Bill of Materials for the STK682-010GEVB Evaluation Board Designator Quantity Description Value Tolerance Footprint Manufacturer C1 C2 C3 C4 C5 R1 R2 R3 to R4 R5 1 1 1 1 1 1 1 2 1 For setting of chpping freg. VM Bypass Capacitor VCC Bypass Capacitor For Vref For 5V power supply Resistor to Set Vref Resistor to Set Vref Pull-up Resistor Pull-up Resistor Various SUN SUN Various Various AKAHANE ELECTRONICS 1 ±5% ±20% ±20% ±5% ±5% ±1% ±5% ±5% ±1% ±1% ±5% ±1% ±1% - Through-hole Through-hole Through-hole Through-hole Through-hole Through-hole Through-hole Through-hole Through-hole - R6 100pF 100μF/50V 10μF/50V 0.082μF 0.082μF 470Ω 1.0 kΩVR 10kΩ 10kΩ No use(used JP04) 10kΩ 6.8Ω 10kΩ 0.22Ω 0.22Ω - R7 to R10 RFA RFB HIC JP1-6 TP1 to TP11 4 1 1 1 3 11 FDT terminal voltage setting SLOW DECAY MIXFD DECAY FAST DECAY Pull-up Resistor Current Resistor Hybrid IC, 19pin Jumper Test Point AKAHANE ELECTRONICS AKAHANE ELECTRONICS AKAHANE ELECTRONICS Through-hole Through-hole Through-hole - AKAHANE ELECTRONICS PANASONIC PANASONIC ON Semiconductor Mac-Eight Mac-Eight Manufacturer Part Number Substitution Allowed Lead Free Various 50ME100CA 50ME10CA Various Various RN14S471JK RN14S****FK RN14S****FK RN14S****FK RN14S****FK RN14S****JK ERX2SJR22 ERX2SJR22 STK682-010-E JR-4 ST-1-3 YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES NO YES YES YES YES YES YES YES YES Note: R3 is used for Vref current setting. Therefore their value is not mentioned on this table. 1/2/2014 Page 1 of 1 www.onsemi.com