Catalog: 1654001 Issue Date: 06.2011 Corcom Product Guide RFI Filter for Power Factor Corrected Power Supplies U Series UL Recognized CSA Certified VDE Approved 6EU1 U Series 6EUP Specifications • Designed for equipment using power factor corrected power supplies • Offers high impedance circuit to mismatch the power supply’s impedance characteristics • Available in PC board mountable version • All models meet low leakage current requirements Maximum leakage current each Line to Ground: @ 120 VAC 60 Hz: .30 mA @250 VAC 50 Hz: .50 mA Hipot rating (one minute): Line to Ground: Line to Line: 2250 VAC 1450 VDC Rated Voltage (max): 250 VAC Operating Frequency: 50/60 Hz Rated Current: 6A Operating Ambient Temperature Range (at rated current Ir): -10°C to +40°C In an ambient temperature (Ta) higher than +40°C the maximum operating current (Io) is calculated as follows: Io = Ir (85-Ta)/45 Ordering Information 6EU1 Input / Output Style 1 – .250 [6.3] spade terminals P – PC board pins Electrical Schematic LINE LOAD U Series Leakage current designation E – Low leakage (<0.5 mA) Current Rating 6A Available Part Numbers 6EUP 6EU1 84 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. For email, phone or live chat, please go to te.com/help corcom.com Catalog: 1654001 Issue Date: 06.2011 Corcom Product Guide RFI Filter for Power Factor Corrected Power Supplies (continued) U Series Case Styles 6EU1 Case Dimensions Part No. B C 6EU1 D 1 E RFI Power Line Filters B 6EUP D E A A Performance Data C Typical Insertion Loss Measured in closed 50 Ohm system 6EUP 6EU db 100 90 80 B 70 60 50 40 30 Ground pin (2) Threaded Inserts (3) .14 3.56 20 10 0 .39 9.91 0.01 0.1 1 10 30 Frequency in MHz Common Mode / Asymmetrical (L-G) Differential Mode / Symmetrical (L-L) C A Minimum Insertion Loss Common Mode / Asymmetrical (Line to Ground) Recommended PC Board Layout LINE LOAD .157 Dia. (3) .075 Dia. (6) .26 6.60 1.50 38.1 .52 13.21 .75 19.05 Differential Mode / Symmetrical (Line to Line) 1.50 38.1 .79 20.07 2.10 53.34 2.99 75.95 85 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. For email, phone or live chat, please go to te.com/help corcom.com