CDI-DIODE CDLL4924A Temperature compensated zener reference diode Datasheet

• TEMPERATURE COMPENSATED ZENER REFERENCE DIODES
CDLL4916
thru
• LEADLESS PACKAGE FOR SURFACE MOUNT
• 19.2 VOLT NOMINAL ZENER VOLTAGE + 5%
CDLL4932A
• LOW NOISE
• DOUBLE PLUG CONSTRUCTION
• METALLURGICALLY BONDED
MAXIMUM RATINGS
Operating Temperature: -65°C to +175°C
Storage Temperature: -65°C to +175°C
DC Power Dissipation: 500mW @ +50°C
Power Derating: 4 mW / °C above +50°C
REVERSE LEAKAGE CURRENT
lR = 15µA @ 25°C & VR = 12Vdc
ELECTRICAL CHARACTERISTICS @ 25°C, unless otherwise specified.
CDI
TYPE
NUMBER
TEST
CURRENT
l ZT
VOLTAGE
TEMPERATURE
STABILITY
∆VZT
(Note 2)
mA
mV
°C
(Note 3)
TEMPERATURE
RANGE
EFFECTIVE
TEMPERATURE
COEFFICIENT
MAXIMUM
DYNAMIC
IMPEDANCE
ZZT
(Note 1)
MAXIMUM
NOISE
DENSITY
ND
%/°C
OHMS
µ V/ Hz
CDLL4916
CDLL4916A
CDLL4917
CDLL4917A
0.5
0.5
0.5
0.5
144
298
72
149
+25 to +100
-55 to +100
+25 to +100
-55 to +100
0.01
0.01
0.005
0.005
600
600
600
600
1.0
1.0
1.0
1.0
CDLL4918
CDLL4918A
CDLL4919
CDLL4919A
0.5
0.5
1.0
1.0
29
60
144
298
+25 to +100
-55 to +100
+25 to +100
-55 to +100
0.002
0.002
0.01
0.01
600
600
300
300
1.0
1.0
0.5
0.5
CDLL4920
CDLL4920A
CDLL4921
CDLL4921A
1.0
1.0
1.0
1.0
72
149
29
60
+25 to +100
-55 to +100
+25 to +100
-55 to +100
0.005
0.005
0.002
0.002
300
300
300
300
0.5
0.5
0.5
0.5
CDLL4922
CDLL4922A
CDLL4923
CDLL4923A
2.0
2.0
2.0
2.0
144
298
72
149
+25 to +100
-55 to +100
+25 to +100
-55 to +100
0.01
0.01
0.005
0.005
150
150
150
150
0.25
0.25
0.25
0.25
CDLL4924
CDLL4924A
CDLL4925
CDLL4925A
2.0
2.0
4.0
4.0
29
60
144
298
+25 to +100
-55 to +100
+25 to +100
-55 to +100
0.002
0.002
0.01
0.01
150
150
75
75
0.25
0.25
0.22
0.22
CDLL4926
CDLL4926A
CDLL4927
CDLL4927A
4.0
4.0
4.0
4.0
72
149
29
60
+25 to +100
-55 to +100
+25 to +100
-55 to +100
0.005
0.005
0.002
0.002
75
75
75
75
0.22
0.22
0.22
0.22
CDLL4928
CDLL4928A
CDLL4929
CDLL4929A
4.0
4.0
7.5
7.5
14
30
144
298
+25 to +100
-55 to +100
+25 to +100
-55 to +100
0.001
0.001
0.01
0.01
75
75
36
36
0.22
0.22
0.20
0.20
CDLL4930
CDLL4930A
CDLL4931
CDLL4931A
7.5
7.5
7.5
7.5
72
149
29
60
+25 to +100
-55 to +100
+25 to +100
-55 to +100
0.005
0.005
0.002
0.002
36
36
36
36
0.20
0.20
0.20
0.20
CDLL4932
CDLL4932A
7.5
7.5
14
30
+25 to +100
-55 to +100
0.001
0.001
36
36
0.20
0.20
NOTE 1
Zener impedance is derived by superimposing on lZT A 60Hz rms a.c. current equal
to 10% of lZT.
NOTE 2
The maximum allowable change observed over the entire temperature range i.e.,
the diode voltage will not exceed the specified mV at any discrete temperature
between the established limits, per JEDEC standard No.5.
NOTE 3
Zener voltage range equals 19.2 volts + 5%.
DIM
D
F
G
G1
S
MILLIMETERS
INCHES
MIN MAX MIN MAX
1.60
1.70 0.063 0.067
0.41
0.55 0.016 0.022
3.30
3.70 .130 .146
2.54 REF.
.100 REF.
0.03 MIN.
.001 MIN.
FIGURE 1
DESIGN DATA
CASE: DO-213AA, Hermetically sealed
glass case. (MELF, SOD-80, LL34)
LEAD FINISH: Tin / Lead
POLARITY: Diode to be operated with
the banded (cathode) end positive.
MOUNTING POSITION: Any.
MOUNTING SURFACE SELECTION:
The Axial Coefficient of Expansion
(COE) Of this Device is Approximately
+6PPM/°C. The COE of the Mounting
Surface System Should Be Selected To
Provide A Suitable Match With This
Device.
22 COREY STREET, MELROSE, MASSACHUSETTS 02176
PHONE (781) 665-1071
FAX (781) 665-7379
WEBSITE: http://www.cdi-diodes.com
E-mail: [email protected]
CDLL4916
thru
CDLL4932A
ZENER IMPEDANCE ZZT (OHMS)
1000
500
200
100
50
20
10
2
4
6
8
10
OPERATING CURRENT lZT (mA)
12
FIGURE 2
1N4916 - 1N4918
1N4919 - 1N4921
1N4922 - 1N4924
.2
.4
.6
.8
OPERATING CURRENT lZT (mA)
0.5
1.0
1.5
2.0
OPERATING CURRENT lZT (mA)
1.0
2.0
3.0
4.0
OPERATING CURRENT lZT (mA)
+.0015
+.0010
+.0005
0
-.0005
-.0010
-.0015
1N4925 - 1N4928
CHANGE IN TEMPERATURE
COEFFICIENT ( %/°C)
CHANGE IN TEMPERATURE COEFFICIENT ( %/°C)
ZENER IMPEDANCE VS. OPERATING CURRENT
1N4929 - 1N4932
+.0015
+.0010
+.0005
0
-.0005
-.0010
-.0015
2
3
4
5
6
OPERATING CURRENT lZT (mA)
6
7
8
9
OPERATING CURRENT lZT (mA)
FIGURE 3
TYPICAL CHANGE OF TEMPERATURE COEFFICIENT
WITH CHANGE IN OPERATING CURRENT
Similar pages