February 15, 2007 SHIELDED SMD INDUCTOR DR357-2 SERIES Features z z z z z Low Profile Surface Mount Design Flat Top for Pick and Place Inductance Range from 10.0µH to 150.0µH Operating Temp. -30°C to +80°C Tinned Leads with Leaded Solder is Available (note 7) ELECTRICAL SPECIFICATIONS AT 25ºC Part No. DR357-2-103 DR357-2-123 DR357-2-153 DR357-2-183 DR357-2-223 DR357-2-273 DR357-2-333 DR357-2-393 DR357-2-473 DR357-2-563 DR357-2-683 DR357-2-823 DR357-2-104 DR357-2-124 DR357-2-154 Inductance (µH) ± 30% 10.0 12.0 15.0 18.0 22.0 27.0 33.0 39.0 47.0 56.0 68.0 82.0 100.0 120.0 150.0 DCR (Ω) Max. 0.058 0.072 0.087 0.116 0.145 0.176 0.213 0.269 0.299 0.336 0.451 0.514 0.700 0.765 0.876 I rated (A) Max. 2.70 2.25 2.22 1.90 1.78 1.63 1.16 1.32 1.18 1.10 1.04 0.94 0.84 0.76 0.70 MECHANICAL OUTLINES Notes: 1. All dimensions are shown in millimeter “mm” 2. General tolerance ±0.2mm, unless other specified 3. Inductance Test: 100kHz, 0.1Vrms 4. Irated for an approximate 40°C temperature rise 5. Irated for an approximate 35% drop maximum of the initial value 6. Tape and reel quantity, 1000 pcs/reel 7. For non-RoHS parts replace DR prefix with 42- (e.g. DR357-2 becomes 42-357-2) 8. Terminal finish is compliant to RoHS requirements. Solder in accordance with J-STD-020C DATATRONIC: 28151 Highway 74, Romoland, CA 92585 Tel: 951-928-7700 Toll Free Tel: 888-889-5391 Fax: 951-928-7701 Email: [email protected] 499 King’s Road, Hong KongTel: (852) 2562 3858, (852) 2564 8477 Fax: (852) 2565 7214, (852) 2563 1290 All specifications are subject to change without notice.