Kingbright ACSC03-41SURKWA-F01 Surface mount display Datasheet

SURFACE MOUNT DISPLAY
Part Number: ACSC03-41SURKWA-F01
Hyper Red
Features
Description
z 0.3 inch digit height.
The Hyper Red source color devices are made with Al-
z Low current operation.
GaInP on GaAs substrate Light Emitting Diode.
z Excellent character appearance.
z Mechanically rugged.
z Gray face,white segment.
z Package : 550pcs / reel.
z Moisture sensitivity level : level 2a.
z RoHS compliant.
Package Dimensions& Internal Circuit Diagram
RED
Notes:
1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted.
2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice.
3.The gap between the reflector and PCB shall not exceed 0.25mm.
SPEC NO: DSAG0281
REV NO: V.9A
DATE: JAN/08/2015
PAGE: 1 OF 5
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: L.Q.Xie
ERP: 1351000444
Selection Guide
Part No.
Dice
ACSC03-41SURKWA-F01
Iv (ucd) [1]
@ 10mA
Lens Type
Hyper Red (AlGaInP)
Min.
Typ.
14000
27000
*3600
*6400
White Diffused
Description
Common Cathode, Rt.
Hand Decimal.
Note:
1. Luminous intensity/ luminous Flux: +/-15%.
* Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Typ.
λpeak
Peak Wavelength
Hyper Red
λD [1]
Dominant Wavelength
Δλ1/2
Max.
Units
Test Conditions
645
nm
IF=20mA
Hyper Red
630
nm
IF=20mA
Spectral Line Half-width
Hyper Red
28
nm
IF=20mA
C
Capacitance
Hyper Red
35
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
Hyper Red
1.95
2.5
V
IF=20mA
IR
Reverse Current
Hyper Red
10
uA
VR=5V
Notes:
1.Wavelength: +/-1nm.
2.Forward Voltage: +/-0.1V.
3.Wavelength value is traceable to the CIE127-2007 compliant national standards.
4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Hyper Red
Units
Power dissipation
75
mW
DC Forward Current
30
mA
Peak Forward Current [1]
185
mA
5
V
Reverse Voltage
Operating / Storage Temperature
-40°C To +85°C
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
SPEC NO: DSAG0281
REV NO: V.9A
DATE: JAN/08/2015
PAGE: 2 OF 5
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: L.Q.Xie
ERP: 1351000444
Hyper Red
ACSC03-41SURKWA-F01
SPEC NO: DSAG0281
REV NO: V.9A
DATE: JAN/08/2015
PAGE: 3 OF 5
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: L.Q.Xie
ERP: 1351000444
ACSC03-41SURKWA-F01
Recommended Soldering Pattern
(Units : mm; Tolerance: ± 0.15)
Reel Dimension
Tape Specifications
(Units : mm)
SPEC NO: DSAG0281
REV NO: V.9A
DATE: JAN/08/2015
PAGE: 4 OF 5
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: L.Q.Xie
ERP: 1351000444
PACKING & LABEL SPECIFICATIONS
ACSC03-41SURKWA-F01
Terms and conditions for the usage of this document
1.The information included in this document reflects representative usage scenarios and is intended
for technical reference only.
2.The part number, type, and specifications mentioned in this document are subject to future change
and improvement without notice. Before production usage customer should refer to the latest
datasheet for the updated specifications.
3.When using the products referenced in this document, please make sure the product is being
operated within the environmental and electrical limits specified in the datasheet. If customer usage
exceeds the specified limits, Kingbright will not be responsible for any subsequent issues.
4.The information in this document applies to typical usage in consumer electronics applications.
If customer's application has special reliability requirements or have life-threatening liabilities,
such as automotive or medical usage, please consult with Kingbright representative for further
assistance.
5.The contents and information of this document may not be reproduced or re-transmitted without
permission by Kingbright.
6.All design applications should refer to Kingbright application notes available at
http://www.KingbrightUSA.com/ApplicationNotes
SPEC NO: DSAG0281
REV NO: V.9A
DATE: JAN/08/2015
PAGE: 5 OF 5
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: L.Q.Xie
ERP: 1351000444
Similar pages