A/D and D/A CONVERSION/SAMPLING CIRCUITS VIDEO CIRCUITS Application Note 1943: Mar 21, 2003 Improving the Performance of the MAX4455 by Reducing On-Screen Display Artifacts This article describes an applications circuit for the MAX4455 Arbitrary Graphics OnScreen Display Video Generator to reduce the effects of finite switching time on the insertion of graphics onto a video signal. This application note describes a circuit modification to the MAX4455 EV board that will improve the performance of the MAX4455/MAX4358 chip set by reducing on-screen display (OSD) artifacts caused by finite switch time effects. This modification can be included in any similar MAX4455/MAX4358 application circuit yielding the same performance improvements. The MAX4455 is an 8-channel arbitrary graphics OSD generator and the MAX4358 is a 32x16 crosspoint switch with integrated fast MUX for OSD insertion. Explanation of Finite Switch Time Effect In the MAX4455 there are two outputs involved in the generation of the OSD graphics: the first output, the OSDFILL, is the analog representation of the video fill signal, and the second output, the OSDKEY, is a digital signal that controls the turn on and turn off of the fast MUX switch. They are synchronized to within a nanosecond or so at the output of the MAX4455. Due to the finite switching time of the fast MUX in the MAX4358, the OSDFILL signal emerges slightly delayed from the OSDKEY signal. This results in a slightly delayed OSDFILL graphic with a trailing black level (0 IRE) equal in width to the switch delay time (as shown in Figure 1). This effect may be objectionable in applications that display all white characters, due to the high contrast between the white character and the trailing black edge. This is even more obvious on a light background due to the light dark light pattern. www.maxim-ic.com/an1943 Page 1 of 4 Figure 1. Finite switch time effect Circuit Solution With the circuit modification shown in Figure 2, the trailing black level will be replaced with a trailing white level. If this white level equals the OSDFILL level then the trail effectively disappears, eliminating the finite switch time effect. This is shown in Figure 3. The resistor divider formed by R14 and R sets the brightness of the trailing white level, which can be set to equal the brightness of OSDFILL. When R equals 453 ohms, then the trailing white level is nominally 100 IRE. Figure 2 shows a modification to only one of eight channels. Four MAX4616s can be used to improve all eight channels of the MAX4455. www.maxim-ic.com/an1943 Page 2 of 4 Figure 2. Modification to the MAX4455 EV circuit board on channel 0 www.maxim-ic.com/an1943 Page 3 of 4 Figure 3. Fix for the finite switch time effect MORE INFORMATION MAX4358: QuickView -- Full (PDF) Data Sheet (1.0M) -- Free Sample MAX4455: QuickView -- Full (PDF) Data Sheet (672k) -- Free Sample MAX4616: QuickView -- Full (PDF) Data Sheet (176k) -- Free Sample www.maxim-ic.com/an1943 Page 4 of 4