155 Mbps Single Mode Transceiver C-13-155(C)-T3-SXX3(5) Features • Duplex SC Single Mode Transceiver • Industry Standard 1x9 Footprint • Intermediate Reach SONET OC-3 SDH STM-1 Compliant • Single 3.3V Power Supply • LVPECL Differential Inputs and Outputs • Wave Solderable and Aqueous Washable • LED Multisourced 1x9 Transceiver Interchangeable • Class 1 Laser Int. Safety Standard IEC 825 Compliant • Uncooled Laser Diode with MQW Structure • Complies with Telcordia (Bellcore) GR-468-CORE • Temperature Range: 0 to 70ºC • C-13-155(C)-T3-SSC3(5) black case 10.4 mm • SD LVPECL level C-13-155-T3-SXX3(5) • SD LVTTL level C-13-155C-T3-SXX3(5) • ATM 155 Mbps Links Application • SONET/SDH Equipment Interconnect Application Absolute Maximum Rating Parameter Symbol Min. Max. Unit Power Supply Voltage Vcc 0 3.6 V Output Current Iout 0 30 mA Soldering Temperature - - 260 ºC Operating Temperature Topr 0 70 ºC Storage Temperature Tstg -40 85 ºC Note 10 seconds on leads only Recommended Operating Condition Parameter Symbol Min. Typ. Max. Unit Power Supply Voltage Vcc 3.1 3.3 3.5 V Operating Temperature Topr 0 - 70 ºC - 155 - Mbps Data Rate Transmitter Specifications, (0<Topr<70ºC, 3.1V<VCC<3.5V) Parameter Symbol Min Typical Max Unit Notes Optical Transmit Power Po -15 - -8 dBm C-13-155(C)-T3-SXX3, output power is coupled into a 9/125 µm single mode fiber Optical Transmit Power Po -5 - 0 dBm C-13-155(C)-T3-SXX5, output power is coupled into a 9/125 µm single mode fiber Output Center Wavelength λ 1261 1310 1360 nm C-13-155(C)-T3-SXX3 Optical Output Center Wavelength λ 1263 1310 1360 nm C-13-155(C)-T3-SXX5 Output Spectrum Width Δλ - - 7.7 nm RMS(σ), C-13-155(C)-T3-SXX3 Output Spectrum Width Δλ 5 nm RMS(σ), C-13-155(C)-T3-SXX5 Extinction Ratio ER 8.2 - - dB C-13-155(C)-T3-SXX3 Extinction Ratio ER 10 - - dB C-13-155(C)-T3-SXX5 Output Pulse Mask Compliant with FDDI SMF-PMD1 Output Eye Optical Rise Time Optical Fall Time Compliant with ITU-T recommendation G.957 tr - - 2 ns 10% to 90% Values 10% to 90% Values tf - - 2 ns Relative Intensity Noise RIN - - -116 dB/Hz Total Jitter TJt - - 1.2 ns LUMINENTOIC.COM Measured with 223-1 PRBS with 72 ones and 72 zeros. 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS272-JAN2904 rev. 0 155 Mbps Single Mode Transceiver C-13-155(C)-T3-SXX3(5) Transmitter Specifications, (0<Topr<70ºC, 3.1V<VCC<3.5V) Parameter Symbol Min Typical Max Unit ICC - - 160 mA Data Input Current-Low IIL -350 - - µA Data Input Current-High IIH - - 350 µA Notes Electrical Power Supply Current Differential Input Voltage VIH-VIL 300 - - mV Data Input Voltage-Low VIL-VCC -2.0 - -1.58 V Data Input Voltage-High VIH-VCC -1.1 - -0.74 V Maximum current is specified at Vcc= Maximum @ maximum temperature These inputs are compatible with 10K, 10KH and 100K ECL and PECL inputs Receiver Specifications, (0<Topr<70ºC, 3.1V<VCC<3.5V) Parameter Symbol Min Typical Max Unit Notes Sensitivity - - - -34 dBm measured with 223-1 PRBS with 72 ones and 72 zeros. C-13-155-T3-SXX3 Sensitivity - - - -35 dBm measured with 223-1 PRBS with 72 ones and 72 zeros. C-13-155(C)-T3-SXX5 Maximum Input Power Pin -7 - - dBm C-13-155(C)-T3-SXX3 Maximum Input Power Pin 0 - - dBm C-13-155(C)-T3-SXX5 Signal Detect-Asserted Pa - - -34 dBm C-13-155(C)-T3-SXX3, Measured on transition: low to high Signal Detect-Asserted Pa - - -35 dBm Signal Detect-Deasserted Pd -47 - - dBm 1.0 - 4.0 dB 1100 - 1600 nm Optical Signal Detect-Hysteresis Wavelength of Operation C-13-155(C)-T3-SXX5, Measured on transition: low to high C-13-155-T3-SXX3(5) Measured on transition: high to low Receiver Specifications, (0<Topr<70ºC, 3.1V<VCC<3.5V) Parameter Symbol Min Typical Max Unit Notes ICC - - 100 mA The current excludes the output load current These outputs are compatible with 10K, 10KH and 100KECL and LVPECL outputs. Electrical Power Supply Current Data Output Voltage-Low VOL -Vcc -2 - -1.58 V Data Output Voltage-High VOH- Vcc -1.1 - -0.74 V Signal Detect Output Voltage-Low VSDL-Vcc -2 - -1.58 V Signal Detect Output Voltage-High VSDH- Vcc -1.1 - -0.74 V Signal Detect Output Voltage-Low VSDL - - 0.5 V Signal Detect Output Voltage-High VSDH 2.0 - - V LUMINENTOIC.COM C-13-155-T3-SXX3(5) LVPECL SD Output C-13-155(C)-T3-SXX3(5) LVTTL SD Output 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS272-JAN2904 rev. 0 155 Mbps Single Mode Transceiver C-13-155(C)-T3-SXX3(5) Connection Diagram 1. (Rx GND) 2. (RD +) 3. (RD-) 4. (SD) 5. (Rx Vcc) 6. (Tx Vcc) 7. (TD-) 8. (TD+) 9. (Tx GND) NC Top View NC Receiver Signal Ground Receiver Data Out Receiver Data Out Bar Signal Detect Receiver Power Supply Transmitter Power Supply Transmitter Data In Bar Transmitter Data in Transmitter Signal Ground PIN Symbol Notes 1 RxGND Directly connect this pin to the receiver ground plane 2 RD+ See recommended circuit schematic 3 RD- See recommended circuit schematic 4 SD Active high on this indicates a received optical signal 5 RxVcc +3.3V dc power for the receiver section 6 TxVcc +3.3V dc power for the transmitter section 7 TD- See recommended circuit schematic TD+ See recommended circuit schematic 8 Warnings 9 TxGND Directly connect this pin to the transmitter ground plane Legal Notice LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS272-JAN2904 rev. 0 155 Mbps Single Mode Transceiver C-13-155(C)-T3-SXX3(5) Recommended Circuit Schematic The split-loaded terminations for ECL signals need to be located at the input of devices receiving those ECL signals. The power supply filtering is required for good EMI performance. Use short tracks from the inductor L1/L2 to the module Rx Vcc. A GND plane under the module is required for good EMI and sensitivity performance. LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS272-JAN2904 rev. 0 155 Mbps Single Mode Transceiver C-13-155(C)-T3-SXX3(5) Package Diagram LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS272-JAN2904 rev. 0 155 Mbps Single Mode Transceiver C-13-155(C)-T3-SXX3(5) Package Diagram ST Transceiver Assembly Top View Front View Side View Rear View Qualification Information The 155 Mbps SM Transceiver has passed the following qualification tests and meets the intent of Telcordia (Bellcore) GR-468-CORE. Qualification Test Mechanical Shock Vibration Solderability Thermal Shock Temperature Cycling Damp Heat Cyclic Moisture Resistance ESD LUMINENTOIC.COM Condition Sample Size Reference 500 g 11 MIL-STD-883 20g, 20 Hz-2,000 Hz 11 MIL-STD-883D Method 2007 - 11 MIL-STD-883E Method 2003.7 25ºC 11 MIL-STD-883 Method 1011 500 cycles 11 MIL-STD-883 Method 1010 40ºC, 95% RH, 1344 hrs 11 MIL-STD-202 Method 103 10 cycles 11 MIL-STD-883 Method 1004 ± 500V 6 MIL-STD-883D Method 3015.7 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS272-JAN2904 rev. 0 155 Mbps Single Mode Transceiver C-13-155(C)-T(3)-SXX3(5) Ordering Information C -13 - 155(C) - T(3) - SXX 3(5) • Wavelength = 1310 nm • Communication protocol (155 Mbps) • +3.3V Transceiver • Single mode fiber • Connector options(SC/ST) • Intermediate Reach Warnings Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notice IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at Luminentʼs sole and absolute discretion. Luminent warrants performance of its products to current specifications only in accordance with the companyʼs standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and Luminent expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the companyʼs Terms and Conditions of Sale for further warranty information. Luminent assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and Luminent makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. Luminent customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify Luminent for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that Luminent is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact Luminent to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © Luminent, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS272-JAN2904 rev. 0