CM400YE2N-12F / CM400YE2P-12F TLI-Series Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com M N P P W X N (Three Level Inverter) IGBT 400 Amperes/600 Volts C1 Y K G1 H L G E1 C2 C1 B E Q AK U E1 F E2 R G1 E1 V S C2 E1 AK Z G2 E2 RTC G2 E2 CM400YE2N-12F J T E2 AB D A CM300YE2N-12F AA C C1 AE AF AC AD G1 RTC E1 C2 E1 AK CM400YE2P-12F G2 E2 E2 CM300YE2P-12F Outline Drawing and Circuit Diagram Dim. Inches Dim. Inches Millimeters A 4.33 110.0 R 0.20 5.1 B 3.15 80.0 S 0.14 Min. 3.6 Min. C 0.87 22.0 T 0.22 Dia. 5.6 Dia. Millimeters D 3.74±0.01 95.0±0.25 U M6 Metric M6 E 2.60±0.01 66.0±0.25 V M4 Metric M4 F 2.01 51.0 W 1.38+0.04/-0.02 35.0+1.0/-0.5 G 1.50 38.0 X 1.18+0.04/-0.02 30.0+1.0/-0.5 Y 0.43 11.0 H 0.72 18.3 J 0.20 5.0 Z 0.06 1.5 AA 0.16 4.0 K 0.28 7.0 L 0.12 3.0 AB 0.09 0.67 17.0 2.35 M 0.31 8.0 AC N 0.83 21.0 AD 0.55 14.0 P 1.02 26.0 AE 0.45 11.4 Q 0.54 13.7 AF 0.35 9.0 Ordering Information: Example: Select the complete module number you desire from the table - i.e. CM400YE2N-12F and CM400YE2P-12F are 600V (VCES), 400 Ampere TLI-Series IGBT Power Modules. Type Current Rating Amperes VCES Volts (x 50) CM 400 12 08/10 Rev. 1 Description: The TLI-Series has been designed for three level (neutral point clamped) topologies in applications requiring high efficiency operation and improved output waveform quality. They also provide significant benefits in applications where low output noise using small filter components is required or where long motor leads create Standing Wave Ratio (SWR) voltage surge issues. Features: £ Smaller Output Voltage Steps Reducing Surge Voltage £ Low Output Ripple Current £ Lower Modulation Frequency With Same Quality Output Waveform Applications: £ Three Level Inverter Topologies £ Solar Power Inverters £ High Efficiency UPS £ Long Motor Lead Applications 1 Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com CM400YE2N-12F / CM400YE2P-12F TLI-Series (Three Level Inverter) IGBT 400 Amperes/600 Volts Absolute Maximum Ratings, Tj = 25°C unless otherwise specified Ratings Symbol CM400YE2N-12F / CM400YE2P-12F Units Junction Temperature Tj -40 to 150 °C Storage Temperature Tstg -40 to 125 °C Mounting Torque, Main Terminals (C1, AK, E2), M8 Screw (Max.) – 40 in-lb Mounting Torque, Mounting Holes, M5 Screw (Max.) – 30 in-lb Mounting Torque, C2, E1 Terminals, M4 Screw (Max.) – 15 in-lb – 530 Grams Viso 2500 Vrms Weight (Typical) Isolation Voltage (Main Terminal to Baseplate, AC 1 min.) Inverter Part Collector-Emitter Voltage (G-E Short) VCES 600 Volts Gate-Emitter Voltage (C-E Short) VGES ±20 Volts Collector Current DC (TC = 25°C) IC 400 Amperes Peak Collector Current (Pulse)*2 ICM 800 Amperes Emitter Current (TC = 25°C) IE*1 400 Amperes Peak Emitter Current (Pulse)*2 IEM*1 800 Amperes Maximum Collector Dissipation (TC' = 25°C) PC*3 1250 Watts VRRM 600 Volts IFM 400 Amperes Clamp Diode Part Repetitive Peak Reverae Voltage Forward Current (TC = 25°C) *1 *2 *3 2 IE, IEM, VEC, trr, and Qrr represent characteristics of the anti-parallel, emitter-to-collector free-wheel diode (FWDi). Pulse width and repetition rate should be such that device junction temperature (Tj) does not exceed Tj(max) rating. Junction temperature (Tj) should not increase beyond 150°C. 08/10 Rev. 1 Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com CM400YE2N-12F / CM400YE2P-12F TLI-Series (Three Level Inverter) IGBT 400 Amperes/600 Volts Electrical Characteristics, Tj = 25°C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units VCE = VCES, VGE = 0V – – 1 mA VGE(th) IC = 40mA, VCE = 10V 5 6 7 Volts IGES VGE = VGES, VCE = 0V – – 40 μA Inverter Part Collector-Cutoff Current ICES Gate-Emitter Threshold Voltage Gate Leakage Current Collector-Emitter Saturation Voltage VCE(sat) IC = 400A, VGE = 15V, Tj = 25°C – 1.6 2.2 Volts IC = 400A, VGE = 15V, Tj = 125°C – 1.6 – Volts – – 110 nF VCE = 10V, VGE = 0V – – 7.2 nF – – 4 nF – 2480 – nC Input Capacitance Cies Output Capacitance Coes Reverse Transfer Capacitance Cres Total Gate Charge QG VCC = 300V, IC = 400A, VGE = 15V Turn-on Delay Time td(on) VCC = 300V, IC = 400A, – – 700 ns Turn-on Rise Time tr VGE1 = VGE2 = 15V, – – 400 ns Turn-off Delay Time td(off) RG = 4.7Ω, – – 1100 ns tf Inductive Load Switching Operation, – – 300 ns IE = 400A – – 200 ns – 2.6 – μC – – 2.8 Volts 4.7 – 16 Ω VR = VRRM – – 1 mA Turn-off Fall Time *1 Reverse Recovery Time trr Reverse Recovery Charge Qrr*1 Emitter-Collector Voltage VEC*1 External Gate Resistance RG IE = 400A, VGE = 0V Clamp Diode Part Repetitive Reverse Current IRRM Forward Voltage Drop VFM IF = 400A – – 2.8 Volts Reverse Recovery Time trr IF = 400A, VCC = 300V, – – 200 ns Reverse Recovery Charge Qrr VGE1 = VGE2 = 15V, RG = 4.7Ω, – 2.6 – μC Min. Typ. Max. Inductive Load Switching Operation Thermal and Mechanical Characteristics, Tj = 25°C unless otherwise specified Characteristics Symbol Test Conditions Units Case*4 Rth(j-c')Q Inverter IGBT – – 0.11 °C/W Thermal Resistance, Junction to Case*4 Rth(j-c')D Inverter FWDi – – 0.14 °C/W Case*4 Rth(c-f)D Clamp Diode Part – – 0.14 °C/W Rth(c-f) Thermal Grease Applied (per 1 Module) – 0.037 – °C/W Thermal Resistance, Junction to Thermal Resistance, Junction to Contact Thermal Resistance*5 *4 TC measured point is just under the chips. If using this value, Rth(f-a) should be measured just under the chips. *5 Typical value is measured by using thermally conductive grease of λ = 0.9 [W/(m • K)]. 08/10 Rev. 1 3 Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com CM400YE2N-12F / CM400YE2P-12F TLI-Series (Three Level Inverter) IGBT 400 Amperes/600 Volts COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (INVERTER PART - TYPICAL) OUTPUT CHARACTERISTICS (INVERTER PART - TYPICAL) 3.0 9.5 11 600 9 400 8.5 200 8 7.5 0 1 3 1.0 0.5 0 4 0 200 400 600 3 IC = 800A 2 IC = 160A 1 0 800 IC = 400A 6 8 10 12 14 16 18 20 22 GATE-EMITTER VOLTAGE, VGE, (VOLTS) FREE-WHEEL DIODE FORWARD CHARACTERISTICS (INVERTER PART - TYPICAL) CLAMP DIODE FORWARD CHARACTERISTICS (INVERTER PART - TYPICAL) CAPACITANCE VS. VCE (INVERTER PART - TYPICAL) 103 102 101 1.0 1.5 2.0 2.5 3.0 3.5 102 101 100 0.5 4.0 103 Tj = 25°C CAPACITANCE, Cies, Coes, Cres, (nF) FORWARD CURRENT, IF, (AMPERES) Tj = 25°C 1.0 1.5 2.0 2.5 3.0 3.5 VGE = 0V Cies 102 101 Coes 100 10-1 4.0 Cres 100 101 102 EMITTER-COLLECTOR VOLTAGE, VEC, (VOLTS) FORWARD VOLTAGE, VF, (VOLTS) COLLECTOR-EMITTER VOLTAGE, VCE, (VOLTS) HALF-BRIDGE SWITCHING CHARACTERISTICS (INVERTER PART - TYPICAL) GATE CHARGE VS. VGE (INVERTER PART) SWITCHING LOSS VS. COLLECTOR CURRENT (INVERTER PART - TYPICAL) 103 20 td(off) td(on) SWITCHING TIME, (ns) 1.5 4 COLLECTOR-CURRENT, IC, (AMPERES) 100 0.5 tf 102 101 101 tr VCC = 300V VGE = ±15V RG = 6.2Ω Tj = 125°C Inductive Load 102 COLLECTOR CURRENT, IC, (AMPERES) 4 2.0 Tj = 25°C COLLECTOR-EMITTER VOLTAGE, VCE, (VOLTS) 103 EMITTER CURRENT, IE, (AMPERES) 2 2.5 103 IC = 400A 16 VCC = 200V VCC = 300V 12 8 4 0 0 1000 2000 3000 GATE CHARGE, QG, (nC) 4000 SWITCHING LOSS, ESW(on), ESW(off), (mJ/PULSE) 0 Tj = 25°C GATE-EMITTER VOLTAGE, VGE, (VOLTS) COLLECTOR CURRENT, IC, (AMPERES) 15 5 VGE = 15V Tj = 25°C Tj = 125°C COLLECTOR-EMITTER SATURATION VOLTAGE, VCE(sat), (VOLTS) 10 VGE = 20V COLLECTOR-EMITTER SATURATION VOLTAGE, VCE(sat), (VOLTS) 800 COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (INVERTER PART - TYPICAL) 102 101 VCC = 300V VGE = ±15V RG = 6.2Ω Tj = 125°C Inductive Load ESW(on) ESW(off) 100 101 102 103 COLLECTOR CURRENT, IC, (AMPERES) 08/10 Rev. 1 Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com REVERSE RECOVERY SWITCHING LOSS VS. FORWARD CURRENT (CLAMP DIODE PART - TYPICAL) REVERSE RECOVERY SWITCHING LOSS, Err, (mJ/PULSE) 101 VCC = 300V VGE = ±15V RG = 6.2Ω Tj = 125°C Inductive Load 10-2 102 FORWARD CURRENT, IF, (AMPERES) 08/10 Rev. 1 100 10-1 100 10-1 101 NORMALIZED TRANSIENT THERMAL IMPEDANCE, Zth(j-c') Zth = Rth • (NORMALIZED VALUE) CM400YE2N-12F / CM400YE2P-12F TLI-Series (Three Level Inverter) IGBT 400 Amperes/600 Volts 103 10-3 10-3 TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (TYPICAL) 10-2 10-1 100 101 10-1 Single Pulse TC = 25°C Per Unit Base = Rth(j-c') = 0.1°C/W (IGBT) Rth(j-c') = 0.14°C/W (FWDi) 10-2 Rth(j-c) = 0.14°C/W (Clamp Diode) 10-5 10-4 10-3 10-3 TIME, (s) 5