AWS5506 GaAs IC SPDT Reflective Switch Positive Control DC - 2.5 GHz Data Sheet - Rev 2.1 FEATURES • • • • • Low Insertion Loss (0.4 dB @ 0.9 GHz) Complementary Positive Control Voltages (0/ +3V to 0/+5V) Positive Voltage Supply (+3 to +5 V) Low DC Power Consumption Ultra Miniature 6 Lead SOT-6 Package APPLICATIONS • S14 SOT-6 6 Pin Plastic Package Typical applications include: selection of synthesizers, filters, amplifiers in dual mode, and dual band handsets. DESCRIPTION The AWS5506 is a Single Pole Double Throw GaAs MMIC switch assembled in a SOT-6 plastic package. The AWS5506 is designed for analog and digital application that require for insertion loss, small size, and low cost. State selection is achieved with a complimentary positive voltage (requires positive bias Vs, and blocking caps) or negative voltage (no Vs or blocking caps required). Table 1: Pin Description C1 V1 5 4 C2 3 RF2 (J3) 2 GND 6 1 RF1 (J2) V2 RFCOM (J1) C4 10KΩ Vs DC blocking capacitors (C1, 2, 4) and biasing resistor (R1) must be supplied externally for positive voltage operation. C1, 2, 4 = 100 pF for operation >500 MHz. Figure 1: Pin Out Diagram PIN NAME 1 RF 1 (J2) 2 GND 3 RF2 (J3) 4 V2 5 RF COM (J1)/Vs 6 V1 08/2001 DESCRIPTION RF port (can be used as an input and as an output) Ground connection (keep as short as possible) RF port (can be used as an input or as an output) Control voltage 2 (low 0V, High 3V to 5V) RF common port and bias voltage for positive control (3V to 5V) Control voltage 1 (low 0V, High 3V to 5V) AWS5506 ELECTRICAL CHARACTERISTICS Table 2: Absolute Minimum and Maximum Ranges PARAMETER MIN MAX UNIT - 2 W Control Voltage -0.2 +8 V Operating Temperature -40 +125 °C Storage Temperature -50 +150 °C - 25 ° C/W RF Input Power > 500 MHz, 0/+7 V Control Θ JC Stresses in excess of the absolute ratings may cause permanent damage. Functional operation is not implied under these conditions. Exposure to absolute ratings for extended periods of time may adversely affect reliability. (8 pt bold) Table 3: Operating Ranges at 25° C (0, +3V) PARAMETER CONDITION FREQUENCY MIN TYP MAX UNIT Switching Characteritics 5 Rise, Fall (10/90% or 90/10% RF) On, Off (50% CTL to 90%/10% RF) Video Feedthru - - 10 20 25 - ns ns mV Intermodulation Intercept Point (IP3) For Two-tone Input Power +10 dBm 0.5 - 2.0 GHz - +45 - dBm Input Power for 1dB Compression @ +3V @ +5V 0.5 - 2.0 GHz 0.5 - 2.0 GHz - +21 +28 - dBm Control Voltage V LOW = 0 to 0.2 V @ 20 uA Max V HIGH = +3 V @ 100 uA Max to +5 V @ 200 uA Max V S = VHIGH + 0.2V The device may be operated safely over these conditions; however, parametric performance is guaranteed only over the conditions defined in the electrical specifications. Notes: 1. All measurements made in a 50 ohm system, unless otherwise specified. 2. DC = 300 kHz. 3. Insertion loss changes by 0.003 dB/°C. 4. Insertion loss state. 5. Video feedthru measured with 1 ns rise time pulse and 500 MHz bandwidth. 2 Data Sheet - Rev 2.1 08/2001 AWS5506 Table 4: Electrical Specifications at 25 °C (0, +3V) 1 PARAMETER Insertion Loss FREQUENCY 2 MIN TYP MAX UNIT DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz DC - 2.5 GHz - 0.4 0.45 0.6 0.9 0.5 0.6 0.8 1.1 dB dB dB dB DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz DC - 2.5 GHz 22 17 11 10 25 20 14 13 - dB dB dB dB DC - 1.0 GHz DC - 2.5 GHz - 1.2:1 1.5:1 1.3:1 1.7:1 - 3 Isolation VSWR 4 Table 5: Truth Table Positive Operation V1 V2 J1 - J2 J1 - J3 VHigh 0 Insertion Isolation 0 VHigh Isolation Insertion VHigh = +3 to +5 V (VS = VHigh + 0.2 V) Data Sheet - Rev 2.1 08/2001 3 AWS5506 Figure 2: Test Circuit Schematic 4 Data Sheet - Rev 2.1 08/2001 AWS5506 PACKAGE OUTLINE θ SYMBOLS A A1 A2 b C D E e H L θ1 DIMENSIONS IN MILLIMETERS MIN 1.00 0.00 0.70 0.35 0.10 2.70 1.40 2.60 0.37 1° NOM 1.10 −−− 0.80 0.40 0.15 2.90 1.60 1.90(TYP) 2.80 −−− 5° MAX 1.30 0.10 0.90 0.50 0.25 3.10 1.80 3.00 −−− 9° DIMENSIONS IN INCHES MIN 0.039 0.00 0.027 0.014 0.004 0.106 0.055 NOM 0.043 −−− 0.031 0.016 0.006 0.114 0.063 0.075(TYP) 0.102 0.110 0.015 −−− 1° 5° MAX 0.051 0.004 0.035 0.020 0.010 0.122 0.071 0.118 −−− 9° NOTES: 1. Package body sizes exclude mold flash and gate burrs. 2. Dimension L is measured in gage plane 3. Coplanarity: 0.1000 mm 4. Tolerance + 0.1000 mm (4 mil) unless otherwise specified. Figure 3: Package Outline Data Sheet - Rev 2.1 08/2001 5 AWS5506 NOTES 6 Data Sheet - Rev 2.1 08/2001 AWS5506 NOTES Data Sheet - Rev 2.1 08/2001 7 AWS5506 ORDERING INFORMATION ORDER NUMBER PACKAGE DESCRIPTION AWS5506S14 S14 COMPONENT PACKAGING 6 Pin Plastic Package ANADIGICS, Inc. 35 Technology Drive Warren, New Jersey 07059 Tel: (908) 668-5000 Fax: (908) 668-5132 http://www.anadigics.com [email protected] IMPORTANT NOTICE ANADIGICS, Inc. reserves the right to make changes to its products or to discontinue any product at any time without notice. The product specifications contained in Advanced Product Information sheets and Preliminary Data Sheets are subject to change prior to a product’s formal introduction. Information in Data Sheets have been carefully checked and are assumed to be reliable; however, ANADIGICS assumes no responsibilities for inaccuracies. ANADIGICS strongly urges customers to verify that the information they are using is current before placing orders. WARNING ANADIGICS products are not intended for use in life support appliances, devices, or systems. Use of an ANADIGICS product in any such application without written consent is prohibited. 8 Data Sheet - Rev 2.1 08/2001