorptive Switch: 50 ohm termination present at J2 and J3 (in isolation mode). * Compliant by design, verification optional Switching speed is defined as 50% TTL to 90% RF (t-on) and 50%. TTL to 10% RF (t-off). Finish: Chem film ISO 9001:2008 and AS9100 certified For further information please contact: Aeroflex Control Components, DBA Cobham Signal & Control Solutions (CSCS) reserves the right to make changes to any products and services herein at any time without notice. Consult CSCS or an authorized sales representative to verify that the information in this data sheet is current before using this product. CSCS does not assume any responsibility or liability arising out of the application or use of any product or service described herein, except as expressly agreed to in writing by CSCS; nor does the purchase, lease, or use of a product or service from CSCS convey a license under any patent rights, copyrights, trademark rights, or any other of the intellectual rights of CSCS or of third parties. Cobham Signal & Control Solutions 40 Industrial Way East Eatontown , NJ 07724 [USA] Phone: (732) 460-0212 Fax: (732) 460-0214 [email protected] Copyright 2015, Cobham Signal & Control Solutions. All rights reserved. Revised Date: 12/16/2015 (732) 460-0212 www.cobham.com/CSCS 2