UNISONIC TECHNOLOGIES CO., LTD DTC114Y NPN SILICON TRANSISTOR NPN DIGITAL TRANSISTOR (BUILT- IN BIAS RESISTORS) FEATURES * Built-in bias resistors that implies easy ON/OFF applications. * The bias resistors are thin-film resistors with complete isolation to allow negative input. EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number Lead Free Halogen Free DTC114YL-AE3-R DTC114YG-AE3-R DTC114YL-AL3-R DTC114YG-AL3-R DTC114YL-AN3-R DTC114YG-AN3-R DTC114YL-T92-B DTC114YG-T92-B DTC114YL-T92-K DTC114YG-T92-K DTC114YL-T92-R DTC114YG-T92-R DTC114YL-T9S-K DTC114YG-T9S-K Package SOT-23 SOT-323 SOT-523 TO-92 TO-92 TO-92 TO-92SP Pin Assignment 1 2 3 G I O G I O G I O G O I G O I G O I G O I Packing Tape Reel Tape Reel Tape Reel Tape Box Bulk Tape Reel Bulk MARKING www.unisonic.com.tw Copyright © 2011 Unisonic Technologies Co., Ltd 1 of 3 QW-R223-003,D DTC114Y NPN SILICON TRANSISTOR ABSOLUTE MAXIMUM RATINGS (TA=25°C) PARAMETER RATINGS UNIT 50 V -6 ~ +40 V 70 mA Output Current 100 mA SOT-23/SOT-323 200 SOT-523 150 Power Dissipation PD mW TO-92 625 TO-92SP 550 Junction Temperature TJ +150 °C Storage Temperature TSTG -55 ~ +150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. Supply Voltage Input Voltage SYMBOL VCC VIN IOUT IO(MAX.) ELECTRICAL SPECIFICATIONS (TA=25°C, unless others specified) PARAMETER SYMBOL TEST CONDITIONS VIN(OFF) VCC =5V, IOUT =100μA Input Voltage VIN(ON) VOUT =0.3V, IOUT =1mA Output Voltage VOUT(ON) IOUT/IIN =5mA/0.25mA Input Current IIN VIN=5V Output Current IOUT(OFF) VCC =50V, VIN =0V DC Current Gain hFE VOUT =5V, IOUT =5mA Input Resistance R1 R2 Resistor Ratio R1 Transition Frequency fT VCE =10V, IE =−5mA, f=100MHz Note: Transition frequency of the device UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN TYP MAX 0.3 0.1 0.3 0.88 0.5 UNIT V V V mA μA 68 7 10 13 KΩ 3.7 4.7 5.7 1.4 250 MHz 2 of 3 QW-R223-003,D DTC114Y NPN SILICON TRANSISTOR TYPICAL CHARACTERISTICS UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R223-003,D