ATS fanSINK™ with maxiGRIP™ Attachment ATS PART # ATS-61425R-C1-R0 Features & Benefits « X-Cut straight fin heat sink fins offer omnidirectional air flow for optimum thermal performance independent of PCB lay-out « Stainless steel screw fan attachment ensures dependable long-term fan to heat sink assembly. 4-40 thread screws are supplied in 4 lengths (1/2", 3/4", 7/8", 1"). Contact ATS for custom options available. « Product hole pattern is 32 mm C-C (center to center) « Component Attachment: ATS maxiGRIP™ is a proven high reliability mechanical attachment system « Meets Telecordia GR-63-Core Office Vibration; ETSI 300 019 Transportation Vibration; and MIL-STD-810 Shock Testing and Unpackaged Drop Testing Standards « maxiGRIP™ hardware includes a high performance plastic frame clip and 300 Series stainless steel spring clip- avoiding PCB through holes E « Provided with pre-assembled Thermal Interface Material (TIM) centered on base « “Keep-Out” Requirements: An “Un-Populated” boarder zone of 5 mm around the component is necessary to facilitate the installation/ removal of the maxiGRIP™. Please refer to the maxiGRIP™ Keep-Out Guidelines and Installation/Removal Instructions for further details F FAN NOT INCLUDED Fan type is specific to individual customer requirements and needs to be independently sourced. *Images above is for illustration purposes only. Suggested Fan Details DIMENSIONS PART # DISTRIBUTOR VOLTAGE THERMAL RESISTANCE 40 x 40 x 10 mm KD0504PFS1 DIGI-KEY 5V 0.57 °C/W 40 x 40 x 10 mm KD1204PFS1 DIGI-KEY 12V 0.57 °C/W Heat Sink Details DIM A DIM B DIM C DIM D 42.5 mm 42.5 mm 19.5 mm 27 x 27 mm DIM E DIM F INTERFACE MATERIAL FINISH ATTACHMENT FAN 32 mm 32 mm Chomerics T412 Blk Anodized maxiGRIP™ Customer Supplied NOTES: 1) 2) 3) 4) 5) 6) 7) 8) 9) Fan not included. Fan type is specific to individual customer requirements and needs to be independently sourced. Dimension A and B refers to component size. Dimension C refers to the heat sink height from bottom of the base to the top of the fin field. Dimension D refers to the size of thermal interface material (TIM) applied to heat sink. Dimension E and F refers to hole spacing dimensions. Thermal data reference only. Actual performance may vary by application. ATS reserves the right to update or change its products without notice. Optional maxiGRIP™ Installation/Removal Tool Set P/N: MGT425 Contact ATS to learn about custom options available. For more information, to find a distributor or to place an order, visit www.qats.com or call 781.769.2800 REV4_0516