M ICROWAVE A Division of Crystek Corporation PERFORMANCE SPECIFICATION 2×Fundamental MIN TYP Lower Frequency: Upper Frequency: MAX UNITS 5800 MHz 4.5 VDC 5800 MHz Tuning Voltage: 0.5 Supply Voltage: 7.6 8.0 8.4 VDC Output Power: +3.0 +6.0 +9.0 dBm 35 mA Supply Current: Harmonic, F×(0.5): -30 -20 dBc Harmonic, F×(1.5): -35 -25 dBc Harmonic, F×(2.0): -30 -20 dBc Pushing: 1.5 3.0 MHz/V Pulling, all Phases: 0.5 1.0 MHz pk-pk -95 dBc/Hz Tuning Sensitivity: 20 Phase Noise @ 10kHz offset: -100 Load Impedance: MHz/V 50 Input Capacitance: 10 pF Operating Temperature Range: -40 +85 °C Storage Temperature Range: -45 +90 °C Phase Noise (1 Hz BW, Typical) Tuning Curve (Typical) Page 1 of 2 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation 2×Fundamental SIDE VIEW BOTTOM VIEW Gold Finish 0.465 SQ (11.81 SQ) Solder Mask 0.220 (5.59) 0.030 (0.76) 0.100 (2.54) 0.052 (1.32) 0.180 0.280 0.380 12 11 10 9 0.500 (12.70) 0.415 13 0.315 14 0.215 15 0.115 16 0.000 1 0.000 TOP ORIENTATION MARK 8 0.405 7 0.305 6 0.205 5 0.105 Pad Connection 2 10 14 Others Vt RF-OUTPUT Vcc GROUND PAD LOCATION 2 3 4 0.415 CRYSTEK CVCO55CXT 5800-5800 YYWW 0.500 (12.70) 0.500 0.215 TOP VIEW 0.080 0.040 (1.02) 0.115 [Vt] 0.315 [Vcc] Unless otherwise specified, Dimensions are in: IN (mm) Pad Location Dimensions are in: Inches 0.500 [RF] TAPE AND REEL 0.059 Ø TYP (1.50 Ø) TYP 0.157±0.004 (4.00±0.10) DIRECTION OF FEED 0.945±0.012 (24.00±0.30) 0.630±0.004 (16.00±0.10) Drawing not to scale Product Control: Crystek Part Number: CVCO55CXT-5800-5800 Release Date: 15-Nov-12 Revision Level: D Responsible: C. Vales CRYSTEK CORPORATION Specification is subject to change without notice Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com