Embedded Solutions Power Supplies ADLPS35-150, 150W 2”x4” ATX Power Supply Features Small 2”x4” (50mm x 102mm) Footprint Voltage and Current Specifications (common all variants): Maximum Input Current = 15A Maximum Power = 150W Combined Available Output Current: 5VS/5A, 5V/20A, 3.3V/5A, 12V/10A Input Protection: Overcurrent Overvoltage / Undervoltage / Surge Reverse Voltage Output Protection: Voltage Out of Range (monitored via PWRGD) Short-circuit ATX Compliant Signals Available (PS-ON, PWRGD etc.) Chassis and PC/104 Mounting Plates Optional Two Variants Available: ADLPS35-150-5: Input: 7-36V, Output: 5V, 5VS, 3.3V ADLPS35-150-12: Input: 14-36V, Output: 5V, 5VS, 3.3V, 12V Temperature Range: -40C to +85C Minimal Cooling Required: Chassis Heatspreader or PC/104 Mounting Plate Provide Sufficient Cooling for –40C to +85C Operation Ordering Information Description Item Code Part # Description ADLPS35-150-5 293023 ADLPS35-150-5, 5V, 5VS, 3.3V, ET ADLPS35-150-12 293024 ADLPS35-150-12, 5V, 5VS, 12V, 3,3V, ET *input connector included. Accessories ADLPS35-150-104MT 293029 ADLPS35-150 PC/104 mounting plate with hardware kit ADLPC35-150-HSP 293027 ADLPS35-150 Heat spreader for chassis mount with hardware kit ADLPS35CB-XPWR-5 100-9870 ADLPS35-150, 16P to 10P uFit conn, 5V ATX Power Cable ADLPS35CB-XPWR-12 100-9871 ADLPS35-150, 16P to 10P uFit conn, 5V/12V ATX Power Cable MILCOTS-FILTER 293031 MIL-STD 704/1275/461 Input Filter; 120w max. The ADLPS35-150 power supply board is designed to meet the needs of industrial and embedded motherboards by providing robust ATX voltages (5V, 5VS, 3.3V, 12V) in a small form factor power supply designed for -40C to +85C operation. Its small 2”x4” size (50mm x 102mm) allows it to fit many space limited applications. As well, the ADLPS35-150 is tailored to sit side-by -side with our 3.5-inch product line of motherboards and can also be adapted to a PC/104 stack via an optional mounting plate. The power supply features ATX compliant signaling to allow ACPI/APM power management from within compliant operating systems. At 150 Watts total power and just 50mm x 102mm in size, this small and rugged power supply will fit into most embedded applications. The ADLPS35-150 is available in two variants, one allowing an input voltage range of 7-36V but providing only the 5V, 5VS, and 3.3V outputs, the other with a narrower input voltage range of 14-36V but providing 5V, 5VS, 3.3V and 12V outputs. The board is protected against many types of input power anomalies, such as over-currents, voltage deviations and voltage surge. Short bursts of over-current are simply filtered out. Should overvoltage or under voltage situation persist too long, the power supply shuts off. Noise interference is dampened by up to 35dB. The output is protected against reverse voltage and short-circuit. Data subject to change without notice. ADL Embedded Solutions GmbH, Eiserfelder Straße 316 D-57080 Siegen, Germany P. +49 (0) 271 250 810 0 F. +49 (0) 271 250 810 20 e-mail: [email protected]; web: www.adl-europe.com ADL Embedded Solutions, Inc. 4411 Morena Blvd., Suite 101 San Diego, CA 92117-4345 P. +1 858 490-0597 F. +1 858 490-0599 e-mail: [email protected]; web: www.adl-usa.com Embedded Solutions Power Supplies ADLPS35-150, 150W 2”x4” ATX Power Supply P400 - Power Output P401 - Power Input Description Signal Pin Pin Signal Description Description Signal 5 Volts DC 5 Volts DC Ground Ground 12 Volts DC VCC VCC GND GND 12V 1 2 3 4 5 9 10 11 12 13 VCC VCC GND GND 12V 5 Volts DC 5 Volts DC Ground Ground 12 Volts DC Not Connected NC 1 Not Connected NC 2 Not Connected NC 3 Standby 5 Volts DC SVCC 6 14 PWRBTN# ATX Power Button Shield Ground Power Ground DC Power In S_GND P_GND P_Vin 4 5 6 ATX Power Good PWRBTN# 7 7 15 PS_ON ATX Control Line ATX Power Button ATX_PWRGD 3.3 Volts DC 3.3V 8 16 3.3V 3.3 Volts DC Power Status 1A Fused DC Out** PWRSTAT 8 Pin **This pin will output 12V or 5V at 1A (fused) depending on whether the power supply is 5V only output. Data subject to change without notice. ADL Embedded Solutions GmbH, Eiserfelder Straße 316 D-57080 Siegen, Germany P. +49 (0) 271 250 810 0 F. +49 (0) 271 250 810 20 e-mail: [email protected]; web: www.adl-europe.com ADL Embedded Solutions, Inc. 4411 Morena Blvd., Suite 101 San Diego, CA 92117-4345 P. +1 858 490-0597 F. +1 858 490-0599 e-mail: [email protected]; web: www.adl-usa.com