8 Pin 5 Tap High Speed CMOS (HCT) Compatible Active Delay Lines Delays are ±5% or ±2 nS† Tap Total 12* 12* 12* 12* 12* 12* 12* 15 17 18 19 20 21 22 24 30 22 24 26 28 30 32 36 45 †Whichever is greater. * Inherent Delay 27 30 33 36 39 42 48 60 32 36 40 44 48 52 60 75 DIP Part Number EPA1130-32 EPA1130-36 EPA1130-40 EPA1130-44 EPA1130-48 EPA1130-52 EPA1130-60 EPA1130-75 SMD Part Number Delays are ±5% or ±2 nS† Tap Total EPA1130G-32 EPA1130G-36 EPA1130G-40 EPA1130G-44 EPA1130G-48 EPA1130G-52 EPA1130G-60 EPA1130G-75 20 25 30 35 40 50 60 70 100 VOL IL I CC TRO NH VCC 80 100 120 140 160 200 240 280 400 100 125 150 175 200 250 300 350 500 EPA1130-100 EPA1130-125 EPA1130-150 EPA1130-175 EPA1130-200 EPA1130-250 EPA1130-300 EPA1130-350 EPA1130-500 EPA1130G-100 EPA1130G-125 EPA1130G-150 EPA1130G-175 EPA1130G-200 EPA1130G-250 EPA1130G-300 EPA1130G-350 EPA1130-500 Schematic Min Max Unit High Level Input Voltage VCC = 4.5 to 5.5 Low Level Input Voltage VCC = 4.5 to 5.5 High Level Output Voltage VCC = 4.5V,IO=-4.0mA @V IH or VIL Low Level Output Voltage VCC = 4.5V,IO= 4.0mA @V IH or VIL Input Leakage Current VCC = 5.5V @VIH or VIL Supply Current VCC = 5.5V, VIN=0 Output Rise Time (.75 - 2.4 Volts) High Fanout VCC = 5.5V, VOH = 4.0V Input Pulse Test Conditions @ 25°C EIN PW TRI PRR 60 75 90 105 120 150 180 210 300 SMD Part Number Delay times referenced from input to leading edges at 25°C, 5.0V. DC Electrical Characteristics Test Conditions Parameter VIH VIL VOH 40 50 60 70 80 100 120 140 200 DIP Part Number Unit Pulse Input Voltage Pulse Width % of Total Delay Input Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ PW ≤ 500nS Pulse Repetition Rate @ PW > 500nS Supply Voltage 3.2 150 2.0 1.0 100 5.0 Volts % nS MHz KHz Volts 2.0 0.8 Volt Volt Volt 0.3 Volt 4.0 10 8 ±1.0 uA 15 mA 4 nS LSTTL Load 7 VCC 2 3 5 OUTPUT INPUT 1 4 GROUND Recommended Operating Conditions VCC VI VO IO PW* D* TA 6 Min DC Supply Voltage DC Input Voltage Range DC Output Voltage Range DC Output Source/Sink Current Pulse Width % of Total Delay Duty Cycle Operating Free Air Temperature 4.5 0 0 Max Unit 5.5 VCC VCC 25 Volt Volt Volt mA % % °C 40 0 40 70 *These two values are inter-dependent. DIP Package SMD Package .03 .400 Max. PCA EPA1130G-32 D.C. .280 Max. .055 Pad Layout .410 .500 Max. .020 Typ. .250 Max. .01 Typ. .050 .365 Max. .300 3/27/01 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 .010 Typ. .120 Min, .020 Typ. .02 .280 Max. .100 .500 Max. DSA1130/G Rev. B PCA EPA1130-32 D.C. .100 .100 .250 Max. White Dot Pin#1 QAF-CSO1a Rev. B 8/25/94 ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791 29