date 09/2010 page 1 of 4 a division of CUI INC SERIES: DESCRIPTION: 6 W WALL PLUG SWITCHING POWER SUPPLY FEATURES •Level V (efficient design) •100 ~ 130 V ac input voltage •regulated output voltage •short circuit, over load protection •meets EISA / efficiency level IV regulations •custom designs available RoHS MODEL output voltage output wattage ripple* nominal (V dc) output current min (A) max (A) max (W) max. (mVp-p) efficiency level cord length EPS030100 3 0 1 3 100 IV 1800 ±100 EPS033100 3.3 0 1 3.3 100 IV 1800 ±100 EPS036100 3.6 0 1 3.6 100 IV 1800 ±100 EPS045100 4.5 0 1 4.5 100 V 1800 ±100 EPS050100 5 0 1 5 100 V 1800 ±100 EPS060100 6 0 1 6 100 V 1800 ±100 EPS075080 7.5 0 0.8 6 100 V 1800 ±100 EPS090066 9 0 0.66 6 100 V 1800 ±100 EPS100060 10 0 0.6 6 100 V 1800 ±100 EPS120050 12 0 0.5 6 120 V 1800 ±100 EPS135044 13.5 0 0.44 6 135 V 1800 ±100 EPS150040 15 0 0.4 6 150 V 1800 ±100 EPS180033 18 0 0.33 6 180 V 1800 ±100 EPS240025 24 0 0.25 6 240 IV 1800 ±100 (mm) *at full load, 100 ~ 130 V ac input, measured at 20MHz bandwidth with a 10 uF electrolytic cap and a 0.1 uF ceramic cap on the output PART NUMBER KEY EPS030100 - PXXXX - SZ - CXX Base Number Reserved for custom orders example of 3 V dc, 1 A DC Plug type: see output plug options on page 4 20050 SW 112th Ave. Tualatin, Oregon 97062 Factory Designation phone 503.612.2300 fax 503.612.2382 www.v-infinity.com date 09/2010 page 2 of 4 a division of CUI INC SERIES: 6 W WALL PLUG DESCRIPTION: SWITCHING POWER SUPPLY INPUT parameter conditions/description rated input voltage min nom max units 100 120 130 V ac rated frequency 50 60 Hz frequency range 47 63 Hz inrush current 120 V ac, inrush lasts no longer than 0.5 ms before settling to steady state current 40 A no load power consumption Input: 100 ~ 120 V ac 0.5 W max units OUTPUT parameter conditions/description min line regulation load regulation nom ±2 full load to no load, > 5 V full load to no load, < 5 V % ±5 -5% over/undershoot at turn-on and turn-off temp. coefficient 0 ~ 40°C, full load, after initial 1 hour warm-up start-up time time needed to reach regulation % +0.25 V 0 % ±0.02 %/°C 3 10 s hold-up time at 115 V ac, full load output power limit primary power limited ms overload protection Fold-back current limiting starts at 105 ~ 160% of the rated output current. Auto-recovery. Long term exposure to overload condition may reduce product reliability. short circuit protection Continuous, auto-recovery upon removal of short SAFETY & EMI parameter conditions/description min HI-POT input to output at 10 mA for 1 second insulation resistance input to output at 500 V dc safety approvals UL/cUL 1310 EMI standard FCC part 15 class B leakage current at 120 V ac RoHS compliant yes class 2 power supply yes nom max units 3000 V ac 100 M 0.5 mA max units 40 °C ENVIRONMENTAL parameter conditions/description min operating temperature nom 0 operating humidity 10 90 % storage temperature -20 85 °C storage humidity 10 90 % max units RELIABILITY parameter conditions/description MTBF at 25°C, per MIL-HDBK-217E 20050 SW 112th Ave. Tualatin, Oregon 97062 min nom 240,000 phone 503.612.2300 fax 503.612.2382 www.v-infinity.com hours date 09/2010 page 3 of 4 a division of CUI INC SERIES: DESCRIPTION: 6 W WALL PLUG SWITCHING POWER SUPPLY MECHANICAL DRAWING 17.0 43.3 1.0 26.6 1.0 12.7 63 1.0 22.3X18.0 1800 100 Units: mm 6.3 Tolerance: X.X ±0.5mm X.XX ±0.03mm NOTE 1: THIS POWER UNIT IS INTENDED TO BE CORRECTLY ORIENTED IN A VERTICAL OR FLOOR MOUNT POSITION. 3.0 (TYP) 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 www.v-infinity.com date 09/2010 page 4 of 4 a division of CUI INC SERIES: DESCRIPTION: 6 W WALL PLUG SWITCHING POWER SUPPLY OUTPUT PLUG OPTIONS ˄ˇʳ̈́˃ˁˈ ˆˁˈʳʾ˃˂ˀ˃ˁ˄ ˆˁˈʳʾ˃˂ˀ˃ˁ˄ 3.5 mm Phono Plug ˄ˇʳ̈́˃ˁˈ *Tip positive P1 P1R Standard DC Plug ˖ Standard PX P5/P5R P6/P6R P7/P7R P8/P8R P9/P9R ˕ ˔ ˕ ˔ ˖ Right Angle PXR A 5.5 5.5 3.5 3.8 3.8 B 2.1 2.5 1.3 1.35 1.05 C 9.5 9.5 9.5 9.5 9.5 Unit mm mm mm mm mm Locking DC Plug ˖ ˔ ˕ P10 P11 A 5.5 5.5 B 2.1 2.5 C 9.5 9.5 Unit mm mm EIAJ Plugs EIAJ A B P12/P12R EIAJ-1 2.35 0.7 P13/P13R EIAJ-2 4.0 1.7 P14/P14R EIAJ-3 4.75 1.7 ˕ ˔ ˕ ˔ ˖ C 9.5 9.5 9.5 D NA 5.0 5.0 Unit mm mm mm ˖ Standard PXX Right Angle PXXR ˗ Stripped and Tinned ˅ˈ̈́ˈ DC PLUG TYPE ST PXX X X stripped and tinned Plug type Plug angle: “blank” = standard R = right angle *Contact CUI for additional output plug options. 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 Plug polarity: “blank” = N/A P = center positive N = center negative fax 503.612.2382 www.v-infinity.com