Click on Series name for product info on aimtec.com Series AME20-JZ 20 Watt | AC-DC / DC-DC Converter FEATURES: I/O Isolation 3000VAC Operating Temp: -40°C to +70°C Over current Protection Input: 85-305VAC, 47-63Hz, or 100-430VDC Low Ripple and Noise Over Voltage Protection Up to 85% efficiency Short Circuit Protection Models Single output Input Voltage (VAC/Hz) Input Voltage (VDC) Max Output wattage (W) Output Voltage (V) Output Current max (A) Maximum capacitive load (µF) 85-305/47-63 85-305/47-63 85-305/47-63 85-305/47-63 85-305/47-63 85-305/47-63 100-430 100-430 100-430 100-430 100-430 100-430 11.5 17.5 18.9 19.2 19.5 20 3.3 5 9 12 15 24 3.5 3.5 2.1 1.6 1.3 0.85 48000 12240 5600 5400 2400 1840 Model AME20-3.3SJZ AME20-5SJZ AME20-9SJZ AME20-12SJZ AME20-15SJZ AME20-24SJZ Efficiency (%) 230 VAC 75 78 79 83 84 85 Input Specifications Parameters Current (full load) Inrush current <2ms (cold start) Leakage current External fuse Conditions Typical 115 VAC 230 VAC 115 VAC 230 VAC Recommended slow blow type 15 30 3.15 Conditions Typical (LL-HL) 10-100% load ±2 ±0.5 ±1 115 VAC 230 VAC 15 80 Maximum Units 600 340 mA mA A A mA A 0.25 Output Specifications Parameters Voltage accuracy Line regulation Load regulation Ripple & Noise Hold-up time Maximum ±10 % % % mV p-p ms ms % of Vout Rated Units 3000 2000 VAC 100 Voltage adjustment range Units Isolation Specifications Parameters Tested I/O voltage Conditions Typical Input to Output, 60 sec Input to Ground Isolation resistance >1000 MΩ General Specifications Parameters Switching frequency Over current protection Over voltage protection Short circuit protection Operating temperature Maximum case temperature Storage temperature Temperature coefficient www.aimtec.com F 052e R8.A Conditions Typical Maximum 65 ≥110 Zener Diode Clamp Auto recovery -40 to +70 See derating curve KHz % of Iout 100 -40 to +105 ±0.02 Tel: +1 514 620 2722 1 of 5 Units °C °C °C % / °C Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AME20-JZ 20 Watt | AC-DC / DC-DC Converter General Specifications (continued) Parameters Conditions Typical Maximum Units Cooling Free air convection Humidity Non condensing 95 % RH Case material Plastic (flammability to UL 94V-0) Weight 120 g Dimensions (L x W x H) 70.0 x 48.0 x 23.5 mm (2.76 x 1.89 x 0.93 inches) MTBF > 300 000 hrs (MIL-HDBK -217F, t=+25oC)/ Full Load NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage (115/230VAC) and at rated output load unless otherwise specified. Safety Specifications Parameters Agency approvals CE, UL Information Technology Equipment EMI - Conducted and radiated emission Electrostatic Discharge Immunity RF, Electromagnetic Field Immunity Electrical Fast Transient/Burst Immunity Surge Immunity RF, Conducted Disturbance Immunity Power frequency Magnetic Field Immunity Voltage dips, Short Interruptions Immunity Standards IEC/EN/UL 60950-1 EN55022, class B EN55024: 2010 IEC 61000-4-2: Contact ±6KV/Air ±8KV, Criteria B IEC 61000-4-3: 10V/m, Criteria A IEC 61000-4-4: ±2KV, Criteria B IEC 61000-4-5: ±1KV/±2KV, Criteria B IEC 61000-4-6: 10Vrms, Criteria A IEC 61000-4-8: 10A/m, Criteria A IEC 61000-4-11: 0-70%, Criteria B Typical Application circuit Single Output FUSE 3.15A/300V + Vout AC L AC L MOV S14K350 AC AC N + Vout + DC C2 C1 1µF/50V AC N ‐ Vout Earth/GND ‐ Vout Vout C2 TVS 3.3 & 5V 9V 12 & 15V 24V 330 µF/50V 7A 12A 20A 30A 220 µF/50V TVS Pin Out Specifications Pin Single 1 2 3 4 5 6 Earth/Ground AC Input (L) AC Input (N) Trim - V output + V output www.aimtec.com F 052e R8.A Tel: +1 514 620 2722 2 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AME20-JZ 20 Watt | AC-DC / DC-DC Converter Dimensions 12.50 (0.49) 4.00 (0.16) 70.00 (2.76) 2 Bottom View 6 1 4 62.00 (2.44) 4.00 (0.16) 2 Top View 5 6 5.75 (0.23) 5 4 1 23.00 (0.91) 48.00 (1.89) 20.00 (0.79) 3 3 4.00 (0.16) DIV: 10.00 (0.40) 23.50 (0.93) Ø 1.50 (Ø 0.06) Dimensions mm (inch) Case Tolerance ±0.50 (±0.02) Pin Diameter 1.0 ± 0.10 (0.04 ± 0.004) 6.00 (0.24) 1.00 (0.04) Derating Free Air Convection Free Air Convection at 25°C 80 60 100 Output Power (%) Output Power (%) 100 Safe Operating Area 100% load 100-277VAC Or 120-390VDC 40 80 75 0 40 - 20 -10 0 20 40 55 60 70 80 0 85 100 (100) (120) 100 www.aimtec.com 277 (390) 305 (430) Input Voltage VAC (VDC) Ambient Temperature º C F 052e R8.A Safe Operating Area 20 20 - 40 60 Tel: +1 514 620 2722 3 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AME20-JZ 20 Watt | AC-DC / DC-DC Converter Trimming Output voltage can be externally trimmed by utilizing the methods as shown below Fixed Resistor Variable Potentiometer Leave open if not used. AME20‐3.3SJZ Trim down % 1 Vout (VDC) 3.27 181.7 Rt down (KΩ) Trim up % 1 3.33 Vout (VDC) 174.371 Rt up (KΩ) AME20‐5SJZ Trim down % Vout (VDC) Rt down (KΩ) Trim up % Vout (VDC) Rt up (KΩ) AME20‐9SJZ Trim down % Vout (VDC) Rt down (KΩ) Trim up % Vout (VDC) Rt up (KΩ) www.aimtec.com F 052e R8.A 2 3.23 84.657 3 3.2 59.638 4 3.17 45.602 5 3.14 36.62 6 3.1 28.7 7 3.07 24.517 8 3.04 21.275 9 3 17.939 10 2.97 15.957 2 3.37 63.611 3 3.4 42.843 4 3.43 32.178 5 3.47 24.053 6 3.5 20.166 7 3.53 17.322 8 3.56 15.153 9 3.6 12.95 10 3.63 11.656 1 4.95 160.7 2 4.9 78.2 3 4.85 50.7 4 4.8 36.95 5 4.75 28.7 6 4.7 23.2 7 4.65 19.271 8 4.6 16.325 9 4.55 14.033 10 4.5 12.2 1 5.05 164 2 5.1 81.5 3 5.15 54 4 5.2 40.25 5 5.25 32 6 5.3 26.5 7 5.35 22.571 8 5.4 19.625 9 5.45 17.333 10 5.5 15.5 2 3 4 8.82 8.73 8.64 221.43 153.157 116.145 5 8.55 92.925 6 8.46 76.997 7 8.37 65.393 8 8.28 56.562 9 8.19 49.617 10 8.1 44.011 1 8.91 389.533 1 9.09 2 9.18 3 9.27 4 9.36 5 9.45 6 9.54 7 9.63 8 9.72 9 9.81 10 9.9 328.532 126.639 78.148 56.357 43.975 35.99 30.412 26.297 23.134 20.629 Tel: +1 514 620 2722 4 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AME20-JZ 20 Watt | AC-DC / DC-DC Converter AME20‐12SJZ Trim down % Vout (VDC) 1 11.88 183.233 1 12.12 2 11.76 111.59 2 12.24 3 11.64 79.474 3 12.36 4 11.52 61.246 4 12.48 5 11.4 49.499 5 12.6 6 11.28 41.299 6 12.72 7 11.16 35.249 7 12.84 8 11.04 30.602 8 12.96 9 10.92 26.921 9 13.08 10 10.8 23.933 10 13.2 Rt up (KΩ) 211.778 57.03 32.596 22.642 17.238 13.845 11.516 9.819 8.527 7.511 2 3 14.7 14.55 304 199.833 2 3 15.3 15.45 4 14.4 147.75 4 15.6 5 14.25 116.5 5 15.75 6 14.1 95.667 6 15.9 7 13.95 80.786 7 16.05 8 13.8 69.625 8 16.2 9 13.65 60.944 9 16.35 10 13.5 54 10 16.5 30.25 24 19.833 16.857 14.625 12.889 11.5 Vout (VDC) 1 2 3 4 5 6 23.76 23.52 23.28 23.04 22.8 22.56 471.081 287.942 205.845 159.249 129.221 108.258 1 2 3 4 5 6 24.24 24.48 24.72 24.96 25.2 25.44 7 22.32 92.793 7 25.68 8 22.08 80.914 8 25.92 9 21.84 71.504 9 26.16 10 21.6 63.865 10 26.4 Rt up (KΩ) 239.556 13.15 11.232 9.771 8.622 Vout (VDC) Rt down (KΩ) Trim up % AME20‐15SJZ Trim down % Vout (VDC) Rt down (KΩ) Trim up % Vout (VDC) Rt up (KΩ) AME20‐24SJZ Trim down % Vout (VDC) Rt down (KΩ) Trim up % 1 14.85 616.5 1 15.15 124 61.5 64.606 40.667 36.982 25.728 19.619 15.783 NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com. www.aimtec.com F 052e R8.A Tel: +1 514 620 2722 5 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only