MTRONPTI CMO5TBE 5 x 7 mm, 5.0 volt, cmos/ttl, clock oscillator Datasheet

CMO5 Series
CMO5 Series
5 x 7 mm, 5.0 Volt, CMOS/TTL, Clock Oscillator
THIS PRODUCT IS NOT RECOMMENDED FOR NEW DESIGNS.
5V 5x7mm Surface Mount Crystal Clock Oscillators
PLEASE REFER TO THE M1 PRODUCT SERIES.
Œ
Œ
Œ
Œ
TTL/CMOS Compatible
Tri-State Feature for Auto Test Systems
Tape & Reel Packaging
±20ppm Available - Please Contact Factory
E L E C T R I C A L S P E C I F I C AT I O N S
MODEL
CMO5
Frequency Range (MHz)
1.5 to 156.250
Frequency Stability (ppm)
Overall (Typical)
Inclusive of calibration, temperature, voltage, load, shock,vibration, aging
0°C to 70°C
±25
-40°C to +85°C
±50
Temperature Range (°C)
Operating
-40°C to +85°C
Storage
-40°C to +125°C
Supply Voltage (V)
Input Current (mA)
+5.0 ±10%
1.5MHz to 30MHz
>30MHz to 50MHz
>50MHz to 156.250MHz
<10
<30
<50
Symmetry (%) TTL/CMOS
Transistion Times
45/55
1.5MHz to 50MHz
>50MHz to 156.250MHz
Rise Time (ns)
<5
<3
Fall Time (ns)
<5
<3
Load
10TTL/15pF
“0” Level (VOL)
“1” Level (VOH)
0.5V
2.4V/4.5V
Start up Time (ms)
<10
PA R T N U M B E R I N G G U I D E
CMO5XXXX - Specify Frequency
“C” = CMOS
“T” = TTL
“Blank” = 0oC to 70oC Operating Temp.
“M” = -40oC to 85oC Operating Temp.
“A” = ±25ppm (-40oC to 85oC Excluding Aging)
“B” = ±50ppm
“C” = ±100ppm
“D” = ±20ppm Excluding Aging (Contact Factory)
“Blank” = Fixed Frequency
“E” = Tri-State
MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application.
2553 N. Edgington
Street,offering
Franklin
Park,datasheets.
IL 60131
y Phone:
y Fax: 847.451.7585
Please see www.mtronpti.com
for our complete
and detailed
Contact
us for your 847.451.1000
application specific requirements:
MtronPTI 1-800-762-8800.
800-888-1499 or www.champtech.com
Revision: 03-01-07
CMO5 Series
5V 5x7mm Surface Mount Crystal Clock Oscillators
CMO5 Series
5 x 7 mm, 5.0 Volt, CMOS/TTL, Clock Oscillator
PIN
FUNCTION
1
CMO5 Series
N/C / Tri-State
THIS PRODUCT IS NOT RECOMMENDED FOR NEW DESIGNS.
2
Ground
PLEASE REFER TO THE M1 PRODUCT SERIES.
5V 5x7mm Surface
Mount Crystal Clock Oscillators
3
Output
+ VCC
4
PIN
OUTPUT WAVEFORM
FUNCTION
1
N/C / Tri-State
2
Ground
3
Output
4
+ VCC
TEST CIRCUIT DIAGRAM
OUTPUT WAVEFORM
TEST CIRCUIT DIAGRAM
MECHANICAL AND ENVIRONMENTAL SPECIFICATIONS
TEST METHODS
REFERENCE PROCEDURES
DESCRIPTION
Temperature Cycle
MIL-STD-833, Mtd 1010, Cond. B
-55°C to +125°C; Air-to-Air; 100 cycles; 10
min. dwell
MIL-STD-883, Mtd 2002, Cond. B
1500 g’s
Mechanical Shock
Vibration
MECHANICAL AND ENVIRONMENTAL SPECIFICATIONS
Humidity
Steady State
TEST METHODS
Thermal Shock
Temperature Cycle
Electrostatic Discharge
Mechanical Shock
Solderability
MIL-STD 883, Mtd 2007, Cond. B
20-2000 Hz; 0.06 inch; 15g’s; 3 planes
MIL-STD-202,
MtdPROCEDURES
103
REFERENCE
40°C;
90%-95% R.H.; 56 days
DESCRIPTION
MIL-STD-883, Mtd 1011.7 Cond. B
MIL-STD-833, Mtd 1010, Cond. B
MIL-STD-883, Mtd 3015 Class II
MIL-STD-883,Mtd
Mtd2022.2
2002, Cond. B
MIL-STD-883,
100°C
Water-to-Water;
15 cycles;
cycles 10
-55°Ctoto0°C;
+125°C;
Air-to-Air; 100
2 min.
KV todwell
4 KV Threshold
Hermeticity
Vibration
Resistance
to Soldering
Humidity Steady
State
Lead
Integrity
Thermal
Shock
1500 g’s
Solder
dip; Meniscograph Criteria
MIL-STD-883,
Cond. BA1
Mass
spectro.
2 x 10-8
MIL-STD 883,Mtd
Mtd1014.8,
2007, Cond.
20-2000
Hz; 0.06
inch;atmos.
15g’s; CC/sec
3 planesHe
MIL-STD-202,
Mtd
210D,
Cond.
J
235°C;
30
seconds
MIL-STD-202, Mtd 103
40°C; 90%-95% R.H.; 56 days
MIL-STD-883,
tension
& bend
stress
100°C
to 0°C;
Water-to-Water;
15 cycles
MIL-STD-883,Mtd
Mtd2004.5,
1011.7Cond.
Cond.A,
B B1 Lead
Marking
Permanence
Electrostatic
Discharge
Life
Test
Solderability
MIL-STD-883,
MIL-STD-883,Mtd
Mtd2015.8
3015 Class II
MIL-STD-883,
MIL-STD-883,Mtd
Mtd1005.6
2022.2
Resistance
to solvents
2 KV to 4 KV
Threshold
Solder
dip; Meniscograph
Criteria
125
°C, powered,
1000 hours
minimum
Hermeticity
MIL-STD-883, Mtd 1014.8, Cond. A1
Mass spectro. 2 x 10-8 atmos. CC/sec He
Resistance to Soldering
Lead Integrity
MIL-STD-202, Mtd 210D, Cond. J
235°C; 30 seconds
MIL-STD-883,
Mtd
2004.5,
Cond.
A,
B1
Lead tension & bend stress
800-888-1499 or www.champtech.com
2553 N. Edgington Street, Franklin Park, IL 60131 y Phone: 847.451.1000 y Fax: 847.451.7585
MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application.
MIL-STD-883,
Mtd 2015.8
Resistance
solvents
Permanence
PleaseMarking
see www.mtronpti.com
for our complete
offering and detailed
datasheets. Contact us for your
application to
specific
requirements: MtronPTI 1-800-762-8800.
Life Test
MIL-STD-883, Mtd 1005.6
2
125°C, powered, 1000 hours minimum
Revision: 03-01-07
2553 N. Edgington Street, Franklin Park, IL 60131 y Phone: 847.451.1000 y Fax: 847.451.7585
MtronPTI Lead Free Solder Profile
MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application.
Please see www.mtronpti.com for our complete offering and detailed datasheets. Contact us for your application specific requirements: MtronPTI 1-800-762-8800.
Similar pages