0-10V Dimmable Constant Current Mode 25-DBFE Series www.linkcom.com.tw For more information, please contact with: [email protected] FEATURES: ● AC Input 108~305 Vac Nominal ● 1-10V Dimming ● AC Inrush current: 10 A @ 230 Vac Cold start ● Power Factor: > 0.95 @ 120 Vac / > 0.9 @ 277 Vac ● Protection: SCP / OVP / OCP ● High Operating Ambient Temp.: -30 ℃ ~ +60 ℃ ● Surge Protection: L-N 2 kV ● Safety: Meets UL ● EMI: Meets FCC / Meets CE ● Comply with Indoor/Outdoor Waterproof (IP 67) ● Warranty: 5 years (refer to LinkCom warranty policy) ● RoHS Compliant PRODUCT SPECIFICATION DC OUTPUT POWER(W) DC OUTPUT VOLTAGE(V) OUTPUT CURRENT(A) OUTPUT CURRENT TOLERANCE EFFICIENCY O/P NOISE(P-P,V) DBFE-025U701-00 26.6 30-38 0.7 ±5% 84% 3 DBFE-020U701-00 19.6 20-28 0.7 ±5% 84% 3 MODEL ELECTRICAL SPECIFICATION INPUT VOLTAGE RANGE 108-305 Vac, 152-431 Vdc, Normal: 120-277 Vac INPUT FREQUENCY Range: 47-63 Hz, Normal: 50-60 Hz ACTIVE POWER FACTOR > 0.95 @ 120 Vac / > 0.9 @ 277 Vac THD < 20% @ 277 Vac at Full Load TURN ON DELAY TIME 1s at Full Load 120 Vac / 277 Vac AC CURRENT 0.35 A / 120 Vac 0.15 A / 277 Vac INRUSH CURRENT (max) Cold Start 10 A @ 230 Vac LEAKAGE CURRENT < 0.7 mA / 240 Vac SHORT CIRCUIT PROTECTION SCP will restart automatically after the fault condition is removed OVER VOLTAGE PROTECTION Shut down and latch off o/p voltage, re-power on to recover OVER CURRENT PROTECTION Constant Current OPERATING TEMP. -30℃~+60℃ STORAGE TEMP. RELATIVE HUMIDITY -40℃~+80℃ 10% to +90%, non-cond. SAFETY Meets UL 60950-1 EMI Meets FCC Part 15 / Meets EN 55015 WITHSTAND VOLTAGE I/P-O/P: 3 kVac ISOLATION RESISTANCE I/P-O/P :10M Ω / 500 Vdc / 25℃ / 70% RH DIMENSION (L*W*H) 134 * 42 * 33.1 mm【5.28 *1.65 * 1.3 inch】 (1) All parameters specified at 230 Vac input unless otherwise noted. (2) All specifications Typical at 25℃, unless otherwise noted, at normal line and load. (3) Ripple and Noise measured directly at pins/terminals at nom. load, 0.1uF bypass and 47uF electrolytic, pk-pk at 20MHz bandwidth. (4) Specified for free-air convection cooling. (5) Minimum load is NOT required for proper operation . (6) 100% Production Tested. ＊REFERENCE: www.linkcom.com.tw ＊Please contact [email protected], [email protected] for more information Linkcom Manufacturing Co., Ltd. 5F., No. 127, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231-45, Taiwan ▪ T: +886-2-8919-1380 ▪ F: +886-2-8919-1370 ▪ www.linkcom.com.tw 0-10V Dimmable Constant Current Mode 25-DBFE Series www.linkcom.com.tw For more information, please contact with: [email protected] DIMENSIONS Tc Max. LCCE-025U701 as Tc Max. Reference ＊REFERENCE: www.linkcom.com.tw Linkcom Manufacturing Co., Ltd. 5F., No. 127, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231-45, Taiwan ▪ T: +886-2-8919-1380 ▪ F: +886-2-8919-1370 ▪ www.linkcom.com.tw 0-10V Dimmable Constant Current Mode 25-DBFE Series www.linkcom.com.tw For more information, please contact with: [email protected] DIMMING OPERATION Parameters Minimum Absolute maximum voltageon on the 0-10(+) Purple Wire Source current on the 0-10V(+) Purple Wire Purple(+) PDBFE0025■XXX-00G Gray(-) Typical Maximum 1V 10V 0mA 100mA (Leviton) IP710 Dimmer V (Lutron) NTSTV-DV Dimmer Red(+) Black(-) Dimming Performance 110% 100% Output Current (%) 90% 80% 70% 60% 50% 40% 30% 20% Vin=120 10% Vin=277 0% 0 1 2 3 4 5 6 7 8 9 10 Vdc Notes: 1. Purple and Gray wires on the output side are used for 0-10V dimming. 2. When connected to different Dimmers, 0-10V dimmable version will have a ±10% output current tolerance. 3. Recommended dimmers are Leviton IP710,Lutron NTSTV-DV or equivalent. 4. When dimming wires +Purple/-Gray are left open, the output current will be at 100%. 5. If 0-10V Dimmer is below 1V, the LED Driver output will be shut down and enter to Hiccup mode. Linkcom Manufacturing Co., Ltd. 5F., No. 127, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231-45, Taiwan ▪ T: +886-2-8919-1380 ▪ F: +886-2-8919-1370 ▪ www.linkcom.com.tw 0-10V Dimmable Constant Current Mode 25-DBFE Series www.linkcom.com.tw For more information, please contact with: [email protected] Power Factor vs. Load (DBFE-025U701-00) PF vs. Load Power Factor 1.00 0.95 0.90 Vin=100 Vin=120 0.85 Vin=200 Vin=230 Vin=277 0.80 80% 85% 90% 95% 100% 105% Load (%) Efficiency vs. Load (DBFE-025U701-00) Efficiency vs. Load Efficiency (%) 90% 85% 80% Vin=100 Vin=120 75% Vin=200 Vin=230 Vin=277 70% 80% 85% 90% 95% 100% 105% Load (%) T.H.D vs. Load (DBFE-025U701-00) THD vs. Load 30% 25% THD (%) 20% 15% Vin=100 10% Vin=120 Vin=200 Vin=230 5% Vin=277 0% 80% 85% 90% 95% 100% 105% Load (%) Linkcom Manufacturing Co., Ltd. 5F., No. 127, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231-45, Taiwan ▪ T: +886-2-8919-1380 ▪ F: +886-2-8919-1370 ▪ www.linkcom.com.tw 0-10V Dimmable Constant Current Mode 25-DBFE Series www.linkcom.com.tw For more information, please contact with: [email protected] Output Current VS Load (DBFE-025U701-00) Output Current vs. Load Output Current (A) 0.720 0.710 0.700 Vin=100 Vin=120 0.690 Vin=200 Vin=230 Vin=277 0.680 80% 85% 90% 95% 100% 105% Load (%) Linkcom Manufacturing Co., Ltd. 5F., No. 127, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231-45, Taiwan ▪ T: +886-2-8919-1380 ▪ F: +886-2-8919-1370 ▪ www.linkcom.com.tw