Features • • • • Lamp Outage Indication for Car and Trailer Temperature and Supply Voltage Compensated Flashing Frequency Relay Driver Output with High Current Carrying Capacity and Low Saturation Voltage Minimum Lamp Load for Flasher Operation > 10W 1. Description The bipolar integrated circuit ATA2069 is designed for the use in relay-operated automotive flasher modules and makes it possible to detect the outage of flasher bulbs on the vehicle itself and also on a trailer. Vehicles with a trailer hook are equipped with additional pilot lamps in the dashboard. Flasher with Trailer Control ATA2069 ATA2069 is off (i.e., the relay is deactivated) as long as the flasher switch (at contact +49a) is open. As soon as this switch is closed, the IC starts reliably with the bright phase. There are two thresholds integrated: one threshold is defined to be 21 + 10W and is designed for the lamp outage detection of 1 of 2 lamps. If the current is below this threshold, the IC switches to frequency doubling, just like the standard flashers (e.g. U2043B). The other threshold is defined to be 42 + 10W and is designed for the outage detection of 1 of 3 lamps; if this happens, the additional trailer pilot lamp is switched off, but there is no frequency doubling. 50 ms after the start of the bright phase, the comparator measures the voltage drop at the shunt and latches this value for the rest of the bright phase. The output of this pilot lamp (pin 8) is short-circuit protected against GND. In case of a short circuit the external transistor is switched off after 52 ms for the rest of the current flasher cycle, but it is enabled again for the next cycle. Rev. 4917B–AUTO–03/06 Figure 1-1. Block Diagram VS 2 +49 VS - 57 mV C1 K1 5 32V VS - 111 mV 3 kΩ R1 R4 10Ω K4 Timing Unit K2 VS - 11 mV S R 6 Q VS/2 K3 1 40% of VS K5 3 7 4 R3 1.5 kΩ Relay 49a R2 100Ω 8 Shunt R6 VS R5 20 mΩ +49 150Ω 4W Pilot lamp trailer 21W trailer 2 5W 21W 21W 21W 21W 5W 21W trailer ATA2069 4917B–AUTO–03/06 ATA2069 2. Pin Configuration Figure 2-1. Pinning GND VS REL LD Table 2-1. Pin 1 2 3 4 8 7 6 5 OPL SI OSCR OSCC Pin Description Symbol Function 1 GND IC ground 2 VS Supply Voltage 3 REL Relay driver 4 LD Lamp failure detection 5 OSCC Cap. oscillator 6 OSCR Res. oscillator 7 SI Start input (49a) 8 OPL Output pilot lamp 3 4917B–AUTO–03/06 3. Absolute Maximum Ratings Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Parameters Pin Symbol Value Unit 2 VS 16.5 V TJ 150 °C Ambient temperature range Tamb –40 to +95 °C Storage temperature range Tstg –55 to +150 °C Thermal resistance junction ambient DIP8 Rthjc 110 K/W Thermal resistance junction ambient SO8 Rthjc 160 K/W Supply voltage Junction temperature 4. Electrical Characteristics Parameters Pin Symbol Supply voltage range 2 VS (+49a) Relay output current 3 IRel 300 mA 3 VRel 1 1.5 V V 3 IRelr 100 µA Relay saturation voltage Test Conditions I = 130 mA I = 250 mA Relay leakage current Min. Typ. Max. 9 to 15 Unit V Values for T = 25°C Start delay ton 10 ms 55 ms Delay time for output OPL OPL tDel 45 Switch off delay time output OPL in case of short circuit OPL tDel 1.5 2.4 ms Voltage threshold for short circuit detection at output OPL OPL Vth 36 44 % of Us Output current at OPL OPL IO 10 25 mA Saturation voltage at OPL OPL VSATO 300 mV Control signal threshold K1 for outage detection without trailer operation VS = 9V VS = 13V VS = 15V Vk1 47.5 54.2 58 50 57 61 52.2 59.9 64.1 mV mV mV Control signal threshold K4 for outage detection with trailer operation VS = 9V VS = 13V VS = 15V Vk4 96 109 115 98 111 118 100 113 120 mV mV mV Delta f1 –5 +5 % Frequency tolerance Bright period Basic frequency Delta f1 47 53 % Bright period Frequency doubling Delta f2 37 45 % Frequency increase Lamp outage f2 2.15 × f 2.3 × f Hz Leakage increase 49a to GND RI 5 kΩ Lamp load 4 PL 10 W ATA2069 4917B–AUTO–03/06 ATA2069 5. Ordering Information Extended Type Number Package Remarks ATA2069-3AY DIP8 Tubed, Pb-free ATA2069-TAY SO8 Tubed, Pb-free ATA2069-TAG3Y SO8 Taped and reeled, Pb-free 6. Package Information Package: DIP8 Dimensions in mm 9.8 max. 7.62±0.15 9.6±0.1 0.3 B A 2.5 3.6±0.1 4.2±0.3 6.7 1.8 1.2±0.3 0.53±0.05 2.54 nom. 0.4 A 6.3±0.1 0.36 max. 3 x 2.54 = 7.62 nom. B 8.75±0.8 1.54 0.65 8 5 technical drawings according to DIN specifications 1 4 Drawing-No.: 6.543-5040.01-4 Issue: 1; 16.01.02 5 4917B–AUTO–03/06 Package SO8 Dimensions in mm 5.2 4.8 5.00 4.85 3.7 1.4 0.25 0.10 0.4 1.27 6.15 5.85 3.81 8 0.2 3.8 5 technical drawings according to DIN specifications 1 4 7. Revision History Please note that the following page numbers referred to in this section refer to the specific revision mentioned, not to this document. 6 Revision No. History 4917B-AUTO-03/06 • Table “Ordering Information” on page 5 changed. ATA2069 4917B–AUTO–03/06 Atmel Corporation 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 487-2600 Regional Headquarters Europe Atmel Sarl Route des Arsenaux 41 Case Postale 80 CH-1705 Fribourg Switzerland Tel: (41) 26-426-5555 Fax: (41) 26-426-5500 Asia Room 1219 Chinachem Golden Plaza 77 Mody Road Tsimshatsui East Kowloon Hong Kong Tel: (852) 2721-9778 Fax: (852) 2722-1369 Japan 9F, Tonetsu Shinkawa Bldg. 1-24-8 Shinkawa Chuo-ku, Tokyo 104-0033 Japan Tel: (81) 3-3523-3551 Fax: (81) 3-3523-7581 Atmel Operations Memory 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 436-4314 RF/Automotive Theresienstrasse 2 Postfach 3535 74025 Heilbronn, Germany Tel: (49) 71-31-67-0 Fax: (49) 71-31-67-2340 Microcontrollers 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 436-4314 La Chantrerie BP 70602 44306 Nantes Cedex 3, France Tel: (33) 2-40-18-18-18 Fax: (33) 2-40-18-19-60 ASIC/ASSP/Smart Cards 1150 East Cheyenne Mtn. Blvd. Colorado Springs, CO 80906, USA Tel: 1(719) 576-3300 Fax: 1(719) 540-1759 Biometrics/Imaging/Hi-Rel MPU/ High Speed Converters/RF Datacom Avenue de Rochepleine BP 123 38521 Saint-Egreve Cedex, France Tel: (33) 4-76-58-30-00 Fax: (33) 4-76-58-34-80 Zone Industrielle 13106 Rousset Cedex, France Tel: (33) 4-42-53-60-00 Fax: (33) 4-42-53-60-01 1150 East Cheyenne Mtn. Blvd. Colorado Springs, CO 80906, USA Tel: 1(719) 576-3300 Fax: 1(719) 540-1759 Scottish Enterprise Technology Park Maxwell Building East Kilbride G75 0QR, Scotland Tel: (44) 1355-803-000 Fax: (44) 1355-242-743 Literature Requests www.atmel.com/literature Disclaimer: The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS, BUSINESS INTERRUPTION, OR LOSS OF INFORMATION) ARISING OUT OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no representations or warranties with respect to the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice. Atmel does not make any commitment to update the information contained herein. Unless specifically provided otherwise, Atmel products are not suitable for, and shall not be used in, automotive applications. Atmel’s products are not intended, authorized, or warranted for use as components in applications intended to support or sustain life. © Atmel Corporation 2006. All rights reserved. Atmel ®, logo and combinations thereof, Everywhere You Are ® and others, are registered trademarks or trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others. Printed on recycled paper. 4917B–AUTO–03/06