SMD 14 Pin 10 Tap TTL Compatible Active Delay Lines ELECTRONICS INC. EPA247-XX & EPA247-XX-RC Add “-RC” after part number for RoHS Compliant PCA Part Number EPA247-50(-RC) EPA247-60(-RC) EPA247-75(-RC) EPA247-100(-RC) EPA247-125(-RC) EPA247-150(-RC) EPA247-175(-RC) EPA247-200(-RC) EPA247-225(-RC) EPA247-250(-RC) EPA247-300(-RC) EPA247-350(-RC) EPA247-400(-RC) EPA247-420(-RC) Test Conditions Min. V CC = min. V IL = max. I OH = max 2.7 V CC = min. V IH = min. I OL = max V CC = min. II = II K V CC = max. VIN = 2.7V V CC = max. VIN = 5.25V IIL Low-Level Input Current V CC = max. VIN = 0.5V IOS Short Circuit Output Current V CC = max. V OUT = 0. -40 (One output at a time) ICCH High-Level Supply Current V CC = max. VIN = OPEN ICCL Low-Level Supply Current V CC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) Td > 500 nS NH Fanout High-Level Output V CC = max. V OH = 2.7V NL Fanout Low-Level Output V CC = max. V OL = 0.5V High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current Max. Unit 0.5 -1.2 50 1.0 -2 -100 V V V µA mA mA mA Recommended Operating Conditions Min. Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 4.75 2.0 Max. Unit 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 *These two values are inter-dependent. 14 VCC 13 3 12 4 11 5 10 OUTPUT 9 8 6 INPUT 1 7 GROUND J-Lead Package PCA EPA247-XX Date Code .055 (1.40) Suggested Solder Pad Layout .280 Max. (7.11) .310 (7.87) .030 (.762) .100 (2.54) .780 Max. (17.81) .025/.045 (.635/1.14) .275 Max. (6.99) .020 (.508) 440 450 470 500 550 600 650 700 750 800 850 900 950 1000 Schematic 150 mA 150 mA 4 nS 5 nS 20 TTL Load 10 TTL Load .300 Max. (7.62) VCC VIH VIL IIK IOH IOL PW* d* TA Total Delay (†±5% or ± 2nS) Tap Delays PCA (†±5% or ± 2nS) Part Number 5 50 EPA247-440(-RC) 44 6 60 EPA247-450(-RC) 45 7.5 75 EPA247-470(-RC) 47 10 100 EPA247-500(-RC) 50 12.5 125 EPA247-550(-RC) 55 15 150 EPA247-600(-RC) 60 17.5 175 EPA247-650(-RC) 65 20 200 EPA247-700(-RC) 70 22.5 225 EPA247-750(-RC) 75 25 250 EPA247-800(-RC) 80 30 300 EPA247-850(-RC) 85 35 350 EPA247-900(-RC) 90 40 400 EPA247-950(-RC) 95 42 420 EPA247-1000(-RC) 100 †Whichever is greater. Delay times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter VOH VOL VIK IIH Total Delay (†±5% or ± 2nS) Tap Delays (†±5% or ± 2nS) .100 (2.54) Notes : 1. Assembly Process (Solder Composition) .300 (7.62) (Leadframe) (Assembly Solder) EPA247-XX SnPb EPA247-XX-RC Sn SnPb SnPb (RoHS exemption 7a) 2. Peak Solder Rating Input Pulse Test Conditions @ 25° C EIN PW TRI PRR Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS VCC Supply Voltage Unit 3.2 110 2.0 1.0 100 5.0 Volts % nS MHz KHz Volts 225°C 260°C (per IPC/JEDEC-J-STD-020C) 3. Moisture Sensitive Levels (MSL) (per IPC/JEDEC-J-STD-020C) 4. Weight 5. Packaging Information (*Add “TR” to end of part number when placing order) (Tube) 3 4 (168 hours, ≤30°C/60%RH) (72 hours, ≤30°C/60%RH) TBD grams TBD grams 27 pieces/tube 27 pieces/tube (Tape & Reel) TBD pieces/13” reel (*EPA245-XX-TR) TBD pieces/13” reel (*EPA245-XX-RCTR) Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CSA247 & -RC Rev. A1 12/5/05 RR TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com