CY3236A PYROELECTRIC INFRARED (PIR) MOTION SENSOR EVALUATION KIT QUICK START GUIDE 1 2 Insert the CY3236A-PIRMOTION board kit DVD into the DVD drive of your PC. The CY3236A-PIRMOTION board is preprogrammed with firmware designed for the CY8C27443 PSoC device. Power the board using the 12-V adapter at the power jack, J1.Esure that the shunt is not placed on J4. Install the kit contents, PSoC Designer, and PSoC Programmer. 3 4 Stimulate the infrared sensor by moving your hand above the sensor. To adjust the length of time the relay is active, use the potentiometer, R7. Turn it counter-clockwise to increase the relay-on time and vice versa. Relay on is indicated by the LED, D2. Use the Fresnel lens to direct infrared rays from various angles toward the PIR sensor. Use the AC terminal block to connect an external hardware device. To enable the ambient light detector, shunt header J4. After enabling this feature, adjust the responsiveness of the board to light, using the potentiometer, R8. [+] Feedback CY3236A PYROELECTRIC INFRARED (PIR) MOTION SENSOR EVALUATION KIT QUICK START GUIDE CY3236A-PIRMOTION KIT DETAILS ISSP/I2C Programming Header AC Terminal Block Relay PSoC CY8C27443 12-V Power Jack DAC Debug Test Point Relay Time Adjust LED for Relay Status Light Sensitivity Adjust Status LEDs Ambient Light Sensor Light Detect Enable PIR Sensor with Fresnel Lens Covering For the latest information about this kit, visit http://www.cypress.com/go/CY3236 © 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. DOC#: 001-69098 REV. *A [+] Feedback