PSOC® 3 FIRSTTOUCH™ STARTER KIT QUICK START GUIDE Out of Box Demo: PSoC Rocks! 1 2 Connect the 9-V battery to the board. Wave the kit and view the message, as shown. 3 4 Insert the kit CD and run the CD’s autorun utility. Open the guide and install software. PSOC® 3 FIRSTTOUCH™ STARTER KIT QUICK START GUIDE CapSense® Proximity Sensor Voltage Regulator General-purpose Switch CY8C3866AXI PSoC 3 Device Accelerometer CapSense Slider J4 Voltage Regulator Source Select 8 Red LED Outputs 12-Pin Wireless Header 9-V Battery Header USB Mini B Port J1 Vddio Power Source Select Thermistor 28-Pin External I/O (on reverse) CY7C68013A FX2LP High-Speed USB Kit Revision To know if you are using the latest kit, look for the kit revision in the white sticker at the bottom left on the back of the kit box. If the revision reads CY8CKIT-003B REV. **, then you own the latest version. You can also check the silicon marketing part number on the board; the part number should be CY8C3866AXI-040. This kit is equipped with production PSoC 3 silicon. For the latest information about this kit, visit http://www.cypress.com/go/CY8CKIT-003 © 2009-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc.#: 001-53755 Rev.*D