ES1A thru ES1M Super Fast Surface Mount Rectifiers Reverse Voltage 50 to 1000 Volts Forward Current 1.0 Ampere Features For surface mounted application Low profile package Built-in strain relief, Ideal for automated placement Easy pick and place Superfast recovery time for high efficiency Glass passivated chip junction High temperature soldering: 250oC/10 seconds at terminals Plastic material used carries Underwriters Laboratory Classification 94V-O Mechanical Data Cases: Molded plastic Terminals: Solder plated Polarity: Indicated by cathode band Weight: 0.002 ounce, 0.064 gram Maximum Ratings and Electrical Characteristics Ratings at 25oC ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20% Symbols ES 1A ES 1B ES 1C ES 1D ES 1F ES 1G Maximum repetitive peak reverse voltage VRRM 50 100 150 200 300 400 Maximum RMS voltage VRMS 35 70 105 140 210 280 Maximum DC blocking voltage V DC 50 100 150 200 300 400 600 Maximum average forward rectified current S ee F i g. 1 I(AV) 1.0 Amp Peak forward surge current, 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) IFSM 30.0 Amps Maximum instantaneous forward voltage @ 1.0A VF Parameter Maximum DC reverse current at rated DC blocking voltage @ TA=25oC @ TA=100oC trr Typical junction capacitance (Note 2) CJ Operating junction temperature range Storage temperature range Notes: ES 1K ES 1M 600 800 1000 Volts 420 560 700 Volts 800 1000 Volts 1.3 1.7 Units Volts 5.0 100 IR Maximum reverse recovery time (Note 1) Typical thermal resistance (Note 3) 0.95 ES 1J uA uA 35 10 nS 8 pF RθJA RθJL 85 35 TJ -55 to +150 o C -55 to +150 o C TSTG 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A 2. Measured at 1 MHz and Applied VR=4.0 Volts 3. P.C.B. Mounted on 0.2 x 0.2" (5.0 x 5.0mm) Copper Pad Area. 227 o C/W RATINGS AND CHARACTERISTIC CURVES 228