UNISONIC TECHNOLOGIES CO., LTD DTA115T PNP SILICON TRANSISTOR DIGITAL TRANSISTORS (BUILT- IN BIAS RESISTORS) FEATURES * Built-in bias resistors that implies easy ON/OFF applications. * The bias resistors are thin-film resistors with complete isolation to allow positive input. EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number Package DTA115TG-AE3-R Note: Pin Assignment: E: Emitter B: Base C: Collector SOT-23 1 E Pin Assignment 2 3 B C Packing Tape Reel MARKING www.unisonic.com.tw Copyright © 2015 Unisonic Technologies Co., Ltd 1 of 3 QW-R206-062.C DTA115T PNP SILICON TRANSISTOR ABSOLUTE MAXIMUM RATINGS (TA=25°C, unless otherwise specified) PARAMETER SYMBOL RATING UNIT Collector-Base Voltage VCBO -50 V Collector-Emitter Voltage VCEO -50 V Emitter-Base Voltage VEBO -5 V Collector Current IC -100 mA Collector Power Dissipation PC 200 mW Junction Temperature TJ +150 ℃ Storage Temperature TSTG -55~+150 ℃ Note Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL SPECIFICATIONS (TA=25°C, unless otherwise specified) PARAMETER SYMBOL Collector-Base Breakdown Voltage BVCBO Collector-Emitter Breakdown Voltage BVCEO Emitter-Base Breakdown Voltage BVEBO Collector-Emitter Saturation Voltage VCE(SAT) Collector Cutoff Current ICBO Emitter Cutoff Current IEBO DC Current Gain hFE Input Resistance R1 Transition Frequency fT Note: Transition frequency of the device TEST CONDITIONS IC=-50μA IC=-1mA IE=-50μA IC=-1mA, IB=-0.1mA VCB=-50V VEB=-4V VCE=-5V, IC=-1mA VCE=-10V, IE=5mA,f=100MHz (Note) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN -50 -50 -5 TYP 100 70 250 100 250 MAX UNIT V V V -0.3 V -0.5 μA -0.5 μA 600 130 kΩ MHz 2 of 3 QW-R206-062.C DTA115T PNP SILICON TRANSISTOR UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R206-062.C