Photoelectric sensors FLDM 170G1011/S42 Copy counters dimension drawing 70 64 30 17 158 M16 x 0,75 Display and keypad 47° Laser beam Interface connector Main connector 68 35 23,5 6 M6 ø 6,4 170 13 12 general data photo measuring distance Sd 0 ... 90 mm optimum operating distance 70 mm counting rate < 3000000 copies/h object speed 5 m/sec object cycle distance > 1 mm sensitivity single sheet/edge thickness 0,1 mm sync. input yes measuring point visible red laser line 6 mm light source pulsed red laser diode wave length 670 nm laser class 2 edge indicator LED yellow power on indication LED green false pulse suppression 4 program options direct gap detection yes sensitivity adjustment 4 preset levels or level set by customer connection diagram electrical data voltage supply range +Vs 10 ... 30 VDC current consumption max. (no load) 230 mA output circuit push-pull output pulse length 0,3 ... 100 ms selectable short circuit protection yes reverse polarity protection yes interface serial for ScaDiag software 200mA 10 Ω polyfuse (3) +VS (1) output (6) ground laser warning LASER RADIATION DO NOT STARE INTO BEAM Wavelength: 620...680nm Max. av. Output: < 1mW IEC 60825-1, Ed. 2, 2007 CLASS 2 LASER PRODUCT mechanical data width / diameter 30 mm type rectangular housing material die-cast zinc connector base (main connector) DIN 45322, 6 pin connector base (interface) DIN 45326, 8 pin front (optics) glass Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to laser notice No. 50, dated June 24, 2007 A software package called ScaDiag allows to control all functions and settings. ambient conditions operating temperature 0 ... +50 °C protection class IP 54 FLDM 170G1011/S42 Also the software allows to record and display measurement sequences speeding up troubleshooting. www.baumer.com 11/11/2015