THROUGH HOLE CLOCK OSCILLATORS - TTL COMPATIBLE SERIES CO1 AND CO13 FEATURES STANDARD 8 AND 14 PIN DIP PACKAGE TOLERANCE AND STABILITY TO ± 25 PPM LOW COST AVAILABLE IN 3.3 VOLT SPECIFICATIONS SERIES CO1 PACKAGE FREQUENCY RANGE 8 PIN DIP 500.00 KHz TO 125.00 MHz 500.00 KHz TO 125.00 MHz CO1100 : ±100 ppm CO13100 : ±100 ppm CO1050 : ±50 ppm CO13050 : ±50 ppm FREQUENCY STABILITY† OPERATING TEMPERATURE RANGE CO1025 : ±25 ppm CO13025 : ±25 ppm 0° C TO +70° C STANDARD -40° C TO +85° C EXTENDED 0° C TO +70° C STANDARD -40° C TO +85° C EXTENDED -55° C TO +125° C -55° C TO +125° C STORAGE TEMPERATURE RANGE VOLTAGE†† INPUT CURRENT (MAX) +5 VDC ±0.5 VDC +5 VDC ±0.5 VDC 500.00 KHz TO 2.999 MHz: 30 mA 500.00 KHz TO 2.999 MHz: 30 mA 3.00 MHz TO 31.999 MHz: 50 mA 3.00 MHz TO 31.999 MHz: 50 mA 32.00 MHz TO 79.999 MHz: 70 mA 32.00 MHz TO 79.999 MHz: 70 mA 80.00 MHz TO 125.00 MHz: 80 mA 80.00 MHz TO 125.00 MHz: 80 mA 40 TO 60% NORMAL 45 TO 55% TIGHT 40 TO 60% NORMAL 45 TO 55% TIGHT SYMMETRY (AT 1.4 VDC LEVEL) RISE AND FALL TIME (0.4 - 2.4 VDC) OUTPUT CO13 14 PIN DIP UNDER 9 MHz : ±15 ns MAX UNDER 9 MHz : ±15 ns MAX 9 MHz TO 32 MHz : ±10 ns MAX 9 MHz TO 32 MHz : ±10 ns MAX 32 MHz TO 80 MHz : ±6 ns MAX 32 MHz TO 80 MHz : ±6 ns MAX 80 MHz TO 125 MHz : ±4 ns MAX 80 MHz TO 125 MHz : ±4 ns MAX LOGIC "0" LEVEL +0.5 V MAX, SINK TO 16 mA +0.5 V MAX, SINK TO 16 mA LOGIC "1" LEVEL +2.4 V MIN, SOURCE 0.4 mA +2.4 V MIN, SOURCE 0.4 mA 1 TO 10 TTL STANDARD 1 TO 10 TTL STANDARD LOAD††† 35 † FREQUENCY STABILITY INCLUSIVE OF ROOM TOLERANCE , FREQUENCY STABILITY OVER TEMPERATURE, 10% POWER SUPPLY VARIATION, AGING, SHOCK, AND VIBRATION †† +3.3 VOLT VERSION IS AVAILABLE. CONSULT RALTRON FOR SPECIFICATIONS ††† OUTPUT LOADS ALSO AVAILABLE AT 15 pF, 30 pF AND 50 pF. CONSULT RALTRON FOR SPECIFICATIONS ENVIRONMENTAL AND TECHNICAL CONDITIONS OUTPUT WAVEFORM ENVIRONMENTAL TEMPERATURE CYCLE MIL-STD 883, METHOD 1010, 10 CYCLES -20° C TO 85° C SHOCK MIL-STD-202, METHOD 213, TEST CONDITION C VIBRATION MIL-STD-202, METHOD 204, TEST CONDITION A RESISTANCE TO SOLDERING HEAT MIL-STD-202, METHOD 210, TEST CONDITION B HUMIDITY 85% RELATIVE HUMIDITY AT 85° C 250 HOURS tf tr VCC "1" LEVEL +2.5 VDC +1.5 VDC MECHANICAL "0" LEVEL 0 VDC GROSS LEAK TEST MIL-STD-883, METHOD 1014, TEST CONDITION C FINE LEAK TEST MIL-STD-883, METHOD 1014, TEST CONDITION A TERMINAL STRENGTH MIL-STD-202, METHOD 211, TEST CONDITION A AND C MARKING INK EPOXY, HEAT CURED. MOISTURE RESISTANCE MIL-STD 202, METHOD 106, OMIT STEP 7B SOLDERABILITY MIL-STD-202, METHOD 208, 95% COVERAGE SOLVENT RESISTANCE MIL-STD-202, METHOD 2002, METHOD 215 +0.5 VDC t T PART NUMBERING SYSTEM S ERIES CO1 CO13 (14 PIN DIP) (8 PIN DIP) FREQUENCY STA B ILITY 100 050 025 ±100 PPM ± 50 PPM ± 25 PPM EXTENDED TEMPERA TURE FREQUENCY - IN MHz EXAMPLE: CO1100-20.000-EXT-T, CO13050-32.000-T-TR EXT OPTIONS SY MMETRY T TIGHT SY MMETRY TR TA PE A ND REEL* GW GULL W ING 3.3 +3.3 V * Available for Gull Wing only Raltron Electronics Corporation 10651 NW 19th St. Miami, Florida 33172 U.S.A. Tel: 305-593-6033 Fax: 305-594-3973 e-mail: [email protected] Internet: http://www.raltron.com THROUGH HOLE CLOCK OSCILLATORS-TTL COMPATIBLE SERIES CO1 AND CO13 TEST CIRCUIT - FREQUENCY STANDARD R = SEE TABLE FREQUENCY COUNTER D A + POWER SUPPLY +5 VDC .01µF OSCILLOSCOPE 14(8) VCC 8(5) OUT D V D=1N914 OSCILLATOR N/C 1 GND 7(4) D C=15 pF MAX D LOADS RESISTANCE (R) 10 390 OHM 5 750 OHM 2 1800 OHM 1 3900 OHM OUTLINE DRAWINGS CO1 PACKAGE (FULL SIZE 14 PIN DIP) COLORED DOT INDICATES PIN 1 LOCATION Scale n one Di mensi on in mm inch CO13 PACKAGE (HALF SIZE 8 PIN DIP) MARKING Scale none Di mensi on in mm inch MARKING AREA AREA 36 PIN 1 13.21 MAX 7.62 ± .13 PIN 4 .300 ± .005 7.62 ± .13 .300 ± .005 4.57 13.20 MAX .519 MAX .180 12.19 6.35 MAX .250 MAX 7.62 ± .13 .300 ± .005 PIN 7 PIN 1 PIN 14 .031 ± .003 0.79 ± .08 5.08 MAX 0.46 ± .08 DIA .018 ± .003 DIA .520 MAX 15.24 ± .13 .600 ± .005 .200 MAX 0.79 ± .08 DIA .018 ± .003 DIA 6.35 MIN .250 MIN 5.08 MAX .200 MAX 0.46 ± .08 .031 ± .003 COLORED DOT INDICATES PIN 1 LOCATION PIN 8 PIN 8 .480 13.21 MAX 20.80 MAX PIN 5 .520 MAX .819 MAX PIN CONNECTION PIN FUNCTION 1 N/C 7 8 14 PIN CONNECTION NOTE: PIN 7 IS INTERNAL TO HEADER PIN FUNCTION 1 N/C GROUND 4 GROUND OUTPUT 5 OUTPUT VCC 8 VCC NOTE: PIN 4 IS INTERNAL TO HEADER PACKAGING 14 PIN DIP: 25 PIECES PER ELECTROSTATIC TUBE 8 PIN DIP: 40 PIECES PER ELECTROSTATIC TUBE Raltron Electronics Corporation 10651 NW 19th St. Miami, Florida 33172 U.S.A. Tel: 305-593-6033 Fax: 305-594-3973 e-mail: [email protected] Internet: http://www.raltron.com