155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Features • Duplex SC\ST\FC Single Mode Transceiver • Industry Standard 1x9 Footprint • Intermediate reach SONET OC-3 SDH STM-1 Compliant • Single +5V Power Supply • PECL/LVPECL Differential Inputs and Outputs • PECL/LVPECL Signal Detection Output • Wave Solderable and Aqueous Washable • LED Multisourced 1x9 Transceiver Interchangeable • Class 1 Laser Int. Safety Standard IEC 825 compliant • Uncooled laser diode with MQW structure • Complies with Telcordia (Bellcore) GR-468-CORE • ATM 155 Mbps links • RoHS compliant Absolute Maximum Rating Symbol Min. Max. Unit Power Supply Voltage Parameter Vcc 0 6 V Output Current Iout - 30 mA - - 260 ºC Tstg -40 85 ºC Symbol Min. Typ. Max. Unit Vcc 4.75 5 5.25 V Topr - 0 70 ºC - 155 - Soldering Temperature Storage Temperature Note 10 seconds on leads only Recommended Operating Condition Parameter Power Supply Voltage1 Operating Temperature1 (Case) Data Rate Mbps Note 1 : Please refer to ordering information Transmitter Specifications Parameter Symbol Min Typical Max Unit Notes Po -15 - -8 dBm Output power is coupled into a 9/125 µm single mode fiber λ 1261 1310 1360 nm 7.7 nm - dB Optical Optical Transmit Power Output center Wavelength Output Spectrum Width ∆λ Extinction Ratio ER 8.2 - Output ulse Mask Compliant with FDDI SMF-PMD1 Output Eye Compliant with ITU-T recommendation G.957 Optical Rise Time Optical Fall Time Relative Intensity Noise Total Jitter LUMINENTOIC.COM tr - - 2 RMS(σ) ns 10% to 90% Values 10% to 90% Values tf - - 2 ns RIN - - -116 dB/Hz TJ - - 1.2 ns Measured with 223-1 PRBS with 72 ones and 72 zeros. 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Transmitter Specifications Parameter Symbol Min Typical Max Unit ICC - - 160 mA Notes Electrical Power Supply Current Maximum current is specified at Vcc= Maximum @ maximum temperature Data Input Current-Low IIL -350 - - µA Data Input Current-High IIH - - 350 µA Differential Input Voltage VIH-VIL 300 - - mV Data Input Voltage-Low VIL-VCC -2.0 - -1.58 V Data Input Voltage-High VIH-VCC -1.1 - -0.74 V These inputs are compatible with 10K, 10KH and 100K ECL and PECL inputs Symbol Min Typical Max Unit Notes - - - -34 dBm Maximum Input Power Pin -7 - - dBm Signal Detect-Asserted Pa - - -34 dBm Measured on transition: low to high Signal Detect-Deasserted Pd -47 - - dBm Measured on transition: high to low 1.0 - 4.0 dB 1100 - 1600 nm Symbol Min Typical Max Unit Notes ICC - - 100 mA The current excludes the output load current Data Input Voltage-Low VOL -Vcc -2 - -1.58 V Receiver Specifications Parameter Optical Sensitivity Signal Detect-Hysteresis Wavelength of Operation Measured with 223-1 PRBS with 72 ones and 72 zeros. Receiver Specifications Parameter Electrical Power Supply Current Data Input Voltage-High VOH- Vcc -1.1 - -0.74 V Signal Detect Output Voltage-Low VSDL-Vcc -2 - -1.58 V Signal Detect Output Voltage-High VSDH- Vcc -1.1 - -0.74 V LUMINENTOIC.COM These outputs are compatible with 10K, 10KH and 100KECL and PECL outputs. 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Connection Diagram 1. (Rx GND) 2. (RD +) 3. (RD-) 4. (SD) 5. (Rx Vcc) 6. (Tx Vcc) 7. (TD-) 8. (TD+) 9. (Tx GND) NC Top View NC Receiver Signal Ground Receiver Data Out Receiver Data Out Bar Signal Detect Receiver Power Supply Transmitter Power Supply Transmitter Data In Bar Transmitter Data in Transmitter Signal Ground PIN Symbol 1 RxGND 2 RD+ See recommended circuit schematic 3 RD- See recommended circuit schematic 4 SD Active high on this indicates a received optical signal 5 RxVcc 6 TxVcc 7 TD- See recommended circuit schematic TD+ See recommended circuit schematic 8 Warnings 9 Notes Directly connect this pin to the receiver ground plane +5V dc power for the receiver section +5V dc power for the transmitter section TxGND Directly connect this pin to the transmitter ground plane Legal Notice LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Recommended Circuit Schematic C-13-155-T-Sxx3(-55)-G5 Tx Vcc C5 Rx Vcc 9 R1 8 7 6 5 4 3 2 1 R3 R9 R5 C6 R7 TD + RD + TD - RD - Tx Vcc SD Rx Vcc R2 R4 No internal connection Transceiver Top view No internal connection R10 R6 R8 L1 Notes +5V: R1=R3=R5=R7=R9=82� R2=R4=R6=R8=R10=130� C1=C2=C3=C5=C6=0.1�F C4=10�F L1=L2=1�H Vcc C3 Rx Vcc C1 L2 C4 Tx Vcc C2 The split-loaded terminations for ECL signals need to be located at the input of devices receiving those ECL signals. The power supply filtering is required for good EMI performance. Use short tracks from the inductor L1/L2 to the module Rx Vcc. / Tx Vcc. A GND plane under the module is required for good EMI and sensitivity performance. LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Package Diagram (10.4 mm SC transceiver assembly) LUMINENTOIC.COM Top View Front View Side View Rear View Units: mm 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Package Diagram (ST transceiver assembly) y Top View Front View Side View Rear View Top View Front View Units: mm Package Diagram (FC transceiver assembly) Rear View Side View LUMINENTOIC.COM Units: mm 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Ordering Information Available Options: C-13-155-T-SSC3-G5 C-13-155-T-SST3-G5 C-13-155-T-SFC3-G5 C-13-155-T-SSC3-55-G5 C-13-155-T-SST3-55-G5 C-13-155-T-SFC3-55-G5 Part numbering Definition: C - 13 - 155 - T - S SC TxPower Temperature and Package -xx -RoHS • 13 = Wavelength 1310nm • Communication protocol (155 Mbps) 155 = PECL Signal Detection Output • T = +5V Transceiver, FP • Single mode fiber • Connector options SC/ST/FC • Tx Power range 3= -15 to -8 dBm • Temperature range and package Blank = commercial temperature(0 to 70 ºC), 10.4 mm, Black case • -55 = lead soldered Blank = lead free solderd • Blank = RoHS non-compliant product G5 = RoHS compliant LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 8 LUMNDS1930-Aug0508 Rev A.0