TPD1024AS TOSHIBA Intelligent Power Device Silicon Monolithic Power MOS Integrated Circuit TPD1024AS Low-Side Power Switch for Motors, Solenoids, and Lamp Drivers TPD1024AS is a monolithic power IC for low-side switches. The IC has a vertical MOS FET output which can be directly driven from a CMOS or TTL logic circuit(e.g, an MPU). The device offers intelligent selfprotection function. Features A monolithic power IC with a new structure combining a control block and a vertical power MOS FET(π-MOS) on a single chip. Can directly drive a power load from a CMOS logic. Built-in protection against overvoltage, load short circuiting, and thermal shutdown. Low on resistance : RDS (ON) = 0.5 Ω (max) (@VIN = 5 V, Tj = 25°C) Package : TPS Can be packed in tape. Weight: 0.54g (typ.) Pin Assignment Note: That because of its MOS structure, this product is sensitive to static electricity. 1 2002-10-24 TPD1024AS Block Diagram Pin Description Pin No. Symbol Function 1 GND Ground pin. 2 OUT Output pin. When current in excess of the typical current (3.5 A (typ.)) flows to the output pin, the current limiter operates to protect the IC. 3 IN Input pin. Input is CMOS-compatible, with pull-down resistor connected. Even if the input is open, output will not accidentally turn on. Timing Chart 2 2002-10-24 TPD1024AS Maximum Ratings (Ta = 25°C ) Characteristic Drain-source voltage Output current Input voltage Symbol Rating Unit VDS (DC) 40 V ID 1.5 A VGS − 0.5 to 6 V Power dissipation PD 1.2 W Operating temperature Topr − 40 to 85 °C Junction temperature Tj 150 °C Storage temperature Tstg − 55 to 150 °C Recommendable Condition Characteristic Input voltage Symbol Test Condition Min Typ. Max Unit VIN ― 4.5 5 6 V Min Typ. Max Unit 40 ― ― V Electrical Characteristics (Tj = 25°C) Symbol Test Circuit Drain-source breakdown voltage V (BR) DSS ― Operating supply voltage VDD (OPR) ― ― ― 18 V IDSS (1) ― VGS = 0, VDS = 40 V ― ― 3 mA IDSS (2) ― VGS = 0, VDS = 24 V ― ― 100 µA Vth ― VGS = 10 V, ID = 1 mA 0.8 ― 2.5 V Input current IGSS ― VGS = 5 V, at normal operation ― ― 300 µA On resistance RDS (ON) ― VGS = 5 V, ID = 1 A ― ― 0.5 Ω Thermal shutdown temperature TS ― ― 160 ― °C Overcurrent protection IS ― VDS = 12 V, VGS = 5 V ― 3.5 ― A 1 VDS = 12 V, VGS = 5 V, RL = 12Ω ― 50 ― µs ― 10 ― µs VDSF ― IF = 1.5 A ― 0.9 1.8 V EA ― L = 10 mH, Single pulse 30 ― ― mJ Characteristic Current at output off Input threshold voltage Switching time Diode forward voltage Between drain and source Avalanche energy tON tOFF Test Condition VGS = 0, ID = 10 mA ― ― Test Circuit 1 Switching Time 3 2002-10-24 TPD1024AS 4 2002-10-24 TPD1024AS 5 2002-10-24 TPD1024AS Package Dimensions Weight: 0.54g (typ.) 6 2002-10-24 TPD1024AS RESTRICTIONS ON PRODUCT USE 000707EBA • TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc.. • The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer’s own risk. • The products described in this document are subject to the foreign exchange and foreign trade laws. • The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. • The information contained herein is subject to change without notice. 7 2002-10-24