NCP59744MN2ADJGEVB_TEST_PROCEDURE - 53 KB

Test Procedure for the NCP59744MN2ADJGEVB Evaluation Board
V
V
A
REGULATED
DC SUPPLY
VBIAS
A
ELECTRONIC
LOAD
REGULATED
DC SUPPLY
VIN
VOUT
V
V
A
VPG
Figure 1: Test Setup
Test Procedure
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Connect the test setup as shown in Figure 1.
Apply supply voltage Vin = 1.5 V
Apply supply voltage Vbias = 5.0 V
Apply Iout = 10 mA load.
Check that Vout is 1.2 V
Increase Iout load current to 3.0 A
Check that Vout is 1.2 V
Decrease Iout load current to 10 mA
Check that voltage on PG output VPG is 5 V
Decrease Vin voltage to 0.9 V
Check that voltage on PG output VPG < 0.1 V
Power down the load
Power down Vin and Vbias supply
End of test
7/22/2014
1
www.onsemi.com