Data Sheet 0917B CRYSTAL OSCILLATORS AB-X0A5XXX-X Series Sine wave or CMOS/TTL XO Rev. D Description The AB-X0A5XXX-X crystal oscillator (XO) provides Sine wave or CMOS/TTL output options.. The device does not use any frequency multiplication, providing exceptionally low Phase Noise and Jitter. It’s packaged in a miniature, FR-4 based 9x14 mm SMD package. COTS/Dual use. Creating a Part Number AB - X 0A5 X X X – X - FREQ Package code AB 6 pad 9x14 mm SMD Environmental L Contains a level of lead that is in excess of RoHs directive and is not designed for reflow R RoHS compliant Operating Voltage 0 5.0V ±5% A 3.3V ±5% B 2.5V ±5% Output Option T - CMOS/TTL S - Sine wave Temperature Range, ºC A - 0 to 50 B - 0 to 70 C - -20 to 70 D - -40 to 85 9 - Customer Specific Frequency Stability, ppm E - ±20 F - ±25 G - ±50 H - ±100 9 - Customer specific 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: [email protected] www.nelfc.com CRYSTAL OSCILLATORS Drawing Specification Data Sheet 0917B Rev D OUTLINE TOLERANCE: ±0.015” / 0.4mm (Unless otherwise specified) PIN FUNCTIONS: [1] NC [2] N/C [3] GROUND [4] OUTPUT [5] NC [6] Vcc Environmental and Mechanical Characteristics Operating temp. range Mechanical Shock Thermal Shock Vibration Hermetic Seal see part # table Soldering conditions See MAX reflow profile below; The device may be reflowed once. Reflowing upside down is not allowed. NO CLEAN assembly is recommended Per MIL-STD-202, Method 213, Cond. A Per MIL-STD-883, Method 1011, Cond. A Per MIL-STD-883, Method 2007, Cond. A Leak rate less than 1x10-8 atm.cc/s of helium, crystal only MAX Reflow Profile The device may be reflowed once. Reflowing upside down is not allowed. NO CLEAN assembly is recommended 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: [email protected] www.nelfc.com Data Sheet 0917B CRYSTAL OSCILLATORS Rev. D Absolute Maximum Ratings Parameter Symbol Operating Temperature Range Storage Temperature Range Supply Voltage To Tst Vcc Value Unit -40 to +85 -50 to +90 -0.5 to 1.1 Vcc ºC ºC V Electrical Parameters (1) Parameter Symb Nominal Frequency Supply Voltage Fo Vcc Supply current Icc Output Logic Type Load Duty Cycle(Symmetry) Rise/Fall Time Tr,Tf Output power Pout Harmonics Sub-Harmonics Jitter Integrated Ph Ps J Phase Noise * £(Δf) Frequency Stability ΔF/F Conditions, Note MIN TYP 12 5.0 3.3 2.5 MAX Unit 250 MHz 4.25 3.465 2.625 50 V Code 0 Code A Code B Frequency & Vcc dependent, Consult factory S version T version Sine - Internally AC-coupled CMOS/TTL 4.75 3.135 2.375 At 50% Vcc; CMOS/TTL only 0.2Vcc to 0.8Vcc; CMOS/TTL F<70MHz 70MHz>F<125MHz 125MHz<F<250Mhz Into 50 Ohm, Sine wave only 45/55 50/50 55/45 % 5 3 2.5 ns 5 3 2 1.5 10 mA Sine wave CMOS/TTL 50 15pf/10K ohm Ohm dBm Note: 3dBm lower for Vcc 2.5V Highest, Sine wave only none 0.1 Integrated from Phase Noise, 12 KHz to 20 MHz , RMS 10Hz to 80KHz,RMS 50 KHz to 80 MHz Deterministic @100 MHz @ 10 Hz @100 Hz @1 KHz @10KHz @100KHz @>1MHz Overall, including temperature, aging 10 years, shock and vibration 0.2 0 -90 -120 -145 -160 -165 -165 -30 dBc 0.15 ps 0.8 ps ps ps dBc/Hz -85 -115 -140 -158 -165 -165 See Chart ppm * Please consult factory for performance at other frequencies. Note: 1. All parameters, unless otherwise specified, are at nominal conditions, ie: T=25°C, Nominal Vcc & Nominal Load. 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: [email protected] www.nelfc.com