NCP3064PDBSTGEVB_TEST_PROCEDURE.PDF

Test Procedure for the NCP3064 Boost PDIP package
6/5/2008
Test Procedure:
1. Strap the Enable pins in the ON position.
2. Connect the test setup as shown in Figure 1.
3. Apply an input voltage, Vcc = 12V ,
4. Apply Iout = 0mA load.
5. Check that Vout is 24V (23.75V – 24.25V)
6. Increase Iout load to 0.3A.
7. Check that Vout is 24V (23.75V – 24.25V)
8. Power down the load.
9. Power down Vcc.
10. End of test.
04/24/2012
1
www.onsemi.com

Open as PDF

Similar pages: NCP3064DFBSTGEVB_TEST_PROCEDURE.PDF - 1199.0 KB; NCP3064DFBCKGEVB_TEST_PROCEDURE.PDF - 152.0 KB; NCP3064DFBCKGEVB_BOM_ROHS.PDF - 39.0 KB; NCP3064PDBCKGEVB_TEST_PROCEDURE.PDF - 301.0 KB; NCP3064PDBCKGEVB_BOM_ROHS.PDF - 39.0 KB; NCP3064PDBSTGEVB_BOM_ROHS.PDF - 573.0 KB; NCP3064DFBSTGEVB_BOM_ROHS.PDF - 40.0 KB; ONSEMI NCV3064PG; NCP3064 D; NCP3064PDBCKGEVB_SCHEMATIC.PDF - 130.0 KB; NCP57152DSADGEVB_TEST_PROCEDURE.PDF - 48.0 KB; NCP57302DSADGEVB_TEST_PROCEDURE.PDF - 52.0 KB; NCP58302DSADGEVB_TEST_PROCEDURE.PDF - 52.0 KB; NCP59152DSADGEVB_TEST_PROCEDURE.PDF - 51.0 KB

NCP3064PDBSTGEVB_TEST_PROCEDURE.PDF - 612.0 KB