AM-119 / AMC-119
High Performance Amplifier,
8 dB Gain, 30 - 250 MHz
Rev. V4
Features
TO-8-1
2.3 dB Typical Midband Noise Figure
+23 dBm Typical Midband Output Power
+40 dBm Typical Midband Third Order Intercept
Description
M/A-COM’s AM-119 is a coupler feedback amplifier
with high intercept and compression points. The use
of coupler feedback minimizes noise figure and
current in a high intercept amplifier. This amplifier is
packaged in a TO-8 package. Due to the internal
power dissipation the thermal rise minimized. The
ground plane on the PC board should be configured
to remove heat from under the package. AM-119 is
ideally suited for use where a high intercept, high
reliability amplifier is required.
Ordering Information
Part Number
AM-119 PIN
4
AMC-119 SMA
Package
TO-8-1
Connectorized
4. Mounting kit part number AU00071 required for PCB
applications.
Outline Drawing: SMA Connectorized *
Absolute Maximum Ratings 1
Parameter
Absolute Maximum
Max. Input Power
+13 dBm
Vbias
+15.75 V
Operating Temperature
-55°C to +85°C
Storage Temperature
-65°C to +125°C
1. Operation of this device above any one of these parameters
may cause permanent damage.
Dimensions are inches (millimeters) ±0.015 (0.38) unless otherwise specified.
1
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
AM-119 / AMC-119
High Performance Amplifier,
8 dB Gain, 30 - 250 MHz
Electrical Specifications:
Parameter
2, 3
Rev. V4
TA = -55°C to +85°C Case Temperature
Test Conditions
o
Frequency
Units
Min.
Typ.
Max.
Gain
@+25 C
250 MHz
dB
7.5
8.0
8.5
Frequency Response
—
30 - 250 MHz
dB
—
—
±0.75
Gain Variation with
Temperature
—
30 - 250 MHz
dB
—
—
±1.0
1 dB Compression
Output Power
30 - 250 MHz
dBm
+20
—
—
Noise Figure
—
30 - 250 MHz
dB
—
—
3.5
Reverse Transmission
—
30 - 250 MHz
dB
—
-11.0
-9.5
VSWR
—
30 - 250 MHz
Ratio
—
—
2.3:1
Output IP2
Two-Tone inputs up to +10 dBm
30 - 250 MHz
dBm
+39
—
—
Output IP3
Two-Tone inputs up to +10 dBm
30 - 250 MHz
dBm
+34
—
—
Vbias
—
—
VDC
+14.5
+15.0
+15.5
Ibias
Vbias = +15.0 VDC
—
mA
—
50
60
Power Dissipation
@ +15 V Bias
—
mW
—
750
—
2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance.
3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 1W must be provided
in use.
2
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
AM-119 / AMC-119
High Performance Amplifier,
8 dB Gain, 30 - 250 MHz
Rev. V4
Typical Performance Curves
3
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
AM-119 / AMC-119
High Performance Amplifier,
8 dB Gain, 30 - 250 MHz
Rev. V4
M/A-COM Technology Solutions Inc. All rights reserved.
Information in this document is provided in connection with M/A-COM Technology Solutions Inc ("MACOM")
products. These materials are provided by MACOM as a service to its customers and may be used for
informational purposes only. Except as provided in MACOM's Terms and Conditions of Sale for such products or
in any separate agreement related to this document, MACOM assumes no liability whatsoever. MACOM
assumes no responsibility for errors or omissions in these materials. MACOM may make changes to
specifications and product descriptions at any time, without notice. MACOM makes no commitment to update
the information and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future
changes to its specifications and product descriptions. No license, express or implied, by estoppels or otherwise,
to any intellectual property rights is granted by this document.
THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR
IMPLIED, RELATING TO SALE AND/OR USE OF MACOM PRODUCTS INCLUDING LIABILITY OR
WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, CONSEQUENTIAL OR
INCIDENTAL DAMAGES, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR
OTHER INTELLECTUAL PROPERTY RIGHT. MACOM FURTHER DOES NOT WARRANT THE ACCURACY
OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN
THESE MATERIALS. MACOM SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR LOST PROFITS,
WHICH MAY RESULT FROM THE USE OF THESE MATERIALS.
4
MACOM products are not intended for use in medical, lifesaving or life sustaining applications. MACOM
customers using or selling MACOM products for use in such applications do so at their own risk and agree to
fully indemnify MACOM for any damages resulting from such improper use or sale.
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support