550VA Audio/Video Backup Power Block - Exclusive UPS Protection for Structured Wiring Enclosure MODEL NUMBER: AV550SC Highlights 4 AC outlets (including 1 delay-on outlet for router) Automatic recycle/reset button; Auto-restart capability Regulated 12V DC output for 4 devices; Complete surge suppression Convenient installation fits structured wiring enclosures without using mounting screws or brackets HD-compatible 2.2GHz coaxial and telephone/modem/DSL line surge protection; 550VA UPS capacity Package Includes AV550SC backup power block Description Detachable 6 in. NEMA 5-15P The AV550SC Backup Power Block provides the highest level of protection for structured cabling installations power cord (ie. telephone, Internet and coax connections). With reliable battery backup, surge protection and EMI/RFI line Owner's manual with warranty noise filtering, the AV550SC provides a complete protection solution for audio/video distribution systems by information supporting modems, routers, RF amplifiers, network interfaces, cameras, modulators and other equipment through all power problems. In the event of a power failure, the AV550SC includes an auto-restart feature that eliminates the need to perform an on-site restart. In addition, when a modem or router freeze-up occurs, the AV550SC features a recycle/reset button with sequential outlet startup for proper modem and router rebooting. Features 3 widely-spaced AC outlets (2 Auxiliary, 1 Modem)power, reset or start up connected equipment during a blackout or system freeze-up (provide battery backup, surge protection and EMI/RFI filtering) - 4 outlets total Convenient installation designed to fit in the bottom left corner of structured wiring enclosures without the need for mounting screws or brackets 60-second delay-on AC outlet (router) powers and resets the router during a blackout or system freeze-up and delays router start-up for proper system rebooting (provides battery backup, surge protection and EMI/RFI filtering) 12V DC (1-Amp) output connector provides an additional output power source for 12V DC devices as well as battery backup protection for 4 devices Recycle/reset button resets connected equipment during system freeze-ups with sequential outlet startup HD-compatible 2.2GHz coax jacks protect connected coax lines against surge damage and filter disruptive EMI/RFI line noise. Tel/modem/DSL jacks protect connected telephone,modem or DSL lines against surge damage and filter disruptive EMI/RFI line noise IEC power input connector accepts included 6-inch power cord Diagnostic/Overload LEDs: Alert users to potential power problems before they affect connected equipment. Resettable circuit breaker prevents dangerous system overloads Auto-restart capability eliminates the need to perform an on-site restart 550VA/300 watts standby UPS system Mounting screw holes are included on the back of the unit for convenient board, wall or ceiling mounting (for projectors) Customizable labels for easier cord/cable indentification and maintenance 1/4 Specifications OUTPUT Output Volt Amp Capacity (VA) 550 Output Watt Capacity (Watts) 300 Nominal Output Voltage(s) Supported 110V; 115V; 120V Nominal Voltage Details 115v nominal output in battery mode Frequency Compatibility 60 Hz Output Voltage Regulation (Battery Mode) +/- 5% Output Receptacles (4) 5-15R Output Receptacle Details One receptacle has a 60 second power-up delay Output AC Waveform (AC Mode) Sine wave Output AC Waveform (Battery Mode) PWM sine wave INPUT Rated input current (Maximum Load) 10A Nominal Input Voltage(s) Supported 120V AC UPS Input Connection Type 5-15P; C14 inlet UPS Input Connection Description 5-15P input cable is detachable via C14 inlet on UPS Input Circuit Breakers 10A UPS Input Cord Length (ft.) 0.5 UPS Input Cord Length (m) 0.2 Recommended Electrical Service 15A 120V Input Cord Length (ft.) 0.5 Input Cord Length (m) 0.1524 Input Phase Single-Phase Right-Angle Plug No BATTERY Full Load Runtime (min.) 3 min. (300w) Half Load Runtime (min.) 10 min. (150w) DC System Voltage (VDC) 12 Battery Recharge Rate (Included Batteries) Less than 9 hours from 10% to 90% 2/4 Expandable Runtime No USER INTERFACE, ALERTS & CONTROLS Switches Includes 1 on/off push button (also acts as recycle/reset button) LED Indicators 2 LEDs indicate power status and overload/low battery status SURGE / NOISE SUPPRESSION UPS Dataline Suppression 1 line TEL/DSL (1 in / 1 out); Coax jacks (1 set) UPS Dataline Suppression Details HD-compatible 2.2GHz coaxial protection EMI / RFI AC Noise Suppression Yes AC Suppression Joule Rating 1038 DATALINE SURGE SUPPRESSION Telephone/DSL Protection Yes Cable (Coax) Protection Yes Network (Ethernet) Protection No PHYSICAL Primary Form Factor Desktop UPS Power Module Dimensions (hwd, in.) 8.4 x 6.8 x 3 UPS Power Module Dimensions (hwd, cm) 21.2 x 17.2 x 7.5 UPS Power Module Weight (lbs.) 7.8 UPS Power Module Weight (kg) 3.5 UPS Shipping Dimensions (hwd / in.) 4.5 x 8.4 x 9.9 UPS Shipping Dimensions (hwd / cm) 11.5 x 21.2 x 25.2 Shipping Weight (lbs.) 8.4 Shipping Weight (kg) 3.8 UPS Housing Material Sheet metal ENVIRONMENTAL Operating Temperature Range +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius Storage Temperature Range +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius Relative Humidity 0 to 95%, non-condensing AC Mode BTU / Hr. (Full Load) 31.5 Battery Mode BTU / Hr. (Full Load) 223.9 3/4 AC Mode Efficiency Rating (100% Load) 97% COMMUNICATIONS Communications Interface None LINE / BATTERY TRANSFER Transfer Time 4 milliseconds Low Voltage Transfer to Battery Power (Setpoint) 99V High Voltage Transfer to Battery Power (Setpoint) 139V SPECIAL FEATURES Green Energy-Saving Features High efficiency economy mode operation; Greater than 95% efficiency - GREEN UPS CERTIFICATIONS UPS Certifications Tested to UL1778 (USA); Tested to CSA (Canada); Tested to NOM (Mexico); Meets FCC Part 15 Category B (EMI); Meets FCC Part 68 / Industrie Canada (telecommunications); ROHS (Restriction of Hazardous Substances) WARRANTY Product Warranty Period (Worldwide) 2-year limited warranty © 2016 Tripp Lite. All rights reserved. All product and company names are trademarks or registered trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice. Tripp Lite uses primary and third-party agencies to test its products for compliance with standards. See a list of Tripp Lite's testing agencies: http://www.tripplite.com/products/product-certification-agencies 4/4