November 3, 2011 SMD INDUCTOR DR336 SERIES Features Low Profile Surface Mount Design Flat Top for Pick and Place Inductance Range from 10µH to 1000µH Operating Temp. -20°C to +80°C Tinned Leads with Leaded Solder is Available (note 6) ELECTRICAL SPECIFICATIONS AT 25ºC PART No. INDUCTANCE (H) 10 20% 12 20% 15 20% 18 20% 22 20% 27 20% 33 20% 39 20% 47 20% 56 20% 68 10% 82 10% 100 10% 120 10% 150 10% 180 10% 220 10% 270 10% 330 10% DR336-103 DR336-123 DR336-153 DR336-183 DR336-223 DR336-273 DR336-333 DR336-393 DR336-473 DR336-563 DR336-683 DR336-823 DR336-104 DR336-124 DR336-154 DR336-184 DR336-224 DR336-274 DR336-334 @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 2.52MHz @ 1kHz @ 1kHz @ 1kHz @ 1kHz @ 1kHz @ 1kHz @ 1kHz DCR () Max. 0.08 0.09 0.10 0.11 0.13 0.17 0.18 0.22 0.25 0.28 0.33 0.45 0.48 0.54 0.75 1.02 1.20 1.31 1.50 RATED CURRENT (A) Max. 1.44 1.39 1.24 1.12 1.07 0.94 0.85 0.74 0.68 0.64 0.59 0.54 0.51 0.49 0.40 0.36 0.31 0.29 0.28 MECHANICAL OUTLINES 7.80±0.3 [0.307] 7.00±0.3 [0.276] 8.00 [0.315] 3.50 [0.138] 2.00 [0.078] XXX 1 7.50 [0.295] 2 TOP VIEW SIDE VIEW BOTTOM VIEW PCB SOLDER PAD LAYOUT (REF.) SCHEMATIC NOTES: 1. All dimensions are shown in millimeters “mm” [inches “in”]. 2. General tolerance 0.25mm [0.010 IN.], unless otherwise specified. 3. Tape and reel quantity, 1000 pcs/reel. 4. Terminal finish is compliant to RoHS requirements 5. Solder in accordance with J-STD-002 Rev. D 6. Non-RoHS series parts 42-336-XXX are finished with leaded solder Sn60Pb40 or equivalent DATATRONIC: 28151Highway 74, Romoland, CA 92585 Tel: 951-928-7700 Fax: 951-928-7701 Email: [email protected] 499 King’s Road, Hong KongTel: (852) 2562 3858, (852) 2564 8477 Fax: (852) 2565 7214, (852) 2563 1290 All specifications are subject to change without notice.