INFINEON SLE66C24PEC

Security & Chip Card ICs
SLE 66C24PE
8/16-Bit Security Controller
with enhanced instruction set for large memories
in 0.22 µm CMOS Technology
68-Kbytes ROM, 2304 Bytes RAM, 2-Kbytes EEPROM
Dual Key Triple DES
Preliminary
Short Product Information 02.04
SLE 66C24PE Short Product Information
Ref.: SPI_SLE 66C24PE_0204
This document contains preliminary information on a new product under development.
Details are subject to change without notice.
Revision History:
Current Version 02.04
Previous Releases:
Page
Important: Further information is confidential and on request. Please contact:
Infineon Technologies AG in Munich, Germany,
Security & Chip Card ICs,
Tel +49 - (0)89 234-80000
Fax +49 - (0)89 234-81000
E-Mail: [email protected]
Edition 2004
Published by Infineon Technologies AG, CC Applications Group
St.-Martin-Strasse 53, D-81541 München
© Infineon Technologies AG 2002
All Rights Reserved.
Attention please!
The information herein is given to describe certain components and shall not be considered as warranted
characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding
circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
Information
For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon
Technologies Office in Germany or our Infineon Technologies Representatives world-wide (see address list).
Warnings
Due to technical requirements components may contain dangerous substances. For information on the types in
question please contact your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in life-support devices or systems with the express written
approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of
that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices
or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect
human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered.
SLE 66C24PE
8/16-Bit Security Controller with enhanced instruction set for large
memories in 0.22µm CMOS Technology, 68-Kbyte ROM, 2304 Bytes
RAM, 2-Kbyte EEPROM and Dual Key Triple DES Accelerator
Features
•
•
•
New
New
•
•
Instruction set opcode compatible with standard
SAB 8051 processor
New
New
New
•
•
•
•
•
•
•
New
•
•
Additional enhanced instructions for direct
physical memory access of >64kByte
•
•
•
Typically saves up to 90 % code space and
increases execution speed up to 80 %
Dedicated, non-standard architecture with
execution time 6 times faster than standard SAB
8051 processor at same external clock. (Up to 18
times faster using internal frequency PLL x 3
compared to external clock).
•
•
•
68 Kbytes User ROM for application programs
2 Kbytes MicroSlim-EEPROM
2Kbytes XRAM, 256 bytes internal RAM
Enhanced Memory Management and Protection
Unit (MMU) with application and user defined
segments
•
•
•
Dual Key Triple DES (DDES)
CC EAL5+ certification according to BSI-PP-0002
planned
16-bit Interrupt Module
•
EEPROM programming voltage generated on chip
Code executions during E²-programming for faster
personalization
New
New
•
•
•
•
•
•
•
•
•
Preliminary - Short Product Information
Increased internal clock frequency for maximum
performance
Internal frequency is automatically adjusted to
guarantee a given limited power
consumption
Two 16-bit Autoreload Timer
Power saving sleep mode
Ext. Clock freq. 1 up to 7.5 MHz for int. Clock up to
33 MHz
UART for handling serial interface in accordance
with ISO/IEC 7816 part 3 supporting transmission
protocols T=1 and T=0
Supply voltage range:1.8 V, 3.0 V, 5.0 V
Support of current consumption limits by GSM / UICC
applications
< 10 mA @ 5.5 V
< 6 mA @ 3.3 V
< 4 mA @ 1.98 V
Operating Temperature range: -25 to +85°C
Storing temperature range: –40° to +125°C
ESD protection larger than 6 kV (HBM)
MicroSlim-EEPROM
True Random Number Generator with Firmware
test function
CRC Module
Adjustable internal frequency according to
available power or required performance
•
Addressable memory up to 16 Mbyte
•
•
•
Internal Clock with up to 33 MHz:
Programmable internal frequency (PLL x1, x2, x3, x4
and free running mode(s)).
•
Downward compatibility to existing
SLE 66CxxxP products for existing masks
without using the new features
•
•
New
8/16-bit microcomputer in 0.22 µm CMOS
technology
3/8
Typical Erase + Write time ≤ 2.9 ms
Enhanced ECC module controlled by OS
Reading and programming byte by byte
Platform prepared for flash-like erasing of E²segments up to 2 kB
Flexible page mode for 1 to 64 bytes write/erase
operation
32 bytes security area (OTP)
Fast personalization mode ≤ 1.0 ms
Minimum of 500.000 write/erase cycles @ 25°C per
page. Maximum of 16.500.000 write/erase cycles per
sector
Typical data retention of 10 years @ 25°C
02.04
SLE 66C24PE
Memory Management and Protection Unit
New
•
•
•
•
•
New
•
•
Addressable memory of up to 16 Mbyte
Separates OS (system mode) and application
(user mode)
System routines called by interrupts
OS can restrict access to peripherals in application
mode
Variable application orientated segments defined
and controlled by OS
Code execution from XRAM possible
Enhanced multi-application support by 16
descriptors for system / application mode.
Security Features
•
•
•
•
Enhanced sensor concept:
•
•
•
•
•
•
Low and high voltage sensors
•
•
•
•
•
•
•
•
•
•
Automatic randomization smoothing of power profile
Effective HW-countermeasures against
SEMA/DEMA, SPA/DPA, DFA and Timing-Attacks
Non standard dedicated Smart Card CPU – Core
Active Shield with automatic and user controlled
attack detection
Hardware countermeasures controlled by True
Random Number Generator
Targeted Certification
•
•
•
CC EAL5+
VISA level 3
CAST
Support
•
HW-& SW-Tools (Emulator, ROM Monitor, Card
Emulator, Simulator, Softmasking)
Frequency sensors and filters
•
Supported Standards
Glitch Sensors
Temperature Sensor
Life Test Function for Sensors (UMSLC)
Bus confusion
•
•
•
•
Application notes
ISO/IEC 7816
EMV 2000
GSM 11.11, 11.12, 11.18
ETSI TS 102 221
Security reset detection
Current control oscillator (ICO)
Sparkling SFR encryption for DDES and ACE,
CRC module and RNG
32 bytes security PROM, hardware protected for
batch-, wafer-, die-individual security data. Unique
chip identification number for each chip
Additional memory for customer-defined security
FabKey on request
MED – memory encryption/decryption device for
XRAM, ROM and EEPROM
Security optimized layout and layout scrambling
Fast IRAM erase
Enhanced Error correction unit (ECU)
Testmode
•
•
•
Light Sensor
Memory Security
New
Anti Snooping
Irreversible Lock - Out of test-mode
Preliminary - Short Product Information
Document References
•
•
•
•
•
Confidential Data Book SLE 66CxxxPE
Qualification report
Chip delivery specification for wafer with chip-layout
(die size, orientation,...)
Module specification
package, etc.
containing
description
of
Qualification report module
Development Tools Overview
•
•
•
•
•
4/8
Short Product Information Software Development Kit
SDK CC
Short Product Information Card Emulator CE66PE
Short Product Information ROM Monitor RM66PE
Short Product Information Emulator ET66PE Hitex or
ET66PE KSC
Short Product Information Smart Mask Package
02.04
SLE 66C24PE
Performance DDES- Accelerator (typical values, based on internal test results)
Operation
Data Block
Length
Encryption Time for an
8-Byte Block incl. Data
Transfer
New
5 MHz 15 MHz 33 MHz*
56-bit Single DES Encryption
64 bit
23 µs
8 µs
3.5 µs
112-bit Triple DES Encryption
64 bit
35 µs
12 µs
5.3 µs
* preliminary values
Ordering Information
Type
Package
1
SLE 66C24PE C
Die (sawn,
unsawn)
SLE 66C24PE M5
M5.1
Voltage
Temperature
Range
Range
Frequency
Range
(int. clock
frequency
1.8 V; 3.0 V; 5.0 V
– 25°C to + 70°C
or
or
or
3.0 V; 5.0 V
– 25°C to + 85°C
1 MHz - 7.5 MHz
Up to 33 MHz
Frequency
Range
(ext. clock
frequency)
1 MHz - 5 MHz
For ordering information please refer to the databook and contact your sales representative.
Production sites for SLE 66C24PE:
•
1
Dresden (Germany), UMC (Taiwan), Altis (France).
available as wire-bonded module (M5) for embedding in plastic cards or as die (C) for customer packaging
Preliminary - Short Product Information
5/8
02.04
SLE 66C24PE
Pin Configuration
VCC
GND
CLK
RST
SLE
66C24PE
I/O
Figure 1: Pin Configuration
Pin Definitions and Functions
Symbol
Function
VCC
Operating voltage
RST
Reset input
CLK
Processor clock input
GND
Ground
I/O
Bi-directional data port
Preliminary - Short Product Information
6/8
02.04
SLE 66C24PE
General Description
The SLE66C24PE is a member of the improved 66PE-series of Infineon Technologies. This high performance security
controller is manufactured in advanced 0.22 µm CMOS technology. It is downward compatible to existing 66P controller
derivatives. The well known ECO2000 8/16 bit CPU provides the high efficiency of the SAB 8051 instruction set
extended by additional powerful instructions together with enhanced performance, memory sizes and security features
compared to existing 66P derivatives.
Performance: The internal clock frequency can be adjusted to a level up to 33 MHz either as a multiple of 1,2,3,4 to the
external frequency or independent of the clock rate of the terminal with the help of the internal clock. It is adjustable
according to either available power requirements or required performance:
•
New
Increased internal clock frequency for maximum performance, e.g. for high performance with max. frequency in
payment applications.
•
Automatically adjusted frequency for a max. given power consumption, e.g. by GSM or UMTS requirements.
Memory: The SLE66C24PE offers 68 Kbytes of User-ROM, 256 Bytes internal RAM, 2048 byte XRAM and 2 Kbytes
MicroSlim-EEPROM, to fulfill the requirements of mainly SDA payment, Identification and loyalty applications. The large
ROM size allows to place applications in the ROM-mask and to keep the E²PROM free for customer data. In addition it
saves mask development costs, as one mask may be used for different customer projects.
The enhanced Memory Management and Protection Unit allows a secure separation of the operating system and
different applications. It allows to separate the memories in application orientated segments, which can be controlled by
the OS. Furthermore, the MMU makes a secure downloading of applications possible even after personalization of a
card. These new features suit the requirements of the next generation of multi application operating systems.
Voltage
Clock
Reset
ROM
68 Kbyte
XRAM
2 Kbyte
16-Bit CPU with
MMU
&
ECO 2000
Instruction Set
EEPROM
2 Kbyte
DES
Accelerator
Address-/Data Bus
Sleep Mode Logic
Sensors/Filters
Interrupt
Voltage Regulator
two
16-bit
Timer
CRC
Random
Number
Generator
UART
Clock
generated
Figure 2: Block Diagram SLE 66C24PE
The new platform is designed to address up to 16Mbyte. However this feature is only available upon request and will
clearly require a change in the existing tool environment.
In addition, new instructions have been implemented in the design for an efficient direct access of physical memory
>64Kbyte up to 16 MByte.
Preliminary - Short Product Information
7/8
02.04
SLE 66C24PE
Security features:
Since the very beginning, security is an integrated part of Infineons product development, as proved by various
certificates (ITSEC, CC, Proton, VISA, ZKA, Mondex). The so called “integral security concept” for the 66P series
ensures:
•
•
•
A secret storage of any confidential code, data and keys
Protection against side channel attacks such as: Simple Power Analysis (SPA) , Differential Power Analysis (DPA),
Protection against Differential Fault Analysis (DFA), Electromagnetic Emanation Attack (EMA) and other possible
HW or SW attacks
Peripherals: The CRC module allows the easy generation of checksums according to ISO/IEC 3309 (16-Bit-CRC). To
minimize the overall power consumption, the chip card controller IC offers a sleep mode. The UART supports the halfduplex transmission protocols T=0 and T=1 according to ISO/IEC 7816-3. All relevant transmission parameters can be
adjusted by software, as e.g. the clock division factor, direct/inverse convention and the number of stop bits. Additionally,
the I/O port can be driven by communication routines realized in software.
The HW-DES module supports symmetric crypto algorithms according to the Data Encryption Standard in the Electronic
Code Book Mode.
The random number generator (RNG) is able to supply the CPU with true random numbers on all conditions.
The advanced sensor concept includes various sensors for any kind of attack scenarios and even more important a “Life
Test ” for sensors.
As an important feature, the chip provides an on-chip security, which fulfills the strong security requirements of a
Common Criteria evaluation at an EAL5+ level.
In conclusion, the SLE 66C24PE fulfills all the requirements of today's chip card applications, and is especially designed
for SDA payment and loyalty applications. In addition it offers a powerful platform for multi application cards based on
Multos, Java or WinSC.
The SLE66C24PE offers additional peripherals, in combination with enhanced performance and optimized power
consumption on a minimized die size.
Preliminary - Short Product Information
8/8
02.04