Kingbright DC08-11CGKWA 20.3mm (0.8inch) dual digit numeric display Datasheet

20.3mm (0.8INCH) DUAL DIGIT NUMERIC
DISPLAY
Part Number: DC08-11CGKWA
Green
Features
Description
z 0.8 inch digit height.
The Green source color devices are made with AlGaInP on
z Excellent character appearance.
GaAs substrate Light Emitting Diode.
z Easy mounting on P.C. boards or sockets.
z Two digit package simplifies alignments & assembly.
z Mechanically rugged.
z Standard : gray face, white segment.
z RoHS compliant.
Package Dimensions& Internal Circuit Diagram
Notes:
1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted.
2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice.
SPEC NO: DSAM8353
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 1 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000795
Selection Guide
Part No.
Dice
DC08-11CGKWA
Iv (ucd) [1]
@ 10mA
Lens Type
Green (AlGaInP)
Min.
Typ.
14000
38000
*5600
*12000
White Diffused
Description
Common Cathode,Rt.
Hand Decimal.
Notes:
1. Luminous intensity/ luminous Flux: +/-15%.
*Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Typ.
λpeak
Peak Wavelength
Green
λD [1]
Dominant Wavelength
Δλ1/2
Max.
Units
Test Conditions
574
nm
IF=20mA
Green
570
nm
IF=20mA
Spectral Line Half-width
Green
20
nm
IF=20mA
C
Capacitance
Green
15
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
Green
2.1
2.5
V
IF=20mA
IR
Reverse Current
Green
10
uA
VR=5V
Notes:
1. Wavelength: +/-1nm.
2. Forward Voltage: +/-0.1V.
3. Wavelength value is traceable to the CIE127-2007 compliant national standards.
4. Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Green
Units
Power dissipation
75
mW
DC Forward Current
30
mA
Peak Forward Current [1]
150
mA
5
V
Reverse Voltage
Operating / Storage Temperature
Lead Solder Temperature[2]
-40°C To +85°C
260°C For 3-5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
SPEC NO: DSAM8353
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 2 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000795
Green
DC08-11CGKWA
SPEC NO: DSAM8353
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 3 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000795
PACKING & LABEL SPECIFICATIONS
DC08-11CGKWA
Terms and conditions for the usage of this document
1. The information included in this document reflects representative usage scenarios and is intended for technical reference only.
2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without
notice. Before production usage customer should refer to the latest datasheet for the updated specifications.
3. When using the products referenced in this document, please make sure the product is being operated within the environmental
and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible
for any subsequent issues.
4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has
special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with
Kingbright representative for further assistance.
5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright.
6. All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes
SPEC NO: DSAM8353
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 4 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000795
SPEC NO: DSAM8353
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 5 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000795
SPEC NO: DSAM8353
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 6 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000795
Similar pages