ATMEL ATR2808-PLQ

Features
• Fully Integrated TX/RX with 2.9 GHz TX VCO for 5.8 GHz Applications Using a
Frequency Doubler
• Supply Voltage Range 3.4V to 4.6V
• TX Preamplifier with 0 dBm Output Power at 2.9 GHz
• Ramp-signal Generator for Power Ramping and Power Control of External SiGe Power
2.9/5.8 GHz
WDCET/ISM
Single-chip
Transceiver
Amplifier
• Fast Settling Synthesizer (1.728 MHz Channel Spacing at 5.8 GHz)
• Supports Multiple Reference Clocks (10.368 MHz/13.824 MHz)
Benefits
•
•
•
•
•
Extended Battery Operating Time
Low Current Consumption
Very Small 7 × 7 mm Package
Few Low Cost External Components
No Mechanical Tuning Required
ATR2808
1. Description
The ATR2808 is an RF IC for low-power applications in the 5.8 GHz ISM band. The
QFN 48-packaged IC is a complete transceiver including image rejection mixer, IF
amplifier, FM demodulator, baseband filter, RSSI, TX preamplifier, power-ramping
generator for power amplifiers, integrated synthesizer, fully integrated VCO and gaussian data filter for TX.
Figure 1-1.
Summary
Block Diagram
DEMOD
MIXER
IF_IN
OUT
IF_TANK
IF AMP 1
IR MIXER
CF
TANK
IF AMP 2
RF_IN
BB_OUT
DEMOD
BB FILTER
RAMP_OUT
RAMP_SET
RAMP
GEN
D/A
RAMP
D/A
DEMOD DAC
RSSI
RSSI
GF
VCO
TX / RX
SWITCH
TX_DATA
PC
PD
f
TX_OUT
3-WIRE
BUS
CLOCK
DATA
ENABLE
CTRL
LOGIC
RX_ON
TX_ON
PU_RX/TX
PU_PLL
:n
TX DRIVER
VCO
REG
AUX
REG
RC
CP
VREG_VCO
VS_VCO
VREG
VS_REG
OLE
GND_VCO
PU_REG REG_CTRL VTUNE
f
:n
CP
LD
REF_CLK
I_CPSW
Rev. 4693ES–DECT–03/06
Note: This is a summary document. A complete document
is available under NDA. For more information, please contact your local Atmel sales office.
2. Ordering Information
Extended Type Number
Package
Remarks
ATR2808-PLQ
QFN 48
Taped and reeled
3. Package Information
2
ATR2808
4693ES–DECT–03/06
Atmel Corporation
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 487-2600
Regional Headquarters
Europe
Atmel Sarl
Route des Arsenaux 41
Case Postale 80
CH-1705 Fribourg
Switzerland
Tel: (41) 26-426-5555
Fax: (41) 26-426-5500
Asia
Room 1219
Chinachem Golden Plaza
77 Mody Road Tsimshatsui
East Kowloon
Hong Kong
Tel: (852) 2721-9778
Fax: (852) 2722-1369
Japan
9F, Tonetsu Shinkawa Bldg.
1-24-8 Shinkawa
Chuo-ku, Tokyo 104-0033
Japan
Tel: (81) 3-3523-3551
Fax: (81) 3-3523-7581
Atmel Operations
Memory
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 436-4314
RF/Automotive
Theresienstrasse 2
Postfach 3535
74025 Heilbronn, Germany
Tel: (49) 71-31-67-0
Fax: (49) 71-31-67-2340
Microcontrollers
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 436-4314
La Chantrerie
BP 70602
44306 Nantes Cedex 3, France
Tel: (33) 2-40-18-18-18
Fax: (33) 2-40-18-19-60
ASIC/ASSP/Smart Cards
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906, USA
Tel: 1(719) 576-3300
Fax: 1(719) 540-1759
Biometrics/Imaging/Hi-Rel MPU/
High Speed Converters/RF Datacom
Avenue de Rochepleine
BP 123
38521 Saint-Egreve Cedex, France
Tel: (33) 4-76-58-30-00
Fax: (33) 4-76-58-34-80
Zone Industrielle
13106 Rousset Cedex, France
Tel: (33) 4-42-53-60-00
Fax: (33) 4-42-53-60-01
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906, USA
Tel: 1(719) 576-3300
Fax: 1(719) 540-1759
Scottish Enterprise Technology Park
Maxwell Building
East Kilbride G75 0QR, Scotland
Tel: (44) 1355-803-000
Fax: (44) 1355-242-743
Literature Requests
www.atmel.com/literature
Disclaimer: The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any
intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR STATUTORY
WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS, BUSINESS INTERRUPTION, OR LOSS OF INFORMATION) ARISING OUT
OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no
representations or warranties with respect to the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications
and product descriptions at any time without notice. Atmel does not make any commitment to update the information contained herein. Unless specifically provided
otherwise, Atmel products are not suitable for, and shall not be used in, automotive applications. Atmel’s products are not intended, authorized, or warranted for use
as components in applications intended to support or sustain life.
© Atmel Corporation 2006. All rights reserved. Atmel ®, logo and combinations thereof, Everywhere You Are ® and others, are registered trademarks or trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others.
Printed on recycled paper.
4693ES–DECT–03/06