Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 2A FAST EFFICIENT RECTIFIER FE20-005-LFR THRU FE20-08-LFR FEATURES z LOW POWER LOSS, HIGH EFFICIENCY z LOW LEAKAGE z LOW FORWARD VOLTAGE DROP z HIGH CURRENT CAPABILITY z HIGH SPEED SWITCHING z HIGH RELIABILITY z HIGH CURRENT SURGE z GLASS PASSIVATED CHIP JUNCTION z ROSH 1.0(25.4) MIN .034(0.9) .028(0.7) .300(7.6) .230(5.8) .140(3.6) .104(2.6) MECHANICAL DATA z CASE: MOLDED PLASTIC, DO15, DIMENSIONS IN INCHES AND (MILLIMETERS) z EPOXY: UL 94V-0 RATE FLAME RETARDANT z LEAD: MIL-STD-202E METHOD 208C GUARANTEED z MOUNTING POSITION: ANY z WEIGHT: 0.4 GRAMS 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% FE20 FE20 FE20 FE20 FE20 FE20 FE20 FE20 FE20 -08 UNITS -06 -05 -04 -03 -02 -015 -01 RATINGS SYMBOL -005 -LFR -LFR -LFR -LFR -LFR -LFR -LFR -LFR -LFR MAXIMUM RECURRENT PEAK REVERSE VOLTAGE VRRM 50 100 150 200 300 400 500 600 800 V MAXIMUM RMS VOLTAGE VRMS 35 70 105 140 210 280 350 420 560 V MAXIMUM DC BLOCKING VOLTAGE VDC 50 100 150 200 300 400 500 600 800 V MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT IO 2.0 A 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF IFSM 50 A SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) CJ 70 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθja 40 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS MAXIMUM FORWARD VOLTAGE AT IO DC FE20 SYMBOL -005 -LFR VF FE20 FE20 -015 -01 -LFR -LFR 0.98 FE20 -02 -LFR FE20 FE20 -04 -03 -LFR -LFR 1.25 FE20 FE20 -06 -05 -LFR -LFR 1.85 FE20 -08 UNITS -LFR 2.60 V MAXIMUM REVERSE CURRENT AT 25℃ IR 10 μA MAXIMUM REVERSE CURRENT AT 100℃ IR 50 μA 25 nS MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. BOTH LEADS ATTACHED TO HEAT SINK 20×20×1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A FE20-005-LFR THRU FE20-08-LFR Page: 1 RATINGS AND CHARACTERISTIC CURVE FE20-005-LFR THRU FE20-08-LFR FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 100Ω NO INDUCTIVE 50Ω NO INDUCTIVE FIG. 2-TYPICAL FORWARD CURRENT DERATING CURVE Trr +0.5A AVERAGE FORWARD CURRENT (A) (-) D.U.T. 0 PULSE GENERATOR ( NOTE 2 ) (+) 25 Vdc (approx) 1Ω NON INDUCTIVE (-) OSCILLOSCOPE ( NOTE 1 ) -0.25A (+) -1.0A 1cm NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS FIG. 4-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS INSTANTANEOUS FORWARD CURRENT (A) 1000 10 TJ=80oC 1 0.1 o TJ=25 C .01 20 40 10.0 FE20-005-LF~20-02-LF .1 .01 FE20-06-LF .001 .4 60 80 100 120 140 .6 .8 1.0 1.2 1.4 1.6 1.8 2.0 INSTANTANEOUS FORWARD VOLTAGE (V) FIG. 6-TYPICAL JUNCTION CAPACITANCE FIG. 5-MAXIMUN NON-REPETITIVE FORWARD SURGE CURRENT 200 70 50 40 30 20 10 100 JUNCTION CAPACITANCE (pF) 8.3 ms Single Half Sine Wave (JEDEC Method) 60 FE20-03-LF~20-04-LF 1.0 PERCENT OF RATED PEAK REVERSE VOLTAGE (%) PEAK FORWARD SURGE CURRENT (A) INSTANTANEOUS REVERSE CURRENT (uA) FIG. 3-TYPICAL REVERSE CHARACTERISTICS TJ=125oC Single Phase Half Wave 60 Hz Resistive or Inductive Load 25 50 75 100 125 150 175 AMBIENT TEMPERATURE (oC) SET TIME BASE FOR 10/20 ns/cm 100 6 5 4 3 2 1 0 40 TJ=25oC 20 10 6 4 2 1 0 1 5 10 20 50 100 NUMBER OF CYCLES AT 60 Hz FE20-005-LFR THRU FE20-08-LFR .1 .2 .4 1.0 2 4 10 20 40 100 REVERSE VOLTAGE (V) Page: 2