ADNS-6160-001 Small Form Factor Trim Lens Data Sheet Description The ADNS-6160-001 laser mouse SFF trim lens is designed for use with Avago Technologies ADNS-7530 and ADNS-7550 integrated molded lead-frame DIP LaserStream™ sensors. Together with the VCSEL, the ADNS6160-001 SFF trim lens provides the directed illumination and optical imaging necessary for proper operation of the sensor. ADNS-6160-001 SFF trim lens is a precision molded optical component and should be handled with care to avoid scratching of the optical surfaces. 4X lens seating surfaces 27.95 11.00 C 1.90 0.075 0.76 0.030 Reference surface above base (2.119 mm) 6.00 0.236 12.00 0.472 6.55 0.258 3.35 0.132 0.61 0.024 7.93 0.312 C Section C-C 0.56 0.022 B B 3.70 0.146 30º 30º 10.29 0.405 Guide post A Lens surface 1 8.20 0.323 5.95 0.234 Notes: 1. Dimensions in millimeters/inches. 2. Dimensional tolerance: ±0.10mm 3. Angular tolerance: ±3° 4. Maximum flash: ±0.20mm 5. () reference dimension Figure 1. ADNS-6160-001 SFF trim lens outline drawings and details Lens surface 2 2.40 0.094 Navigation surface Imaging lens Illumination lens Lens surface 3 Lens surface 4 Section B-B Mechanical Assembly Requirements All specifications reference Figure 2, Optical System Assembly Diagram Parameters Symbol Minimum Typical Maximum Units Conditions Distance from Object Surface to Lens Reference Plane A 2.18 2.40 2.62 mm For ADNS-6160-001 with ADNS-7550 and ADNS-7530 sensors mm Sensor Pin Reference Plane must be in contact with Lens Housing Surface Distance from Object Surface to Sensor Pin B Reference Plane 8.35 ADNS-7550 or ADNS-7530 sensor B ADNS-6160-001 A Object Surface Figure 2. Optical system assembly cross-section diagram Figure 3. Avago Technologies logo location Lens Design Optical Performance Specifications All specifications are based on the Mechanical Assembly Requirements. Parameters Symbol Design Wavelength λ Lens Material* Index of Refraction N Min. Typical Max. 842 1.5693 1.5713 Units Conditions nm 1.5735 λ = 842 nm *Lens material is polycarbonate. Cyanoacrylate based adhesives should not be used as they will cause lens material deformation. Mounting Instructions for the ADNS-6160-001 Laser Mouse SFF Trim Lens to the Base Plate An STEP or IGES format drawing file with design specifications for laser mouse base plate features is available. These features are useful in maintaining proper positioning and alignment of the ADNS-6160-001 SFF trim lens when used with the Avago Technologies ADNS-7530 and ADNS-7550 integrated molded lead-frame DIP LaserStream™ sensor. This file can be obtained by contacting your local Avago Technologies sales representative. ADNS-6160-001 SFF Trim Lens Customer Supplied Base Plate Figure 4. Illustration of base plate mounting features for ADNS-6160-001 SFF trim lens For product information and a complete list of distributors, please go to our web site: www.avagotech.com Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies, Limited in the United States and other countries. Data subject to change. Copyright © 2007 Avago Technologies Limited. All rights reserved. AV02-0687EN - January 25, 2008