ANT-2.4-PW-QW DATA SHEET Product Dimensions Description Designed for permanent attachment, PW Series 1/2wave whips give outstanding performance in a rugged and cost-effective package. The antenna is attached by placing its base through a 1/4” hole in the product and securing it with a nut or by threading it into a PEM-style insert. This method of attachment is highly secure and saves the cost of an antenna connector. The antenna is fed through the base with RG-174 coax cable, which may be soldered directly to the board or attached using a 50ohm connector. Standard cable length is 8.5”. Custom lengths and terminations are available by special order. 0.31” (7.8) 0.53” (13.5) Features 4.13” (105.0) • • • • • • • • 0.20” (5.0) Electrical Specifications • • • • • • • 1/4-28 UNF 0.57” (14.5) Low cost Outstanding performance Omni-directional pattern Wide bandwidth Flexible main shaft Rugged & weatherized Integral 8½-inch RG-174 coax cable Use with plastic or metal enclosures Center Freq. Bandwidth Wavelength VSWR Impedance Connection Cable 2.45GHz 250MHz 1/2-wave <1.9 typ. at center 50 ohms Case-mount 8½-inch RG-174 coax Electrical specifications and plots measured on 4.00” x 4.00” reference ground plane End View 7/16” HEX Ordering Information • ANT-2.4-PW-QW VSWR Graph S11 SWR 1.373 CENTER 2450.000MHz SPAN 200.000MHz Typical VSWR Antenna Factor 159 Ort Lane Merlin, OR 97532 www.antennafactor.com 541-956-0931 (phone) 541-471-6251 (fax) Rev 4-13-09