Red Lion CCARPG00 Model zlz - linear cable encoder Datasheet

Bulletin No. ZLZ-B
Drawing No. LP0734
Released 08/13
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
MODEL ZLZ - LINEAR CABLE ENCODER
(Replaces MODEL LES)
 LOW COST LINEAR SOLUTION
 50 OR 500 PULSES PER INCH
 STAINLESS STEEL CABLE
 0 TO 50 INCHES OF CABLE MEASUREMENT
 VARIOUS CABLE ASSEMBLIES AVAILABLE
DESCRIPTION
SPECIFICATIONS
The Linear Cable Encoder can provide an accurate, yet low cost solution for
Linear Measurement applications. Common applications include robotics,
extrusion presses, valve positioning, textile machinery, and gate control
positioning, just to name a few. The ZLZ has some unique advantages over
other sensing solutions. Using a stainless steel cable, perfect parallel alignment
is no longer required and with a 50 inch cable reach, it can easily be mounted
away from harsh environments. The ZLZ is available in a quadrature output,
allowing the sensor to operate in positioning applications.
Additional cable exit configurations, pulses per inch, and mating connectors
are available on special request. Contact the factory for details.
ELECTRICAL SPECIFICATIONS
1. INPUT VOLTAGE: 4.75 to 28 VDC
2. INPUT CURRENT: 80 mA maximum with no output load
3. INPUT RIPPLE: 100 mV peak-to-peak at 0 to 100 KHz
4. OUTPUT: NPN open collector; 250 mA max per channel; Incremental square wave with channel A leading B during linear extension.
5. INDEX: Once per 5" cable extension or retraction
6. MAX FREQUENCY: 0 to 125 KHz
7. SYMMETRY: 180° (±18°) electrical
8. QUAD PHASING: 90° (±22.5°) electrical
9. RISE TIME: Less than 1 µsec
Open Collector Output Wiring
MECHANICAL SPECIFICATIONS
The ZLZ sensors have open collector outputs. An open collector output
brings the uncommitted collector of the encoder switching device to the external
world. Because the collector element is not associated with the sensor supply
voltage, the sensor output collector may be “pulled up” to external voltages (40
VDC max.) different than the encoder supply voltage . NPN open collector
outputs are current sinking devices. An output signal will not be generated
unless a pull-up resistor is connected from the open-collector to the positive side
of an external supply. The same supply can be used for powering the unit and
for the pull-up resistor.
1. FULL STROKE LENGTH (FSL): 50" standard.
2. FINISH: Black powder coated aluminum
3. ACCURACY: ±0.10% FSL
4. REPEATABILITY: ±0.015% FSL
5. LINEAR RESOLUTION: Up to 500 cycles per inch (0.002" per cycle)
6. CABLE MATERIAL: 0.034" nylon coated stainless steel rope
7. CABLE TENSION: 20 oz maximum typical
8. LIFE (CYCLES): 1,000,000 predicted at zero angle cable exit
9. CONNECTOR TYPE: 6-Pin MS type connector
10. WEIGHT: 19 oz (538.64 g)
ENVIRONMENTAL SPECIFICATIONS
1. OPERATING TEMPERATURE: 0 °C to 85 °C
2. SEALING: IP65 standard
DIMENSIONS In inches (mm)
MOUNTING BRACKET
ZLZ
3.50 (88.9)
Ø0.20 (Ø5.08) THRU
0.25
(6.35)
3.00 (76.2)
4.32±0.05
0.625
(15.875)
Ø0.69 (109.73±1.27)
(Ø17.53)
0.13
(3.30)
1.50
(38.1)
2.25
(57.15)
2.74 (69.6)
3.81 (96.8)
Ø0.21 (Ø5.33) THRU 4x
2.25 (57.15)
6-32 x 0.312 (7.92) DEEP
4 PLS ON Ø2.00 (Ø50.8) B.C.
1
2.25
(57.15)
ORDERING INFORMATION
ZLZ ELECTRICAL CONNECTIONS
CABLE & CONNECTOR ASSY
(ORDER SEPARATELY)
LED'S
+VDC
ZLZ
DUAL
CHANNEL
DESCRIPTION
PART NUMBER
Quadrature output, 50 PPI, Standard Housing
ZLZ0050G
Quadrature output, 500 PPI, Standard Housing
ZLZ0500G
DATA A
DATA B
PULSE
SHAPING
AMP.
ACCESSORIES
SHAFT
SLOTTED
DISC
MODEL NO.
COMMON
MODEL NO.
PHOTO XISTOR'S
ZLZ WIRING SPECIFICATIONS
DESCRIPTION
PART NUMBER
ZLZ Mounting Bracket
LEMTBR00
Mating 6-Pin MS Connector
CCARPG00
10' 6-Pin 4-Wire Cable/Connector
CCARPG01
FUNCTION
LE PIN
CCARPG WIRE COLOR
25' 6-Pin 4-Wire Cable/Connector
CCARPG25
+VDC
A
RED
50' 6-Pin 4-Wire Cable/Connector
CCARPG50
COMMON
B
BLACK
DATA A
C
WHITE
DATA B
D
GREEN
NO CONNECTION
E
CCARPG
LIMITED WARRANTY
The Company warrants the products it manufactures against defects in materials and workmanship
for a period limited to two years from the date of shipment, provided the products have been stored,
handled, installed, and used under proper conditions. The Company’s liability under this limited
warranty shall extend only to the repair or replacement of a defective product, at The Company’s
option. The Company disclaims all liability for any affirmation, promise or representation with
respect to the products.
The customer agrees to hold Red Lion Controls harmless from, defend, and indemnify RLC against
damages, claims, and expenses arising out of subsequent sales of RLC products or products
containing components manufactured by RLC and based upon personal injuries, deaths, property
damage, lost profits, and other matters which Buyer, its employees, or sub-contractors are or may be
to any extent liable, including without limitation penalties imposed by the Consumer Product Safety
Act (P.L. 92-573) and liability imposed upon any person pursuant to the Magnuson-Moss Warranty
Act (P.L. 93-637), as now in effect or as amended hereafter.
No warranties expressed or implied are created with respect to The Company’s products except
those expressly contained herein. The Customer acknowledges the disclaimers and limitations
contained herein and relies on no other warranties or affirmations.
Red Lion Controls
Headquarters
20 Willow Springs Circle
York PA 17406
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
Red Lion Controls
Europe
Softwareweg 9
NL - 3821 BN Amersfoort
Tel +31 (0) 334 723 225
Fax +31 (0) 334 893 793
Red Lion Controls
India
201-B, 2nd Floor, Park Centra
Opp 32 Mile Stone, Sector-30
Gurgaon-122002 Haryana, India
Tel +91 984 487 0503
Red Lion Controls
China
Unit 302, XinAn Plaza
Building 13, No.99 Tianzhou Road
ShangHai, P.R. China 200223
Tel +86 21 6113 3688
Fax +86 21 6113 3683
Similar pages