MASTER INSTRUMENT CORPORATION VOLTAGE RANGE CURRENT KBL005 THRU KBL10 50 to 1000 Volts 4.0 Amperes FEATURES l Low cost l This series is UL recognized under component index ,file number E127707 l High forward surge current capability l Ideal for printed circuit board l High temperature soldering guaranteed: 260 oC/10 second, 0.375” (9.5mm) lead length at 5 lbs.(2.3kg) tension. MDN MECHANICAL DATA l Case: Transfer molded plastic l Terminal: Lead solderable per MIL-STD-202E method 208C l Mounting Postition: Any l Weight: 0.22ounce, 6.21gram TRCEKPI MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25oC ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load derate current by 20%. SYMBOLS KBL005 Fdg`hldihl dh dh^c`l \h_ .gdffdg`m`kl/ KBL01 KBL02 KBL04 KBL06 KBL08 KBL10 UNITS Maximum Repetitive Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 Volts Maximum Average Forward Rectified Output Current, at TC=50℃(Note 2) I(AV) 4.0 Amps 3.0 TA=50℃(Note 3) Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) IFSM 200 Amps Rating for Fusing (t<8.3ms) I2 t 166 A2 s Maximum Instantaneous Forward Voltage Drop per bridge element at 4.0A VF 1.0 Volts Maximum DC Reverse Current at rated DC blocking voltage per element TA=25℃ TA=100 ℃ Typical Junction Capacitance (Note 1) Typical Thermal Resistance (Note 2) Operating and Storage Temperature Range 10 µAmps 1.0 mAmps CJ 105 pF RθJA 20 TJ , TSTG -55 to +150 IR NOTES: 1. Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts. 2. Unit mounted on 2.0”x1.6”x0. 3 ” thick (5.0x4.0x0.08 cm) Al. plate. 3. P.C. Board mount with 0.5”x0.5” (12x12cm) copper pads 0.375” (9.5mm) lead length Web Site: WWW.PS-PFS.COM o C/W o C MASTER INSTRUMENT CORPORATION VOLTAGE RANGE CURRENT KBL005 THRU KBL10 Web Site: WWW.PS-PFS.COM 50 to 1000 Volts 4.0 Amperes